Snow Joe H092 Manual de Usario

Snow Joe No categorizado H092

Lee a continuación 📖 el manual en español para Snow Joe H092 (6 páginas) en la categoría No categorizado. Esta guía fue útil para 9 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/6

OPERATOR’S MANUAL

SAVE THESE INSTRUCTIONS

IMPORTANT!

Safety Instructions

All Operators Must Read These

Instructions Before Use

Any electrical appliance can be dangerous if used incorrectly.

Some of the safety precautions given in this manual apply

generally to many appliances. Other warnings are specic to

the use of this tree stand.

You and any other operator of this rotating tree stand must

read, understand and follow these instructions in their entirety,

and should re-read them at the start of each holiday season.

Failure to follow any of these instructions may result in

ELECTRIC SHOCK, FIRE and/or serious PERSONAL INJURY.

General Safety WARNINGS!

Notice the personal safety alert symbol used in this m

manual to draw your attention to a WARNING given along

with the particular operating instruction. This means that

an operation requires special ATTENTION, CAUTION and

AWARENESS.

1. indoor seasonal This tree stand is for use for articial

trees only. Do not install on a permanent basis or use for

commercial purposes.

2. Do not use this product for other than its intended use.

3. Keep tree stand away from all heat sources including gas

and electric heaters, replaces, and candles.

4. Use the electric cord safely.

A. Electric plugs must match the outlet. Never modify

the plug in any way. Unmodied plugs and matching

outlets will reduce the risk of electric shock.

B. Do not use with an extension cord unless the plug can

be fully inserted.

C. Do not abuse the cord. Keep cord away from heat

sources, oil and sharp edges.

D. Do not place the cord in high trafc areas of your

home, or close doors or windows on the cord.

E. Never carry the tree stand by its cord or yank the cord

to disconnect it from electrical outlet.

F. Replace or properly repair damaged cords. If cord is

damaged in any manner while plugged in, pull cord

from wall receptacle.

G. Do not secure the cord with staples or nails, or place

on sharp hooks or nails, since this may damage the

cord and increase the risk of electric shock.

H. Turn off the power switch and disconnect the cord

before decorating your tree or when leaving the tree

stand unattended.

I. Contact with water while operating the tree stand can

result in electric shock and serious personal injury. Do

not handle the plug or the appliance with wet hands or

while standing in water.

5. WARNING Keep out of reach of small children. This m

product is not a toy. To avoid risk of electric shock, re,

and serious bodily injury, do not play with tree stand or

allow access to small children or unauthorized users.

6. Moving parts present risks. Keep your face, hair, clothing,

hands and feet away from the rotating spindle. Shut off

and disconnect cord before touching any moving parts.

7. Make sure the tree can rotate freely without any

obstructions, such as walls curtains, lamp cords, or

furniture. If the tree’s rotation is obstructed, you will hear a

clicking sound every fteen seconds, which will stop once

the obstructing object is removed.

8. Keep tree skirts, tinsel, garland, and other holiday

decorations away from rotating spindle.

9. This product has a polarized plug (one blade is wider than

the other) as a feature to reduce the risk of electric shock.

This plug will t in a polarized outlet only one way. If the

plug does not t fully in the outlet, reverse the plug. If it

still does not t, contact a qualied electrician. Do not use

with an extension cord unless plug can be fully inserted.

Do not alter or replace the plug. It is acceptable to omit

this item if the product does not employ a polarized plug.

10. Do not cover the product with cloth, paper or any material

not part of the product when in use.

11. Unplug the product when leaving the house, or when

retiring for the night, or if left unattended.

A Division of Snow Joe, LLC

Form No. H092-880E

Model No. H092

Rotating Articial Tree Stand

Assembly

Getting Started

1. Remove the tree stand from the box and familiarize

yourself with the unit (Fig. 1).

