Whirlpool MK2167AW Manual de Usario

Whirlpool Magnetron MK2167AW

Lee a continuación 📖 el manual en español para Whirlpool MK2167AW (12 páginas) en la categoría Magnetron. Esta guía fue útil para 8 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/12

MICROWAVE OVEN BUILT-IN TRIM KIT

INSTALLATION INSTRUCTIONS

Built-In Trim Kit Models MK2167, MK2160

UL listed for use over any electric or gas built-in oven, up to 30" (76.2 cm) wide

INSTRUCTIONS D’INSTALLATION

GARNITURE ENCASTRÉE POUR FOUR À MICRO-ONDES

Garniture encastrée pour modèles MK2167, MK2160

Homologation UL pour utilisation au-dessus de tous les fours encastrés électriques ou gaz, jusqu’à 30" (76,2 cm) de largeur

MICROWAVE OVEN SAFETY

Table of Contents / Table des matières

MICROWAVE OVEN SAFETY ...................................................1

INSTALLATION INSTRUCTIONS..............................................2

Tools and Parts .......................................................................2

Location Requirements...........................................................2

Required Cutout Dimensions..................................................2

Trim Kit Frame Dimensions.....................................................3

Electrical Requirements ..........................................................3

Prepare Microwave Oven........................................................3

Prepare Cutout/Cabinet Opening ...........................................4

Install the Microwave Oven.....................................................5

Install Trim Kit Frame ..............................................................6

SÉCURITÉ DU FOUR À MICRO-ONDES...........................................7

INSTRUCTIONS D’INSTALLATION....................................................7

Outillage et pièces.............................................................................7

Exigences d'emplacement................................................................7

Dimensions nécessaires de l'ouverture d'encastrement..................8

Dimensions du cadre de la trousse de garniture..............................8

Spécifications électriques .................................................................9

Préparation du four à micro-ondes...................................................9

Préparation de l'ouverture d'encastrement ....................................10

Installation du four à micro-ondes ..................................................11

Installation du cadre de la trousse de garniture .............................12

W10532204A

You can be killed or seriously injured if you don't immediately

You can be killed or seriously injured if you don't follow

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can

happen if the instructions are not followed.

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety

messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”

These words mean:

follow instructions.

instructions.

DANGER

WARNING

INSTALLATION INSTRUCTIONS

Tools and Parts

Tools Needed

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools

listed here.

Parts Supplied (not shown to scale

Location Requirements

The microwave oven may be installed over a built-in oven. If

installing over a built-in oven, make sure there is a minimum of 3"

(7.6 cm) between the top of the lower oven cutout and the

microwave oven cutout floor.

The microwave oven may also be installed in a cabinet by itself

(without a built-in oven below). For best usability, we recommend

a minimum distance of 36" (91.4 cm) from the floor to the cutout

floor.

Make sure the surrounding cabinetry has clearance to open and

close freely. Allow a clearance of at least 1⁹⁄₁₆" (4.0 cm) below the

cutout floor (3" [7.6 cm] for installation above a built-in oven), and

a clearance of at least 2" (5.1 cm) above the cutout opening.

Required Cutout Dimensions

NOTES:

■Depth requirements depend upon receptacle and its location

within or outside of recommended region. See illustration and

chart above.

■Height dimension is critical: 17" (43.2 cm) minimum, 17¹⁄₈"

(43.5 cm) maximum.

■Width measurement has ±1/16" (2 mm) tolerance.

■3" (7.6 cm) minimum dimension is from lower oven cutout

ceiling to microwave oven cutout floor.

■Trim kit frame extends 1¹⁄₁₆" (2.7 cm) above and below the

cutout opening.

■Measuring tape

■Pencil

■Phillips screwdriver

■Drill

■7/64" drill bit

Rails (2) Bottom duct Trim kit frame

Short screws (14)

(11 + 3 extra)

Long wood screws (6 - painted)

(4 + 2 extra)

A. Upper cabinet

B. Microwave oven cutout

C. Lower oven cutout

D. Lower cabinets

E. Floor

(7.6 cm)

36"

(91.4 cm)

(5.1 cm)

1 "⁹⁄₁₆

(4.0 cm)

A. Trim kit frame overhang

B. Cutout for lower oven

C. Recommended region for receptacle

location (no less than 6" [15.2 cm] to

the right of cutout centerline)

D. Cutout centerline

Receptacle Location Minimum Depth

Within recommended

region

18" (45.7 cm) with flush receptacle;

21" (53.2 cm) with non-flush receptacle

Outside recommended

region

19¹⁄₂" (49.5 cm) with flush receptacle;

22¹⁄₂" (57.2 cm) with non-flush

receptacle

(7.6 cm)

(15.2 cm)

1 "¹⁄₁₆

(2.7 cm)

1 "¹⁄₁₆

(2.7 cm)

23¹⁄₈" (58.7 cm)17 " (43.5 cm)¹⁄₈

max.

