Wasco LS 1403 E Manual de Usario

Wasco lavadora LS 1403 E

Lee a continuación 📖 el manual en español para Wasco LS 1403 E (52 páginas) en la categoría lavadora. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/52

Washing Machine

Vaskemaskine

Tvättmaskin

LS 1403 E

2EN

1 Important safety instructions

This section contains safety instructions that will

help protect from risk of personal injury or property

damage. Failure to follow these instructions shall

void any warranty.

General safety

• 8yearsandolderchildrenandpeoplewith

reduced physical, sensory, and mental abilities

as well as unskilled or inexperienced persons

can use this appliance provided that they are

supervised and instructed on safe use of the

appliance as well as to the related dangers.

Children should not play or tamper with the

appliance. Cleaning and user maintenance

should never be performed by children unless

supervised by a responsible adult.

• Neverplacetheproductonacarpet-covered

floor; otherwise, lack of airflow beneath the

machine will cause electrical parts to overheat.

This will cause problems with your product.

• Donotoperatetheproductifthepowercable

/ plug is damaged. Call the Authorized Service

Agent.

• Haveaqualifiedelectricianconnecta

16-Amperefusetotheinstallationlocationof

the product.

• Iftheproducthasafailure,itshouldnot

be operated unless it is repaired by the

Authorized Service Agent. There is the risk of

electric shock!

• Thisproductisdesignedtoresumeoperating

in the event of powering on after a power

interruption.Ifyouwishtocancelthe

programme, see "Cancelling the programme"

section.

• Connecttheproducttoagroundedoutlet

protected by a fuse complying with the values

inthe"Technicalspecifications"table.Donot

neglect to have the grounding installation

madebyaqualifiedelectrician.Ourcompany

shall not be liable for any damages that

will arise when the product is used without

grounding in accordance with the local

regulations.

• Thewatersupplyanddraininghosesmustbe

securely fastened and remain undamaged.

Otherwise,thereistheriskofwaterleakage.

• Neveropentheloadingdoororremovethe

filter while there is still water in the drum.

Otherwise,riskoffloodingandinjuryfromhot

water will occur.

• Donotforceopenthelockedloadingdoor.

The loading door will be ready to open just a

few minutes after the washing cycle comes to

anend.Incaseofforcingtheloadingdoorto

open, the door and the lock mechanism may

get damaged.

• Unplugtheproductwhennotinuse.

• Neverwashtheproductbyspreadingor

pouring water onto it! There is the risk of

electric shock!

• Nevertouchtheplugwithwethands!Never

unplug by pulling on the cable, always pull out

by grabbing the plug.

• Usedetergents,softenersandsupplements

suitable for automatic washing machines only.

• Followtheinstructionsonthetextiletagsand

on the detergent package.

• Theproductmustbeunpluggedduring

installation, maintenance, cleaning and

repairing procedures.

• Alwayshavetheinstallationandrepairing

procedures carried out by the Authorized

Service Agent. Manufacturer shall not be

held liable for damages that may arise from

procedures carried out by unauthorized

persons.

Intended use

• Thisproducthasbeendesignedfordomestic

use.Itisnotsuitableforcommercialuseandit

must not be used out of its intended use.

• Theproductmustonlybeusedforwashing

and rinsing of laundry that are marked

accordingly.

• Themanufacturerwaivesanyresponsibility

arisen from incorrect usage or transportation.

Children's safety

• Electricalproductsaredangerousforthe

children. Keep children away from the product

whenitisinuse.Donotletthemtotamper

withtheproduct.Usechildlocktoprevent

children from intervening with the product.

• Donotforgettoclosetheloadingdoorwhen

leaving the room where the product is located.

• Storealldetergentsandadditivesinasafe

place away from the reach of the children.

2 Installation

Refer to the nearest Authorised Service Agent for

installation of the product. To make the product

ready for use, review the information in the user

manual and make sure that the electricity, tap

water supply and water drainage systems are

appropriate before calling the Authorized Service

Agent.Iftheyarenot,callaqualifiedtechnician

and plumber to have any necessary arrangements

carried out.

C Preparation of the location and electrical,

tap water and waste water installations at

the place of installation is under customer's

responsibility.

B Installationandelectricalconnectionsofthe

product must be carried out by the Authorized

Service Agent. Manufacturer shall not be

held liable for damages that may arise from

procedures carried out by unauthorized

persons.

A Prior to installation, visually check if the

producthasanydefectsonit.Ifso,donot

haveitinstalled.Damagedproductscause

risks for your safety.

