Westland SW 12 Manual de Usario

Westland No categorizado SW 12

Lee a continuación 📖 el manual en español para Westland SW 12 (2 páginas) en la categoría No categorizado. Esta guía fue útil para 4 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF
Página 1/2
Step 1: Push Bar
• Fit the push rods into the spreader tank (Fig.2)
• Fit the push bar on to the push rods (Fig.3)
Step 2: Adjustment lever
• Fit the adjustment lever grip (Fig.1/ Item 2)
to the adjustment lever (Fig.4/ Item A).
Setup Guide:
Lawn Spreader Instructions
Layout
1. Push bar
2. Adjustment lever for setting the spreading volume
3. Spreader tank
4. Wheel
5. Stand
6. Push rods
Step 4: Wheels
• Take the wheel caps off the wheels (Fig.7)
• Remove the screws (Fig.8/ Item E) (on
both sides).
• Attach the wheels (Fig.9/ Item D) and
secure them.
• Fit the wheel caps.
Step 3: Foot
• Remove the screw (Fig.5/ Item B)
• Insert the foot (Fig.6/ Item 5) and secure it.
2 3
4
6
9
5
7 8
1
44 5
23
6
13
4
25
6 1
6
3
1
A
B
5
C D
E E D
102077 A4 Lawn Spreader 20/2/09 09:54 Page 1
1. MEASURE YOUR LAWN AREA
Measure the length and breadth of the lawn. Multiply the measurements together to get the area you need to
treat (For example 10 metres x 10 metres = 100m
2).
2. PREPARING YOUR SPREADER FOR USE
• Always read the product label before use.
• DO NOT fill the Lawn Spreader on the lawn.
• Ensure hopper is dry and applicator outlets are clear of obstruction.
• Set the distribution lever to zero.
• Carefully pour product into Lawn Spreader ensuring an even spread across the hopper.
• To ensure that the Lawn Spreader distributes the lawn treatment product at the recommended rate it is
essential that the hopper is filled above the black plastic plate at all times.
• DO NOT apply if grass is wet/damp and longer than 60-70mm as lawn treatment product may become damp,
blocking the Lawn Spreader and may result in over or under-dosing of product.
3. USING YOUR SPREADER
1. Before inserting the appropriate Westland lawn product, always set the adjustable lever to zero.
2. Do not fill the spreader on the lawn. Place the spreader on a sheet of newspaper or plastic to avoid spillage on
paths/patios.
3. Set calibration lever on top of the hopper to appropriate setting to start applying the
product. It is important to start walking immediately after the lever is set as the product
will start discharging from the spreader. The recommended settings for Westland product
with an application rate of 35g/m2
0 =Off
3 =Aftercut Lawn Feed & Conditioner, Lawn Feed Weed Moss Killer*,
Autumn Lawn Feed & Moss Killer**
4. It is recommended to treat 2/3 stripes of lawn alongside fences and hedges to avoid
having to make difficult manoeuvres along these perimeters. This will allow you to treat
the rest of the lawn in stripes (Fig.1).
5. Walk at a steady pace up and down the lawn, slightly overlapping the edges to prevent
stripes until you have covered the required distance (Fig.2).
6. If rain does not fall within 48 hours, it is best to water the lawn thoroughly.
7. The lawn is safe for use by children and pets once the product has been watered in.
4. AFTER USE
• NEVER leave product sitting in the hopper. Move the spreader off the lawn and pour
leftover product back into the original container, seal tightly and store in a safe, dry place.
• Clean hopper thoroughly using a stiff bristled brush. Open the distribution lever to setting
10 and remove all residues, particularly around the axle.
• DO NOT allow any cleanings to enter drains. Clean up residues and dispose of safely.
• Store the clean, dry Lawn Spreader under cover ready for next use.
*Westland Lawn Feed Weed & Moss Killer MAPP 10794 contains 2,4-D, mecoprop-P and ferrous sulphate.
**Westland Autumn Lawn Feed & Moss Killer MAPP 11023 contains ferrous sulphate. Always read the label. Use pesticides safely.
Application Advice
For further information on the Westland range of products please contact our Customer Care Department or visit www.gardenhealth.com
Customer Care Department, Westland Horticulture Limited, 14 Granville Industrial Estate, Granville Road, Dungannon, Co. Tyrone, BT70 1NJ.
UK Tel: 08700 663 566 ROI Tel: 1800 927 927
Guide To Using Lawn Spreader
To get the best results from your Lawn Spreader
read all instructions and advice before use
Complete two circuits of the
lawn. Continue treating
remaining lawn in straight strips
off the longest side.
For correct bout spacing line up
arrow on hopper with previous
wheeling mark.
Fig.1
Fig.2
102077 A4 Lawn Spreader 20/2/09 09:54 Page 2

Especificaciones del producto

Marca: Westland
Categoría: No categorizado
Modelo: SW 12

¿Necesitas ayuda?

Si necesitas ayuda con Westland SW 12 haz una pregunta a continuación y otros usuarios te responderán


No categorizado Westland Manuales

Westland

Westland SW 12 Manual de Usario

15 Septiembre 2024

No categorizado Manuales

Últimos No categorizado Manuales

POLARIS

POLARIS RZR S 1000 EPS (2018) Manual de Usario

27 Octubre 2024
Workzone

Workzone 20V Li-Ion Reciprocating Saw PT160501 Manual de Usario

27 Octubre 2024
Philips

Philips 43PUL7672 Manual de Usario

27 Octubre 2024
Manhattan

Manhattan 461504 Manual de Usario

27 Octubre 2024
Sungrow

Sungrow SG125HV Manual de Usario

27 Octubre 2024
Schneider

Schneider CCT724319 Manual de Usario

27 Octubre 2024
Technoline

Technoline WS 250 Manual de Usario

27 Octubre 2024
Livarno

Livarno IAN 354423 Manual de Usario

27 Octubre 2024
Kupper

Kupper 12152 Manual de Usario

27 Octubre 2024
JennAir

JennAir CARBON24L Manual de Usario

27 Octubre 2024