Smeg L30FABERE Manual de Usario
Smeg
hogar abierto
L30FABERE
Lee a continuación 📖 el manual en español para Smeg L30FABERE (7 páginas) en la categoría hogar abierto. Esta guía fue útil para 17 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/7
©2013 Smeg (UK) Ltd.
INSTALLATION & USER INSTRUCTIONS
All instructions must be handed to the user for
safekeeping.
MODELS COVERED BY THESE INSTRUCTIONS
L30 FABEBL
L30 FABECR
L30 FABERE
L30 FABESI
WALL MOUNTED ELECTRIC FIRE
Please note: Except where otherwise stated, all rights,
including copyright in the text, images and layout of this
booklet is owned by Smeg (UK) Ltd. You are not permitted
to copy or adapt any of the content without the prior
written permission of Smeg (UK) Ltd.
1
Revision A - 10/13
L30 FABE
GB IE
SMEG UK LTD
3a Park Square
Milton Park
Abingdon
OX14 4RN
IMPORTANT - THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE
REFERENCE.
When using this electrical appliance, basic precautions should be followed to reduce the risk of fire, electric shock and injury to person,
including the following:
• This heater must be used on an AC supply only and the voltage marked on the heater’s rating label must correspond to the supply
voltage.
• Do not switch the appliance on until it is properly installed as described in this manual.
• The heater must not be located immediately above a socket outlet.
• Keep furniture, curtains and other fabric material away from the appliance.
• Do not leave the appliance unattended during use.
• From time to time, check the cord for damage. Never use the appliance if the cord or any part of the appliance shows signs of damage.
A damaged cord must only be replaced by a qualified person.
• Do not operate this appliance with a damaged plug or cord, after a malfunction or after being dropped or damaged in any way.
• Repairs to electrical appliances should only be performed by a qualified electrician. Improper repairs may place the user at serious risk.
• Do not run the mains cable under carpets, rugs etc.
• Do not cover or obstruct the heater in any way. Overheating will result if it is accidentally covered.
• Never immerse the product in water or any other liquids.
• Do not use this heater where it may come into contact with water e.g. in bathrooms, shower rooms etc.
• Do not use the appliance outdoors.
• Before cleaning the appliance, ensure it is unplugged from the power and that it is completely cool.
• Do not clean the appliance with abrasive chemicals.
• Never use accessories that are not recommended or supplied by the manufacturer. It could cause danger to the user or damage to the
appliance.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Do not lift the appliance by the decorative fascia.
• CAUTION! In order to avoid a hazard due to inadvertent resetting of the thermal cut out, this appliance must not be supplied through
an external switching device such as a timer or connected to a circuit that is regularly switched on and off by the utility.
• Do not insert or allow foreign objects to enter the inlet or outlet vents as this may result in electric shock, fire or damage to the
appliance.
• Do not install the fire using an extension cord.
• Unplug from the mains supply if the appliance is not to be used for long periods.
The appliance is supplied with a pre-wired three pin plug (13 Amp fuse rated) and 1.8 metres of electrical cable. It is therefore
necessary for a suitable electrical socket to be located within this distance and be easily accessible. This appliance is designed to
be wall hung, using the wall fixtures/fixings provided. DO NOT recess any part of appliance into the wall. This appliance is
suitable for installation in static holiday/park homes.
Supply Voltage: 220~240V AC, 50Hz 13 AmpFuse Rating:
Heating Elements: Lighting:1800W LED
This fire is fitted with LED’s (Light Emitting Diode) in place of conventional bulbs. LED’s generate the same light levels as
conventional bulbs, but use a fraction of the energy consumed. LED’s are maintenance free and will not require replacing during
the life of the product.
©2013 Smeg (UK) Ltd.
I N S TA L L AT I O N & U S E R I N S T R U C T I O N S
2
GB IE
3.0 APPLIANCE DATA
Section Contents Page No.
1.0 Important Notes 2
2.0 Installation Requirements 2
3.0 Appliance Data 2
4.0 Unpacking The Appliance 3
5.0 Component Checklist 3
6.0 Site Requirements 3
7.0 Clearances To Combustibles 3
Section Contents Page No.
8.0 Installing The Appliance 4
9.0 Fitting The Decorative Frame 5
10.0 Operating The Appliance 5
11.0 Cleaning And Maintenance 6
12.0 Troubleshooting Guide 7
13.0 Guarantee-Terms And Conditions 7
1.0 IMPORTANT NOTES
2.0 INSTALLATION REQUIREMENTS
Read the instructions before continuing to unpack or install this appliance. Carefully remove the appliance from its packagingall
and lay on the floor with it’s back surface downward. Note: DO NOT stand the appliance on its frame as this may cause distortion.
