Tor Rey DT-2 Manual de Usario

Lee a continuación 📖 el manual en español para Tor Rey DT-2 (1 páginas) en la categoría No categorizado. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/1
INSTRUCTIONS
NOTES:
The printer is pre-programmed at Torrey to communicate with your scale.
You will need to purchase a RS-232 9 pin serial cable. It must be a straight thru, male on one end, female
on the other end. DO NOT purchase a null modem cable. It will not work.
The yellow button on top of printer is for programming/diagnostics only. Do not press it.
Do not run the software while the printer is connected to a computer. This may erase or alter the
programming.
When you turn on the printer, after a few seconds the led (light) on top should turn yellow/orange.
Printer was programmed for a 2-1/4 x 1-5/8” label with 1/8” gap between them. (Other size labels may
work but you might need to follow the procedure below).
To print a label, put weight on the platter, enter a price, then press M+. A label should print and you will
see something like TOT 1. This means total of items you weighed. Press C once to weigh another product
or press C twice to clear total.
If the led (light) turns red or the labels are not dispensing correctly, follow the procedure below:
1). Turn off printer
2). Hold in button on top of printer and turn on.
3). Hold in button until led (light) flashes yellow. Release button.
4). After a few seconds the printer will dispense several labels. It should be calibrated now.
5). Turn off and back on. Led (light) should turn yellow/orange.
6). Print a label.

Especificaciones del producto

Marca: Tor Rey
Categoría: No categorizado
Modelo: DT-2

¿Necesitas ayuda?

Si necesitas ayuda con Tor Rey DT-2 haz una pregunta a continuación y otros usuarios te responderán




No categorizado Tor Rey Manuales

Tor Rey

Tor Rey DT-2 Manual de Usario

5 Septiembre 2024

No categorizado Manuales

Últimos No categorizado Manuales