Valk Carbon 3+ Manual de Usario

Valk Scooter Carbon 3+

Lee a continuación 📖 el manual en español para Valk Carbon 3+ (17 páginas) en la categoría Scooter. Esta guía fue útil para 11 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/17
THE BATTERY MAY A H VE SOME CHARGE ON ARRIVAL, IT IS IMPORTANT
HOWEVER THAT THE BATTERY T IS CHARGED PRIOR O USE.
User Manual
[Revision 20237 .0 May ]
READ THIS MANUAL CAREFULLY BEFORE USE FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND MAY
VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by this manual may vary in appearance,
assembly, inclusions, specifications, description, and packaging.
Carbon 3+ Scooter
E&OE © 2 2023 Valk
Safety
Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or
equipment or property damage if not understood or followed. Safety messages have the following symbols:
You WILL be KILLED or
SERIOUSLY INJURED if you do
not follow instructions.
You CAN be KILLED or
SERIOUSLY INJURED if you do
not follow instructions.
You CAN be INJURED if you do
not follow instructions or equipment
damage may occur.
It is vital that you read and understand this
user manual before using the product,
including safety warnings, and any assembly
and operating instructions. Keep the manual
for future reference.
Safety precautions and recommendations
detailed here must be fully understood and
followed to reduce the risk of injury, fire,
explosion, electrical hazard, and/or property
damage.
Safety information presented here is generic
in nature – some advice may not be
applicable to every product. The term
"equipment" refers to the product, be it
electrical mains powered, battery powered or
combustion engine powered.
- If you are not familiar with the Before Use
safe operation/handling of the equipment or
are in any way unsure of any aspect of
suitability or correct use for your
application, you should complete training
conducted by a person or organization
qualified in safe use and operation of this
equipment, including fuel/electrical handling
and safety.
Do NOT operate the equipment in
flammable or explosive environments, such
as in the presence of flammable liquids,
gases, or dust. The equipment may create
sparks or heat that may ignite flammable
substances.
Keep clear of moving parts.
Equipment may be a potential source of
electric shock or injury if misused.
Do NOT operate the equipment if it is
damaged, malfunctioning or is in an
excessively worn state.
Do NOT allow others to use the equipment
unless they have read this manual and are
adequately trained.
Keep packaging away from children - risk
of suffocation! Operators must use the
equipment correctly. When using the
equipment, consider conditions and pay
due care to persons and property.
General Work Area Safety
Work areas should be clean and well it.
Do not operate the equipment if
bystanders, animals etc are within
operating range of the equipment or the
general work area.
If devices are provided for connecting dust
extraction / collection facilities, ensure
these are connected and used properly.
Dust collection can reduce dust-related
hazards.
General Personal Safety
Wear appropriate protective equipment
when operating, servicing, or when in the
operating area of the equipment to help
protect from eye and ear injury, poisoning,
burns, cutting and crush injuries. Protective
equipment such as safety goggles,
respirators, non-slip safety footwear, hard
hat, hearing protection etc should be used
for appropriate equipment / conditions.
Other people nearby should also wear
appropriate personal protective equipment.
Do not wear loose clothing or jewellery,
which can be caught in moving parts. Keep
hair and clothing away from the equipment.
Stay alert and use common sense when
operating the equipment. Do not over-
reach. Always maintain secure footing and
balance.
Do not use the equipment if tired or under
the influence of drugs, alcohol, or
medication.
This equipment is not intended for use by
persons with reduced physical, sensory, or
mental capabilities.
General Fuel Safety
Petrol/fuel/gasoline is extremely flammable
– keep clear of naked flames or other
ignition sources.
Do not spill fuel. If you spill fuel, wipe it off
the equipment immediately – if fuel gets on
your clothing, change clothing.
Do NOT smoke near fuel or when
refuelling.
Always shut off the engine before
refuelling.
Do NOT refuel a hot engine.
Open the fuel cap carefully to allow any
pressure build-up in the tank to release
slowly.