Check that the remaining packaging contents correlate with the component checklist below. Please dispose of all packaging at
your local recycling centre.
QUANTITY DESCRIPTION
1 Wall heater
1 Decorative fascia
1 Instruction booklet
1 Remote control
1 Pack of fixing screws and wall plugs (5 x 40mm pozi pan head screws / 5 x wall plugs)
1 Wall mounting bracket
This appliance is designed to be wall mounted using the mounting bracket and fixings provided. The wall should be relatively flat
and not interfere with any of the ventilation slots in the rear panel.
The wall must be structurally sound and of a material capable of withstanding moderate heat. Finished plaster, conventional
wallpaper, dry-lined plaster board are examples of suitable materials. Materials such as flock, blown vinyl, embossed paper and
cloth wall coverings which are sensitive to even small amounts of heat should be avoided, as some discolouration may occur.
It should be noted that the appliance creates warm convected air currents. These currents move heat from the room surroundings
to, and up the wall surfaces adjacent to the heater.
Installing the heater next to these types of wall coverings or operating the heater where impurities in the air, (such as tobacco
smoke) exist, may slightly discolour wall finishing.
If the appliance is to be mounted on a dry lined or timber framed construction then the integrity and ability of the wall to carry
the weight of the appliance must be confirmed. It is important in these circumstances that any vapour barrier and/or structural
members of the house frame are not damaged.
If you are unsure of the ability of the wall to carry the weight and/or which type of wall fixing to use, you should take professional
advice and obtain the correct fixings. Alternatively, find a more suitable wall location.
DO NOT
• mount on a ceiling or floor.
• recess any part of the appliance into the wall, or run the supply cable under carpets.
• site any electrical equipment e.g. plasma screen TV sets etc, on the wall below the appliance.
• site in a position where curtains or drapes could cover the appliance, or other soft materials could cover e.g. below a coat
rack.
• site behind an opening door where mechanical impact/damage could occur.
• site where the supply cable would become a trip hazard.
• sit, stand or forcefully pull on the appliance.
• obstruct, cover or force items into the openings.
• use the heater to dry clothes.
• site/use in an outdoor location(s).
It is important that the following clearances are maintained from the appliance to combustible materials. These clearances are
dependent on the mounting location as defined below:
• The minimum distance from the top of the appliance to a ceiling is 300mm
• The minimum distance from the bottom of the appliance to the floor is 300mm
• The minimum distance to the sides of the appliance is 100mm
• The minimum distance to the front of the appliance is 500mm
4.0 UNPACKING THE APPLIANCE
5.0 COMPONENT CHECKLIST
GB IE
6.0 SITE REQUIREMENTS
7.0 CLEARANCES TO COMBUSTIBLE MATERIALS
©2013 Smeg (UK) Ltd.
3
Especificaciones del producto
| Marca: | Smeg |
| Categoría: | hogar abierto |
| Modelo: | L30FABERE |
¿Necesitas ayuda?
Si necesitas ayuda con Smeg L30FABERE haz una pregunta a continuación y otros usuarios te responderán
hogar abierto Smeg Manuales
29 Septiembre 2024
1 Agosto 2024
30 Julio 2024
18 Julio 2024
hogar abierto Manuales
- hogar abierto Ambiano
- hogar abierto Eurom
- hogar abierto Klarstein
- hogar abierto Scarlett
- hogar abierto EWT
- hogar abierto Dimplex
- hogar abierto Well Straler
- hogar abierto Cotech
- hogar abierto Qlima
- hogar abierto Dovre
- hogar abierto Napoleon
- hogar abierto Faber
- hogar abierto Blumfeldt
- hogar abierto Bimar
- hogar abierto Edilkamin
- hogar abierto La Nordica
- hogar abierto Jotul
- hogar abierto Hwam
- hogar abierto Euromac
- hogar abierto Deville
- hogar abierto Spartherm
- hogar abierto Olsberg
- hogar abierto Eligent
- hogar abierto Blue Rhino
- hogar abierto Amantii
- hogar abierto Planika
Últimos hogar abierto Manuales
25 Octubre 2024
21 Octubre 2024
18 Octubre 2024
6 Octubre 2024
5 Octubre 2024
5 Octubre 2024
5 Octubre 2024
5 Octubre 2024
3 Octubre 2024
3 Octubre 2024