Stanley ST-20F-DDF-E Manual de Usario

Stanley Ventilador ST-20F-DDF-E

Lee a continuación 📖 el manual en español para Stanley ST-20F-DDF-E (5 páginas) en la categoría Ventilador. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/5
Please note the serial number of your fan, and write it on the back of this User’s Manual for future reference.
READ AND SAVE THESE INSTRUCTIONS
IMPORTANT: Read and understand all of the instructions in this manual before assembling,
starting, or servicing the fan. Improper use of this fan can cause serious injury. Keep this manual for
future reference.
Model Numbers: ST-12F-DDF-E, ST-20F-DDF-E, ST-20FO-DDF-E, ST-24-DDF-E, ST-42-BDF-E,
ST-36-DDF-E, ST-30P-DDF-E
User’s Manual and Operating Instructions
12” Floor Fan
ST-12F-DDF-E
20” Floor Fan
ST-20F-DDF-E
20” Omni Floor Fan
ST-20FO-DDF-E
30” Pedestal Fan
ST-30P-DDF-E
© 2018, Obelis S.A Registered Address:
Bd. Général Wahis, 53 1030 Brussels, Belgium
42” Belt-Drive Barrel
Fan
ST-42-BDF-E
24” Floor Fan
ST-24-DDF-E
36” Direct-Drive Barrel
Fan
ST-36-DDF-E
STXE-400
NEVER LEAVE A FAN UNATTENDED WHILE
OPERATING OR WHILE CONNECTED TO A
POWER SOURCE
© 2018, Obelis S.A Registered Address:
Bd. Général Wahis, 53 1030 Brussels, Belgium
2
STANLEY, The STANLEY Logo, The Notched Rectangle and the Yellow and Black Diagonal Package
Design are all trademarks of Stanley Black & Decker, Inc. or an affiliate thereof.
To reduce risk of fire and to properly exhaust air, be sure to duct air outside.
CAUTION
Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces or garages.
Do not operate any fan with a damaged cord or plug.
WARNING
Discard fan or return to an authorized service facility for examination and/or repair.
Do not run under carpeting.
Do not cover with throw rugs, runners, or similar coverings.
Do not route cord under furniture or appliances.
Arrange cord away from traffic area where it will not be tripped over.
To reduce the risk of electric shock, do not expose to water/rain or use in damp locations.
IMPORTANT: READ ALL INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY, SERVICE OR
USE OF THIS FAN. FAILURE TO COMPLY WITH THESE INSTRUCTIONS COULD RESULT IN
SERIOUS PERSONAL INJURY AND / OR PROPERTY DAMAGE.
THIS IS A FAN - NOT A TOY! TO REDUCE THE RISK OF PERSONAL INJURY
AND ELECTRIC SHOCK, FANS SHOULD NOT BE PLAYED WITH OR PLACED
WHERE SMALL CHILDREN CAN REACH IT.
WARNING
To guard against electric shock while operating, do not allow fan to come in contact
with other grounded objects such as pipes, radiators, etc.
WARNING
Risk of fire, electric shock, or personal injury when performing service or mainte-
nance. Unplug or disconnect the fan from the power supply before servicing.
WARNING
Safety Information
CAUTION Automatically Operated Device - To Reduce The Risk Of Injury
Disconnect From Power Source Before Servicing
WARNING
To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Fan With Any Solid-
State Speed Control Device.
WARNING
To Reduce The Risk Of Electric Shock And Injury To Persons, Do Not Use In a
Window.
WARNING
For General Ventilating Use Only. Do Not Use To Exhaust Hazardous Or Explosive
Materials And Vapors. Never use the fan in spaces which contain products such as
gasoline, solvents, paint thinners, dust particles, volatile or airborne combustibles, or any unknown
chemicals.
CAUTION
NEVER LEAVE A FAN UNATTENDED WHILE
OPERATING OR WHILE CONNECTED TO A
POWER SOURCE
© 2018, Obelis S.A Registered Address:
Bd. Général Wahis, 53 1030 Brussels, Belgium
3
Safety Information
- Before operating always check fan for loose or damaged parts. Inspect power cord for any dam-
age. Never use fan if any parts are
damaged or missing. Never use fan without safety guards attached.
- Operate only on 220-240 volt, 50 Hz (cycle) current with a minimum of a 15 amp circuit.
- When used with an extension cord, use only cord of proper size (Amp rating), UL listed, and with
receptacle to accept three prong grounded plug furnished on the fan’s power cord. Always keep
power cord and extension cords away from heat, oil, and sharp edges. Inspect cords periodically
and replace if damaged.
Installation work and electrical wiring must be done by qualified person (s) in accor-
dance with all applicable codes and regulations.
WARNING
When servicing or replacing a component requires the removal or disconnection of
a safety device, the safety device is to be reinstalled or remounted as previously
installed before operating this fan.
WARNING
Use this fan only in the manner intended by the manufacturer.
WARNING
Do not operate any fan with a damaged cord or plug. Discard fan or return to an
authorized service facility for examination and/or repair. Do not run cord under car-
peting. Do not cover cord with throw rugs , runner, or similar coverings. Do not route cord under fur-
niture or appliances. Arrange cord away from traffic areas and where it will not be tripped over.
WARNING
1. Place the fan on level ground in a safe, desired position then connect to an approved power
source.
Installation and Assembly
ST-12F-DDF-E / ST-20F-DDF-E / ST-20FO-DDF-E / ST-24-DDF-E
To Reduce The Risk Of Electric Shock, Do Not Expose To Water Or Rain or use in
damp locations.
WARNING
ST-36-DDF-E / ST-42-BDF-E
1. Slide wheel axle through wheel support frame.
2. Slide one (1) wheel onto either side of axle.
3. Secure wheel with one (1) cotter pin.
4. Place the fan on level ground in a safe, desired position then connect to an approved power
source.

Especificaciones del producto

Marca: Stanley
Categoría: Ventilador
Modelo: ST-20F-DDF-E

¿Necesitas ayuda?

Si necesitas ayuda con Stanley ST-20F-DDF-E haz una pregunta a continuación y otros usuarios te responderán




Ventilador Stanley Manuales

Ventilador Manuales

Últimos Ventilador Manuales