Always refuel in well ventilated areas.
Always check for fuel leakage. If fuel
leakage is found, do not start, or run the
engine until all leaks are fixed.
General Carbon-Monoxide Safety
Using a combustion engine indoors CAN
KILL IN MINUTES. Engine exhaust
contains carbon-monoxide – a poison you
cannot smell or see.
Use combustion engines OUTSIDE only,
and far away from windows, doors, and
vents.
General Equipment Use and Care
The equipment is designed for domestic
use only.
Handle the equipment safely and carefully.
Before use, inspect the equipment for
misalignment or binding of moving parts,
loose components, damage, or any other
condition that may affect its operation. If
damaged, have the equipment repaired by
an authorised service centre or technician
before use.
Prevent unintentional starting of the
equipment - ensure equipment and power
switches are in the OFF position before
connecting or moving equipment. Do not
carry equipment with hands or fingers
touching any controls. Remove any tools or
other items that are not a part of the
equipment from it before starting or
switching on.
Do not force the equipment. Use the
correct equipment for your application.
Equipment will perform better and be safer
when used within its design and usage
parameters.
Use the equipment and accessories etc. in
accordance with these instructions,
considering working conditions and the
work to be performed. Using the equipment
for operations different from those intended
could result in hazardous situations.
Always keep equipment components
(engines, hoses, handles, controls, frames,
housings, guards etc) and accessories
(cutting tools, nozzles, bits etc) properly
maintained. Keep the equipment clean and,
where applicable, properly lubricated.
Store the equipment out of reach of
children or untrained persons. To avoid
burns or fire hazards, let the equipment
cool completely before transporting or
storing. Never place or store the equipment
near flammable materials, combustible
gases, or liquids etc.
The equipment is not weather-proof, and
should not be stored in direct sunlight, at
high ambient temperatures or locations that
are damp or humid.
Do not clean equipment with solvents,
flammable or harsh abrasives. liquids,
For specific equipment safety use and care,
see Equipment Safety.
Carbon 3+ Scooter
E&OE © 3 2023 Valk
General Electrical Safety
Inspect electrical equipment, extension
cords, power bars, and electrical fittings for
damage or wear before each use. Repair or
replace damaged equipment immediately.
Ensure all power sources conform to
equipment voltage requirements and are
disconnected before connecting or
disconnecting equipment.
When wiring electrically powered
equipment, follow all electrical and safety
codes.
Wherever possible, use a residual current
device (RCD).
High voltage / high current power lines may
be present. Use extreme caution to avoid
contact or interference with power lines.
Electrical shock can be fatal.
General Electrical Safety
Electrically grounded equipment must have
an approved cord and plug and be
connected to a grounded electrical outlet.
Do NOT bypass the ON/OFF switch and
operate equipment by connecting and
disconnecting the electrical cord.
Do NOT use equipment that has exposed
wiring, damaged switches, covers or
guards.
Do NOT use electrical equipment in wet
conditions or in damp locations.
Do NOT use electrical cords to lift, move or
carry equipment.
Do NOT coil or knot electrical cords, and
ensure electrical cords are not trip hazards.
General Service Information
The equipment must be serviced or
repaired at authorised service centres by
qualified personnel only.
Replacement parts must be original
equipment manufacturer (OEM) to ensure
equipment safety is maintained.
Do NOT attempt any maintenance or repair
work not described in this manual.
After use, the equipment and components
may still be hot – allow the equipment to
cool and disconnect spark plugs and/or
electrical power sources and/or batteries
from it before adjusting, changing
accessories, or performing repair or
maintenance.
Do NOT adjust while the equipment is
running.
Perform -related service activities in suitable
conditions, such as a workshop.
Replace worn, damaged or missing
warning/safety labels immediately.
Electric Scooter Safety
The Scooter is a recreational product. Before mastering riding skills, you need to practice. The supplier is not responsible for any injuries or
