Soundmaster RCD 5000 Manual de Usario

Soundmaster Reproductores/grabadores de CD RCD 5000

Lee a continuación 📖 el manual en español para Soundmaster RCD 5000 (4 páginas) en la categoría Reproductores/grabadores de CD. Esta guía fue útil para 12 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/4

This symbol indicates the presence of dangerous

voltage inside the enclosure, sufficient enough to

cause electric shock.

This symbol indicates the presence of important

operating and maintenance instructions for the

device.

Safety, Environmental and Setup Instructions

• Use the device in dry indoor environments only.

• Protect the device from humidity.

• Do not open the device. RISK OF ELECTRIC SHOCK! Refer opening and servicing to qualified personnel.

• Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with the

specifications on the rating plate.

• Make sure the mains cable stays dry during operation. Do not pinch or damage the mains cable in any way.

• Disconnect device warning: Main plug is used as the connection, so it should always remain ready operate.

• The mains plug is used as the disconnect device, the disconnect device shall remain readily operable.

• A damaged mains cable or plug must immediately be replaced by an authorized service center.

• In case of lightning, immediately disconnect the device from the mains supply.

• Children should be supervised by parents when using the device.

• Clean the device with a dry cloth only.

Do NOT use CLEANING AGENTS or ABRASIVE CLOTHS!

• Do not expose the device to direct sunlight or other heat sources.

• Install the device at a location with sufficient ventilation in order to prevent heat accumulation.

• Do not cover the ventilation openings!

• The ventilation should not be impeded by covering the ventilation openings with items, such as newspaper, table-cloths, curtains, etc.

• It shall be not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the

apparatus.

• The unit should not be exposed to direct sunlight, very high or low temperature, moisture, vibrations or placed in dusty environment.

• Never attempt to insert wires, pins or other such objects into the vents or opening of the unit.

• Install the device at a safe and vibration-free location.

• No naked flame sources, such as lighted candles, should be placed on the apparatus.

• Install the device as far away as possible from computers and microwave units; otherwise radio reception may be disturbed.

• Do not open or repair the enclosure. It is not safe to do so and will void your warranty. Repairs only by authorized service/ customer

center.

• The device is equipped with a “Class 1 Laser”. Avoid exposure to the laser beam as this could cause eye injuries.

• Only use mercury and cadmium-free batteries.

• Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.

• Used batteries are hazardous waste and NOT to be disposed of with the household waste!!! Return the batteries to your dealer or to

collection points in your community.

• Keep batteries away from children. Children might swallow batteries. Contact a physician immediately if a battery was swallowed.

• Check your batteries regularly to avoid battery leakage.

CAUTION

INVISIBLE LASER RADIATION

WHEN OPENING

THE COVER

PRESSING THE SAFETY INTERLOCK. AVOID EXPOSURE TO THE LASER BEAM.

ENVIRONMENTAL PROTEC

TION

Do not dispose of this product with the normal household waste at the end

of its life cycle. Return it to a collection point for the recycling of electrical

and electronic devices. This is indicated by the symbol on the product,

user manual or packaging.

The materials are reusable according to their markings. By reusing, recycling or

other forms of utilization of old devices you make an important contribution to

the protection of our environment.

Please contact your local authorities for details about collection points.

WARNING

Risk of electric shock

Do not open

Caution: To reduce the risk of electric shock, do not remove the cover (or back). There

are no user serviceable parts inside. Refer servicing to qualified service personnel.

Used batteries are hazardous waste and NOT to be disposed

of with the household waste! As a consumer you are legally

obligated all batteries to return for environmentally responsible

recycling – no matter whether or not the batteries contain harmful

substances*).

Return batteries

free of charge

to public collection points in your

community or to shops selling batteries of the respective kind.

Only return fully discharged batteries.

*) marked Cd = cadmium, Hg = mercury, Pb = lead

RCD5000 English Instruction Manual

LOCATION OF CONTROLS

1 Speaker 13 BAND Switch

2 Antenna 14 BASS Button

3 FOLDER DOWN Button 15 CD Compartment

4 FOLDER UP Button 16 LCD Button

5 MODE Button 17 CD Door Open Button

6 SKIP DOWN Button 18 AUX-IN Jack

7 SKIP UP Button 19 Battery Compartment

8 STOP/USB Button 20 AC Socket

9 PLAY/PAUSE Button 21 Handle

10 VOLUME Control 22 USB Slot (1A Charging)

11 TUNING Control 23 USB Slot (Decoding)

12 FUNCTION Switch 24 NFC Sensor

AC OPERATION

Before operation, please make sure that the VOLTAGE mentioned on the unit is same as the voltage of your local

area. Unravel the AC power cord, insert one end into the AC socket on the set, and the other end into a standard

AC outlet.