2. Inspect the stand carefully for shipping damage. If

damage is seen or suspected (such as damaged wire

insulation, cracks in the enclosures, loose connections or

exposed copper wire), do not assemble. Instead, contact

Snow Joe Customer Service for assistance.

Tree Installation

1. Locate the tree base collar in the parts bag and slide the

collar onto the tree pole (Fig. 2). Do not attempt to insert

the tree pole into the collar while the collar is screwed into

the tree stand.

Note: This tree stand will accommodate standard size

tree poles up to 1.25 in. (3.18 cm) in diameter. If the collar

will not slip onto the tree pole, this indicates that your tree

pole is not a standard size.

2. Insert the tree pole into the stand.

Note: For poles with pointed ends (crimps), carefully turn

the pole into the spindle until the crimp hooks onto the rib

inside the spindle (Fig. 3).

m m CAUTION

Inspect wiring, which, if damaged during shipping, may

cause serious bodily injury during equipment use. If any

damage is seen or suspected, do not assemble. Instead,

contact Snow Joe Customer Service (1-866-766-9563)

for assistance.

Handle with care during assembly so that electrical

wiring does not become damaged.

F E

Figure 1

A. Spindle Screw

B. Rotaing Power Base

C. Tree Base Collar

D. Tree Stand Base

E. Switch Box

F. Reset Switch

G. Light Switch

H. Rotation Switch

I. Power Cord

Figure 2

A. Articial Tree Pole

B. Spindle Screws (x3)

C. Receptacle

D. Tree Base Collar

E. Rotating Power Base

F. Tree Stand Base

Figure 3

A. Articial Tree Pole

C. Collar Screws (x3)

B. Tree Stand Base

3. Slide the collar down the pole and secure it to the tree

stand by fastening the three (3) collar screws (Fig. 4).

IMPORTANT: Do not over-tighten the screws, since this

can damage the tree stand.

4. Tighten all three (3) spindle screws to secure the tree in a

stable, upright position (Fig. 5).

5. Make sure the tree ts securely inside the collar before

turning on the tree stand. Once the tree is installed inside

the stand, do not rock it back and forth since this can

damage the stand. If the tree does not t properly even

after tightening the collar screws, please contact Snow

Joe Customer Service at 1-866-766-9563.

Operation

1. The electric cord has a polarized plug (Fig. 6), with one

prong slightly longer and wider than the other. This plug

can be inserted only one way into a polarized outlet. If the

plug does not t properly in the outlet, unplug it from the

outlet and insert it in the reverse direction. If it still does

not t, seek the assistance of a qualied electrician.

Note: If using an extension cord with this unit, make sure

that the original plug ts snugly into the extension cord

slots, which are likewise polarized.

Figure 4

A. Articial Tree Pole

B. Collar Screws (x3)

C. Tree Base Collar

D. Rotating Power Base

E. Tree Stand Base

B B

Figure 5

A. Articial Tree Pole

B. Spindle Screws (x3)

C. Rotating Power Base

D. Receptacle

m WARNING m

Electric shock can cause SEVERE INJURY or

DEATH. Heed these warnings:

• Do not allow any part of tree stand to make contact

with water while powered on. If the stand becomes

wet while turned off, wipe dry before starting.

• Do not touch the tree stand or its plug with wet

hands or while standing in water.

• Do not use with an extension cord unless the plug

can be fully inserted.

Figure 6

A. Electrical Cord

Especificaciones del producto

Marca:	Snow Joe
Categoría:	No categorizado
Modelo:	H092
Color del producto:	Grey, Red
Ancho:	117 mm
Profundidad:	215 mm
Altura:	336 mm
Nivel de ruido:	70 dB
Fuente-de-alimentación:	Batterij/Accu
Capacidad de polvo:	0.35 l
Potencia máxima de entrada:	150 W
Tiempo de carga:	5 uur
Ladrón removible:	Ja
Duración:	30 min
Batería/Voltaje de la batería:	22.2 V
Tecnología de batería:	Lithium