damage caused by a rider's inexperience or failure to follow the instructions in this user manual.
You can reduce risks by following all the instructions and warnings in this user manual, but you cannot eliminate all risks. Remember that
whenever you ride the Scooter, you risk injury from loss of control, collisions, and falls. When entering public spaces, always comply with the
local laws and regulations.
As with other vehicles, faster speeds require longer braking distance. Sudden braking on low traction surfaces could lead to wheel slips or falls.
Be cautious and always keep a safe distance between you and other people or vehicles when riding. Be alert and slow down when entering
unfamiliar areas.
Always wear a helmet when riding. Use an approved bicycle or skateboard helmet that fits properly with the chin strap in place and provides
protection for the back of your head.
Do not attempt your first ride in any area where you might encounter children, pedestrians, pets, vehicles, bicycles, or other obstacles and
potential hazards.
Respect pedestrians by always yielding the right of way. Pass on the left whenever possible. When approaching a pedestrian from the front, stay
to the right and slow down. Avoid startling pedestrians. When approaching from behind, announce yourself and slow down to walking speed
when passing. Please obey local traffic laws and regulations if situation is different.
In places without laws, comply with the safety guidelines outlined in this user manual. The supplier is not responsible for any property damage,
personal injury/death, accidents, or legal disputes caused by violations of the safety instructions.
Do not allow anyone to ride your Scooter on his/her own unless they have carefully read this user manual and followed the New Rider Tutorial in
the App. The safety of new riders is your responsibility. Assist new riders until they are comfortable with the basic operation of the Scooter. Make
sure each new rider wears a helmet and other protective gear.
Before each ride, check for loose fasteners and damaged components. If the Scooter makes abnormal sounds or signals an alarm, immediately
stop riding. Diagnose your Scooter via the App and call your local dealer/distributor for servicing.
Always be alert! Scan both far ahead and in front of your Scooter - your eyes are your best tool for safely for avoiding obstacles and low traction
surfaces (including, but not limited to, wet ground, loose sand, loose gravel, and ice).
To reduce risk of injury, you must read and follow all "CAUTION" and "WARNING" notices in this user manual. Do not ride at an unsafe speed.
Under no circumstance should you ride on roads with motor vehicles. The manufacturer recommends riders be 14+ years old. Always follow
these safety instructions:
People who should not ride the Scooter include:
Anyone under the influence of alcohol or drugs.
Anyone who suffers from any diseases that puts them at risk if they engage in strenuous physical activit y.
Anyone who has problems with balance or with motor skills that would interfere with their ability to maintain balance.
Anyone whose weight is outside the stated limits (see Specifications).
Pregnant women.
Riders under the age of 18 years old should ride under adult supervision.
Comply with local laws and regulations when riding this product. Do not ride where prohibited by local laws.
To ride safely, you must be able to clearly see what is in front of you and you must be clearly visible to others.
Do not ride in the snow, in the rain, or on roads which are wet, muddy. icy, or that are slippery for any reason. Do not ride over obstacles (sand,
loose gravel. or sticks). Doing so could result in a loss of balance or traction and could cause a fall.
Do not attempt to charge your Scooter if the charger or the power outlet is wet.
As with any electronic device, use a surge protector when charging to help protect your Scooter from damage due to power surges and voltage
spikes. Only use supplier’s charger. Do not use a charger from any other different product models.

Especificaciones del producto

Marca: Valk
Categoría: Scooter
Modelo: Carbon 3+
Fuente-de-alimentación: Batterij/Accu
Impermeable: Ja
Estación de carga: Nee
Número de cabezales de cepillo incluidos: 1 stuk(s)
Inalámbrico: Ja
Número de niveles de intensidad: 3

¿Necesitas ayuda?

Si necesitas ayuda con Valk Carbon 3+ haz una pregunta a continuación y otros usuarios te responderán




Scooter Valk Manuales

Scooter Manuales

Últimos Scooter Manuales