SilverStone ST50F-ES Manual de Usario

SilverStone Fuente de alimentación de la computadora ST50F-ES

Lee a continuación 📖 el manual en español para SilverStone ST50F-ES (7 páginas) en la categoría Fuente de alimentación de la computadora. Esta guía fue útil para 6 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF
Página 1/7
High efficiency with 80Plus certification
24hour continuous power output with 40 C operating temperature
Class-leading single +12V rail
Multiple protection circuitry
Silent running 120mm fan with 18dBA
PCI-E 8pin and PCI-E 6pin connector support
ATX 12V 2.3 support
Active PFC circuitry
Power for everything you need
November, 2009
NO.G1121
ST50F-ES / ST40F-ES
Strider Essential Series
o
SPECIFICATION
SilverStone Essential Plus
ST50F-ES
ST40F-ES
ATX12V 2.3 Switching Power Supply
With Active PFC
PS/2
01
This specification defines the performance characteristics of a single phase 500
and 400 watts, 5 output power supply. This specification also defines worldwide
safety and electromagnetic compatibility requirements for the power supply which
is intended for use in computer products.
Nominal Voltage
115-230 Vrms
2.1. Input Voltage
2.1.1 ST50F-ES
2.1.1 ST40F-ES
1.GENERSAL
2.INPUT CHARACTERISTICS
1.1. Scope
Voltage Variation Range
103.5 - 253 Vrms
Nominal Voltage
115-230 Vrms
Voltage Variation Range
103.5 - 253 Vrms
02
2.2 Input Frequency
2.3 Max. Input AC Current
2.4 Inrush Current
2.2.1 ST50F-ES
2.2.2 ST40F-ES
Strider Essential Series
Nominal Frequency
50-60 Hz
Frequency Variation Range
47 Hz to 63 Hz
Nominal Frequency
50-60 Hz
* The power supply must operate at above frequency with 103.5 - 253VACrms
input voltage range.
The power supply must meet inrush requirements for any rated AC voltage,
during turn on at any phase of AC voltage, during a single cycle AC dropout
condition, during repetitive ON/OFF cycling of AC, and over the specified
temperature range. The peak inrush current shall be less than the ratings of its
critical components (including input fuse, bulk rectifiers, and surge limiting device).
Frequency Variation Range
47 Hz to 63 Hz
2.3.1 ST50F-ES
Max. Input Current
6.5A
Measuring Range
103.5 - 253 Vrms
2.3.2 ST40F-ES
Max. Input Current
5.5A
Measuring Range
103.5 - 253 Vrms
03
ST50F-ES, ST40F-ES provides an efficiency of >80% when measured at full load
under 115V/60Hz and 230V/50Hz condition.
Maximum continuous total DC output power should not exceed 500W.
Maximum continuous combined load on +3.3VDC and +5VDC outputs shall not
exceed 120W.
Maximum combined load on +12V outputs shall not exceed 400W.
When the 12V output is maximum rating, 5V must reach 3A, the output voltage
can be within the specification.
When the 5V output is maximum rating, 12V output rating must reach 11A, the
output voltage can be within the specification.
Output
Voltage
1. +5V 0.2A
2. +3.3V 0.1A
4. +12V
5. -12V
6. +5Vs
0.6A
0.0A
0.0A
20.0A
24.0A
34.0A
0.3A
2.5A
--
--
--
--
--
±5%
±5%
±5%
±10%
±5%
100mV
100mV
150mV
150mV
100mV
Load
MIN Peak Regulation
Range
MAX Ripple
P-P Max
2.5 Efficiency
3.1 Normal Operation Output
3.1.1 ST50F-ES
3. OUTPUT CHARACTERISTICS
04
STRIDER ST1000STRIDER ST1000-NV
Strider Essential Series
Maximum continuous total DC output power should not exceed 400W.
Maximum continuous combined load on +3.3VDC and +5VDC outputs shall not
exceed 120W.
Maximum combined load on +12V outputs shall not exceed 300W.
When the 12V output is maximum rating, 5V must reach 3A, the output voltage
can be within the specification.
When the 5V output is maximum rating, 12V output rating must reach 9A, the
output voltage can be within the specification.
NOTE:
Noise test should be measured with 20 MHz bandwidth frequency oscilloscope.
The output terminal shall add a tantalum capacitor of 10uF in parallel with a
ceramic capacitor of 0.1uF.
The PSON# signal is required to remotely turn on/off the power supply, PSON# is
an active low signal that turns on the output power rails. When this is not pulled low
by the system, or left open, the outputs (except the +5VSB) turn off. This signal is
pulled to a standby voltage by a pull-up resistor internal to the power supply.
TTL level "H" 2.0 V - 5.25 V
"L" 0.0 V – 1.0 V
Output
Voltage
1. +5V 0.2A
2. +3.3V 0.1A
4. +12V
5. -12V
6. +5Vs
0.6A
0.0A
0.0A
20.0A
24.0A
25A
0.3A
2.5A
--
--
--
--
--
±5%
±5%
±5%
±10%
±5%
100mV
100mV
150mV
150mV
100mV
Load
MIN Peak Regulation
Range
MAX Ripple
P-P Max
3.1.2 ST40F-ES
3.2 Remote On/Off Controlled mode

Especificaciones del producto

Marca: SilverStone
Categoría: Fuente de alimentación de la computadora
Modelo: ST50F-ES

¿Necesitas ayuda?

Si necesitas ayuda con SilverStone ST50F-ES haz una pregunta a continuación y otros usuarios te responderán


Fuente de alimentación de la computadora SilverStone Manuales

SilverStone

SilverStone ST50GF Manual de Usario

11 Septiembre 2024
SilverStone

SilverStone ST50F-ES Manual de Usario

11 Septiembre 2024
SilverStone

SilverStone ST42GF Manual de Usario

11 Septiembre 2024

Fuente de alimentación de la computadora Manuales

Últimos Fuente de alimentación de la computadora Manuales

Corsair

Corsair HX1000W Manual de Usario

2 Octubre 2024
Be Quiet!

Be Quiet! Straight Power E9 600W Manual de Usario

29 Septiembre 2024
Cooler Master

Cooler Master V550 Gold-v2 Manual de Usario

27 Septiembre 2024
Zalman

Zalman ZM850-ARX Manual de Usario

19 Septiembre 2024
Zalman

Zalman ZM1000-ARX Manual de Usario

19 Septiembre 2024
Zalman

Zalman Decamax ZM500-LX3 Manual de Usario

18 Septiembre 2024
Zalman

Zalman ZM750-EBT Manual de Usario

18 Septiembre 2024
Zalman

Zalman GigaMax ZM650-GVII Manual de Usario

18 Septiembre 2024
Zalman

Zalman MegaMax ZM700-TXII Manual de Usario

18 Septiembre 2024
Zalman

Zalman MegaMax ZM500-TXII Manual de Usario

18 Septiembre 2024