ATTENTION

1. Do not plug or unplug the power cable while you have wet hands.

2. When planning not to use this unit for a long time, disconnect the power cable from the wall outlet.

3. When disconnecting the power cord from the wall outlet, do not pull on the cord in order to avoid shock risks

caused by damaged cable.

BATTERY OPERATION

Disconnect the AC cord set completely. Open the battery compartment door and insert 8 pieces UM-2 "C" size

batteries into the battery compartment with battery polarity as shown inside the battery compartment.

USB CHARGING (1 A)

This product can provide 1A charging when it is under AC operation. You can charge most of the smartphones and

tablets. Please be reminded to connect your device to the correct USB slot.

BASS EFFECT

Press BASS button for bass effect.

RADIO OPERATION

1. Set the FUNCTION switch to RADIO position.

2. Rotate the TUNING control to tune to your desired radio station.

3. Adjust the sound level by rotating the VOLUME control.

4. To turn off the radio, set the FUNCTION switch to OFF position.

FM Stereo/Mono Broadcast

For FM Mono Broadcast, set the BAND switch to FM.

For FM stereo broadcast, set the BAND switch to FM ST. "ST." will be shown on the display.

RCD5000 English Instruction Manual

ANTENNA

For best reception, fully extend the FM Antenna to receive FM stations.

MP3/AUX IN CONNECTION

1. Set the FUNCTION switch to BT/AUX position.

2. Insert one side of the audio cable (requires 3.5mm stereo plug, not supplied) into the line-out jack or phones

jack on your MP3 player and the other side to the aux-in jack on the unit.

3. Turn on your MP3 player and follow the playback instruction.

4. Adjust the sound level by rotating the VOLUME control.

5. To stop this function, simply turned off your MP3 player.

CD/MP3/USB OPERATION

Playing Audio CDs

1. Set the FUNCTION switch to CD/USB position.

2. Insert a CD disc in the CD compartment and close the CD door, the unit will start reading the disc and will play

automatically.

3. During playing, press the PLAY/PAUSE button to temporarily pause playing. To resume, press the

PLAY/PAUSE button again.

4. Adjust the sound level by rotating the VOLUME control.

5. To stop playing the CD, press the STOP button.

Playing MP3 Discs

1. Set the FUNCTION switch to CD/USB position.

2. Insert a MP3 disc into the CD Compartment and close the door, the unit will start reading the disc and will play

automatically.

3. If your MP3 disc has folders, you can use the FOLDER DOWN/FOLDER UP button to select the desired folder.

4. During playing, press the PLAY/PAUSE button to temporarily pause playing. To resume, press the

PLAY/PAUSE button again.

5. Adjust the sound level by rotating the VOLUME control.

6. To stop playing the CD, press the STOP button.

Playing MP3 files with USB device

1. Set the FUNCTION switch to CD/USB position.

2. Press and hold the STOP/USB button to select the USB mode, USB will appear on the LCD display.

3. Plug your USB device into the USB port on the unit, the unit will start reading the files in the USB device and

play automatically.

4. If your USB device has folders, you can use the FOLDER DOWN/FOLDER UP button to select the desired folder.

5. During playing, press the PLAY/PAUSE button to temporarily pause playing. To resume, press the

PLAY/PAUSE button again.

6. Adjust the sound level by rotating the VOLUME control.

7. To stop playing the files in the USB, press the STOP button.

Note:

Because of non-standardized format definition/production of MP3 format, playback quality & performance are not

guaranteed.

Manufacturer is not responsible for the playability of MP3 in any case due to recording conditions such as PC

performance, writing software, media ability and etc.

Different Play Mode

Press the MODE button to select different kinds of play mode with the following sequence.

For Audio CDs : Repeat 1 Repeat All Normal  

For MP3 Files : Repeat 1 Repeat Folder Repeat All Normal   



Repeat 1 – repeat the track being played.



Repeat All – repeat all the tracks in the storage media.



Repeat Folder – repeat the tracks in the entire folder.



Normal – play the tracks in sequence.

Especificaciones del producto

Marca:	Soundmaster
Categoría:	Reproductores/grabadores de CD
Modelo:	RCD 5000
Color del producto:	Wit
Peso.:	50 g
Ancho:	60 mm
Profundidad:	60 mm
Altura:	19 mm
Actual:	1 A
Cables suministrados:	USB
Voltaje de entrada:	5 V
Cantidad de puertos micro-USB 2.0:	1
Wifi.:	Ja
Temperatura de funcionamiento (TT):	-10 - 55 °C
Código del Sistema Armonizado (SA):	85176990
Unidad de control y visualización:	Nee
Material-de-la-carcasa:	Kunststof