17" (43.2 cm)

min.

For minimum depth requirements, see chart.

Trim Kit Frame Dimensions

*27" (68.6 cm) trim kit

**30" (76.2 cm) trim kit

Electrical Requirements

Observe all governing codes and ordinances.

Required:

■A 120 volt, 60 Hz, AC only, 15- or 20-amp electrical supply

with a fuse or circuit breaker.

Recommended:

■A time-delay fuse or time-delay circuit breaker.

■A separate circuit serving only this microwave oven.

Prepare Microwave Oven

1. Unplug microwave oven before proceeding with installation.

2. Remove any loose items inside microwave oven.

3. Gently turn microwave oven onto its top, with the door facing

forward (toward installer).

4. Align the two rails on the microwave oven bottom, as shown,

making sure the flanges are forward and pointing up.

5. Secure the rails to the microwave oven bottom using four

short screws.

26⁷⁄₈" (68.2 cm)**

29³⁄₄" (75.6 cm)**

2 " (5.2 cm)*¹⁄₁₆

3¹⁄₂" (8.9 cm)**

22 " (57.8 cm)³⁄₄

12¹⁄₄

(31.1 cm

)

1 " (3.0 cm)³⁄₁₆

19 "¹⁄₈

(48.6 cm)

3⁷⁄₁₆"

(8.7 cm)

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

WARNING

A. Rails (2)

B. Microwave oven bottom

C. Short screws (4)

D. Flanges

E. Door

GROUNDING INSTRUCTIONS

SAVE THESE INSTRUCTIONS

■ For all cord connected appliances:

The microwave oven must be grounded. In the event of

an electrical short circuit, grounding reduces the risk of

electric shock by providing an escape wire for the electric

current. The microwave oven is equipped with a cord

having a grounding wire with a grounding plug. The plug

must be plugged into an outlet that is properly installed

and grounded.

WARNING: Improper use of the grounding plug can

result in a risk of electric shock. Consult a qualified

electrician or serviceman if the grounding instructions are

not completely understood, or if doubt exists as to whether

the microwave oven is properly grounded.

Do not use an extension cord. If the power supply cord is

too short, have a qualified electrician or serviceman install

an outlet near the microwave oven.

A B C

D E

Especificaciones del producto

Marca:	Whirlpool
Categoría:	Magnetron
Modelo:	MK2167AW
Color del producto:	Zwart
Peso.:	100 g
Ancho:	55 mm
Profundidad:	260 mm
Altura:	20 mm
Longitud del cable:	0.195 m
Peso del embalaje:	104 g
Ancho del embalaje:	170 mm
Empaquetadura en profundidad:	142 mm
Altura del embalaje:	30 mm
Material de la carcasa:	Kunststof
Indicadores LED:	Activity, Link, Power
Tecnología de conectividad:	Bedraad
versión USB:	3.2 Gen 1 (3.1 Gen 1)
Interfaz:	Fiber
Certificados de sostenibilidad:	CE, RoHS
Conecta y reproduce:	Ja
Estándar de red:	IEEE 802.1Q, IEEE 802.3z
Temperatura de almacenamiento:	-10 - 70 °C
Interno:	Nee
Soporta el sistema operativo Mac:	Mac OS X 10.10 Yosemite, Mac OS X 10.11 El Capitan, Mac OS X 10.12 Sierra, Mac OS X 10.13 High Sierra, Mac OS X 10.14 Mojave, Mac OS X 10.9 Mavericks, Mac OS X 11.0 Big Sur, Mac OS X 12.0 Monterey, Mac OS X 13.0 Ventura
Cumplimiento de la sostenibilidad:	Ja
Compatible con Linux:	Ja
Fuente de alimentación a través de USB:	Ja
Interfaz de host:	USB Type-C
Velocidad máxima de transferencia de datos:	1000 Mbit/s
Sistemas operativos de servidor compatibles:	Windows Server 2008, Windows Server 2012, Windows Server 2016, Windows Server 2019
Compatibilidad con tramas gigantes:	Ja
Duplex completo:	Ja
conjunto de chips:	Realtek - RTL8153-VB-CG, Microsemi - VSC8211XVW
Altura del paquete principal (exterior):	395 mm
Ancho del embalaje principal (exterior):	330 mm
Longitud del paquete principal (exterior):	605 mm
Cantidad por caja principal (exterior):	80 stuk(s)
Activación de la LAN:	Ja
Temperatura de funcionamiento (TT):	0 - 60 °C
Humedad relativa de funcionamiento (VV):	5 - 90 procent
Código del Sistema Armonizado (SA):	85176990
Marcos gigantes:	9000
conector de fibra óptica:	SFP
Puertos de canal de fibra:	1
Tecnología de cableado de fibra ethernet:	1000BASE-SX, 1000BASE‑LX
etiquetado VLAN:	Ja