3EN

Make sure that the water inlet and discharge

hoses as well as the power cable are not

folded, pinched or crushed while pushing

the product into its place after installation or

cleaning procedures.

Appropriate installation location

• Placethemachineonarigidfloor.Donot

place it on a long pile rug or similar surfaces.

• Totalweightofthewashingmachineandthe

dryer-withfullload-whentheyareplaced

on top of each other reaches to approx.

180kilograms.Placetheproductonasolid

and flat floor that has sufficient load carrying

capacity!

• Donotplacetheproductonthepowercable.

• Donotinstalltheproductatplaceswhere

temperaturemayfallbelow0ºC.

• Placetheproductatleast1cmawayfromthe

edges of other furniture.

Removing packaging reinforcement

Tilt the machine backwards to remove the

packaging reinforcement. Remove the packaging

reinforcement by pulling the ribbon.

Removing the transportation locks

A Donotremovethetransportationlocksbefore

taking out the packaging reinforcement.

A Remove the transportation safety bolts before

operating the washing machine, otherwise,

the product will be damaged.

1. Loosen all the bolts with a spanner until they

rotate freely (C).

2. Remove transportation safety bolts by turning

them gently.

3. AttachtheplasticcoverssuppliedintheUser

Manual bag into the holes on the rear panel.

(P)

C Keep the transportation safety bolts in a safe

place to reuse when the washing machine

needs to be moved again in the future.

C Never move the product without the

transportation safety bolts properly fixed in

place!

Connecting water supply

C Thewatersupplypressurerequiredtorun

theproductisbetween1to10bars(0.1–1

MPa).Itisnecessarytohave10–80litersof

water flowing from the fully open tap in one

minute to have your machine run smoothly.

Attach a pressure reducing valve if water

pressure is higher.

C Ifyouaregoingtousethedoublewater-inlet

productasasingle(cold)water-inletunit,you

must install the supplied stopper to the hot

water valve before operating the product.

(Applies for the products supplied with a blind

stopper group.)

C Ifyouwanttousebothwaterinletsofthe

product, connect the hot water hose after

removing the stopper and gasket group from

the hot water valve. (Applies for the products

supplied with a blind stopper group.)

A Models with a single water inlet should not

beconnectedtothehotwatertap.Insuch

a case the laundry will get damaged or the

product will switch to protection mode and will

not operate.

A Donotuseoldorusedwaterinlethoseson

thenewproduct.Itmaycausestainsonyour

laundry.

1. Connect the special hoses supplied with the

product to the water inlets on the product.

Redhose(left)(max.90ºC)isforhotwater

inlet,bluehose(right)(max.25ºC)isforcold

water inlet.

A Ensure that the cold and hot water

connections are made correctly when

installingtheproduct.Otherwise,yourlaundry

will come out hot at the end of the washing

process and wear out.

2. Tighten all hose nuts by hand. Never use a

wrench when tightening the nuts.

3. Openthetapscompletelyaftermakingthe

hose connection to check for water leaks at

theconnectionpoints.Ifanyleaksoccur,turn

off the tap and remove the nut. Retighten

the nut carefully after checking the seal. To

prevent water leakages and damages caused

by them, keep the taps closed when the

machine is not in use.

Connecting to the drain

• Theendofthedrainhosemustbedirectly

connected to the wastewater drain or to the

washbasin.

A Your house will be flooded if the hose comes

out of its housing during water discharge.

Moreover, there is risk of scalding due to

high washing temperatures! To prevent such

Especificaciones del producto

Marca:	Wasco
Categoría:	lavadora
Modelo:	LS 1403 E
Color del producto:	Red, White
Peso.:	65.5 g
Altura:	77 mm
Manual de usuario:	Ja
Material de la carcasa:	Kunststof
Cargador:	Ja
Capacidad del acumulador/batería:	500 mAh
Edad recomendada (mín.):	14 jaar
Giroscopio:	Ja
Banda de frecuencia:	2.4 GHz
Batería/Voltaje de la batería:	3.7 V
Longitud:	238 mm
Tipo de construcción:	Ready-to-fly (RTF)
Distancia máxima:	150 m
Número de canales:	6 kanalen
Carga vía USB:	Ja
Baterias-incluidas:	Ja
Tipo-producto:	Helikopter
Tecnología de batería:	Lithium-Polymeer (LiPo)
Tipo de motor:	Borstelloos
Número de baterías (transmisor):	4
Número de hélices:	1 propellers
Transmisor:	Ja
Número de palas del rotor principal:	3
Frecuencia de transmisión:	2.4 GHz
Tiempo de vuelo:	10 min
Material de las palas del rotor:	Kunststof