Summit CKPUMPKIT Manual de Usario

Lee a continuación 📖 el manual en español para Summit CKPUMPKIT (4 páginas) en la categoría No categorizado. Esta guía fue útil para 7 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/4
CKPUMPKIT
Assembly Instructions for Your Kitchenette Water Pump
MODELS:
C48ELPUMP
C48ELGLASSPUMP
Write Serial Number (on lower left corner of
inside cabinet) here:
Serial No.: _______________________
Felix Storch, Inc.
An ISO 9001:2015 registered company
770 Garrison Avenue
The Bronx, NY 10474
www.summitappliance.com
Summit Appliance Division · Felix Storch, Inc. · www.summitappliance.com · 718- -3900 · info@summitappliance.com893
Pump Kit Installation CKPUMPKIT
Component
Quantity
Bottled Water Dispenser Pump System,
20ft 110V AC US Plug Water Dispensing
Pump
1
5 Gallon Freshwater Container
1
6 Gallon Waste Container
1
3/8 in. Brass Water Cut-o Valve
1
1/4" Acetal Copolymer Compression
Sleeve
1
20 in. Length Braided Stainless Steel
Faucet Connector
2
1- -in Flexible Plastic Drainage Pipe 1/2
1
Summit Appliance Division · Felix Storch, Inc. · www.summitappliance.com · 718- -3900 · info@summitappliance.com893
1/2 in. x 520 in. White Teon Tape
1
Mounting Template (18x12)
1
10-32 x 1 1/4" Phillips Head Truss Screw
Stainless Steel
4
10-32 Nylon Lock Nut Stainless Steel
4
10 x 5/8" Fender Washer Stainless Steel
4
Installation Instructions
1) Open the cabinet of your combo kitchen. Move the wire shelf to the oor of the cabinet. This is to
ensure nothing sits directly on the floor, keeping any cords or wires dry.
2) To install the faucet, set the gasket on top of the pre-drilled holes of the combo kitchen.
3) Insert the water faucet thought the gasket and secure the faucet with the provided nuts on the
underside of the sink.
4) The pump will be secured to the outer wall of the combo kitchen, using four machine screws and
nuts.
5) Place the provided template on the left side of the combo kitchen, in the top-right corner. It should
align to the front edge and along the bottom edge of the stainless steel top.
6) Using a drill bit, drill the four template holes. ¼”
7) Secure the pump to the interior wall of the cabinet, using the four provided screws, washers, and
nuts. Be sure the screw heads are on the outside of the cabinet.
NOTE: If mounting is not possible for your particular set-up, the pump can be placed on the oor of the
cabinet. It is recommended to place it, so the ON/OFF switch is accessible.

Especificaciones del producto

Marca: Summit
Categoría: No categorizado
Modelo: CKPUMPKIT

¿Necesitas ayuda?

Si necesitas ayuda con Summit CKPUMPKIT haz una pregunta a continuación y otros usuarios te responderán




No categorizado Summit Manuales

No categorizado Manuales

Últimos No categorizado Manuales