Speco Technologies PVM10 Manual de Usario

Lee a continuación 📖 el manual en español para Speco Technologies PVM10 (18 páginas) en la categoría Monitor. Esta guía fue útil para 11 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/18
SPECO PVM10 Manual
User Manual
PVM10
Public View Monitor
with built-in IP
Camera
Please read this manual carefully before operang the unit and keep it for
further reference
SPECO PVM10 Manual
Important Safeguards and Warnings
. Electrical safety
All installaon and operaon here should conform to local electrical safety codes.
Use a cered/listed 12VDC 2A Class2 power adapter (not included) or adequate PoE
switch.
Improper handling and/or installaon could run the risk of re or electrical shock.
. Environment
Do not expose the unit to heavy stress, violent vibraon or long term exposure to water-
and humidity during transportation, storage, and/or installaon.
Do not install near sources of heat. Only install the product in environments inside the
specicaon operang temperature and humidity range.
Do not install the PVM near power lines, radar equipment or other electromagnec
radiaon.
Do not block any venlaon openings if any.
. Operaon and Daily Maintenance
Please shut down the device and then unplug the power cable before you begin any
maintenance work.
Always use the dry so cloth to clean the device. If there is too much dust, use a cloth
dampened with a small quanty of neutral detergent. Finally use the dry cloth to clean the
device.
Stained with dirt:
Use oil free so brush or hair dryer to remove it gently.-
Stained with grease or ngerprint.
Use oil free cotton cloth or paper soaked with alcohol or detergent to wipe from the lens -
center outward. Change the cloth and wipe several mes if it is not clean enough.
SPECO PVM10 Manual
Warning
This camera should be installed by qualied personnel only.
All the examinaon and repair work should be done by qualied personnel.
Any unauthorized changes or modicaons could void the warranty.
Statement
This guide is for reference only.
Product, manuals, and specicaons may be modied without prior noce. Speco
Technologies reserves the right to modify these without noce and without incurring any
obligaon.
Speco Technologies is not liable for any loss caused by improper operaon.
Regulatory Informaon
FCC condions:
This device complies with part 15 of the FCC Rules. Operaon is subject to the following
two condions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause
undesired operaon.
FCC compliance:
This equipment has been tested and found to comply with the limits for a digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protecon against harmful interference.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instrucon manual, may cause harmful interference to
radio communicaon. However, there is no guarantee that interference will not occur in a
parcular installaon. If this equipment does cause harmful interference to radio or
television recepon, which can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separaon between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.

Especificaciones del producto

Marca: Speco Technologies
Categoría: Monitor
Modelo: PVM10

¿Necesitas ayuda?

Si necesitas ayuda con Speco Technologies PVM10 haz una pregunta a continuación y otros usuarios te responderán




Monitor Speco Technologies Manuales

Monitor Manuales

Últimos Monitor Manuales