Yale Easy Fit Kit 4 Manual de Usario
Yale
Sistema de alarma
Easy Fit Kit 4
Lee a continuación 📖 el manual en español para Yale Easy Fit Kit 4 (16 páginas) en la categoría Sistema de alarma. Esta guía fue útil para 11 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/16
Installation · Programming · Operating
Keep this manual safe for reference and future maintenance
Introduction Contents
Thank you for choosing this Yale EF Series Alarm System.
This simple to install system has been designed with the
user in mind.
All the components are self contained and no connections
are needed between the units. There is no need to
damage the home decor, lift carpets or run cables.
You can install up to 30 devices in this system. As well as
extra Door/Window Contacts, PIR Motion Detectors and
Smoke Detectors, you can add Key Fobs and Key Pads
for added control convenience.
There is no need to wire into the mains supply or seek
the services of a qualified electrician. All components are
powered by battery (all batteries included). Regular testing
and battery changes (when notified by the system) will
ensure reliability and peace of mind.
All components are ‘tamper’ protected. Any unauthorised
tampering with the system will result in an alarm. This
feature can be turned off by the user when a battery
change is required.
Display extreme caution when using ladders or steps,
please follow manufacturer instructions. Be careful when
using hand and power tools and follow the manufacturers’
guidelines when using them. Take care that the correct
tools are used. Wear goggles or protective clothing where
required.
The Siren is extremely loud, please ensure you replace the
cover and retreat to a safe distance before testing.
Special Notes on Compatibility:
This alarm system is NOT compatible with HSA6000
series and HSA3000 series accessories. Please note the
prefix “ ” on the front of the part number to indicate EF-
compatibility. (Note: Not compatible with accessories that
carry an ‘SR’ prefix).
Contents
1. Location planning 2
2. Unpacking the system 3
3. Programming the system 5
4. Mounting alarm devices
6
5. Using the system 8
6. Adding accessories
10
7. Changing the batteries 11
8. Troubleshooting 13
9. Specifications
15
Recommended Installation Sequence
We recommend you follow the easy start sequence,
headings numbered . 1-5
Information and illustrations are subject to change within this
document. Yale reserves the right to alter the specification and
product design at anytime without notice. Yale® is a registered
trademark. © 2016 ASSA ABLOY. All rights reserved.
smart
Living EF Series Alarms
(EF-KIT1 & EF-KIT4)
The 2 year guarantee for this Yale
EF Series Alarm Kit is active from
the date of purchase (A copy of this
guarantee is available on our website).
Please register online within
12 months of purchase at
www.yale.co.uk/registeryourproduct
2
Issue No. 1A
For more information on this product
and Yale Smart Living Range visit
www.yale.co.uk/smart-living
Consumer Support: info@yale.co.uk
2
Key Fob
Can be used outside the premises and
kept on your keyring.
Location planning
Operating range
All devices must be within 30 metres of the Siren unit and must
not be mounted on or near large metal objects. Avoid obvious
sources of electrical interference such as fridges and microwave
ovens.
Tamper switches
When mounting devices ensure that any tamper switches close
fully. On uneven surfaces it may be necessary to place packing
behind the switch for reliable operation.
1
Work out the best places to locate the devices for maximum protection. Having chosen the
locations do not mount at this stage.
Smoke Detector
• Mount in the middle of the ceiling at the top of
a stairwell, or on the centre of hallway ceilings
where smoke would most likely be detected.
• Do not mount in corners or above cooking
appliances and heaters.
• Install additional detectors if there are closed
doors preventing smoke from reaching
detectors.
External Siren (EF-KIT1 ONLY)
Choose a position on an external wall where the
Siren would be most prominent. Mount as high
as possible, out of easy reach.
Panic Button
The Panic Button provides extra protection
for you and your family. When help is
needed the button can activate your alarm
immediately - even when the system is
disarmed.
• Mount on flat wall surface
• Designed for indoor use only
• Out of reach of children
• Hidden from view while easily accessible.
Extend the system
Extend the system in the future to increase your security or as your
needs change.
For example, add extra PIR Motion Detectors in bedrooms and extra
Door/Window Contacts (30 devices in total, including Key Pad).
Yale
R
aleY
Door/Window Contact
Use one Door/Window Contact on a door
that is used as the main point of entry and
exit, usually your front door. The other
Door/Window Contact can be used to
protect another entry point such as a rear
door.
• Mount as high as possible.
• Do not aim a PIR Motion Detector at this
door or window.
aleY
1 2 3
654
7 8 9
0
aleY
Indoor Siren
(EF-KIT4 ONLY)
Choose a position on
an internal wall where
the Siren would be most
prominent. Mount as
high as possible, out of
easy reach
PIR Motion Detector
• Mount in a position such that an intruder would normally
move across a PIRs field of view.
• Height should be between 1.9 and 2 metres above floor level.
• Location in a corner will ensure wider room coverage.
• Do not mount a PIR where its field of view will be obstructed
e.g. by curtains, ornaments etc.
• Do not point directly at sources of heat e.g. fires or boilers,
and do not position directly above radiators.
• Avoid mounting a PIR directly facing a window.
• Do not point a PIR at a door protected by a Door/Window
Contact.
Key Pad Remote Control
• The Key Pad should be sited next to the main point of
entry/exit so that the system can be disarmed/armed
within 20 seconds of entering/leaving the premises.
• Ensure that the Key Pad is not visible from the outside
of the premises.
• Mount at chest height for ease of use.
• Designed for indoor use only.
3
Unpack all the parts
The easiest way to get to know the system and get it up and running quickly is to get all the
devices and accessories programmed before locating and mounting them.
2
Pull out the plastic pull tab on the back of the PIR.
This will activate the batteries.
(A red light can be seen flashing through the lens. This will last for
30 seconds indicating the component’s initiation. )
aleY
Status
LED
Learn/Test
Button Cover
screw
Pull out the plastic pull tab found on the side of
the main unit. This will activate the battery.
aleY
Learn/Test
button
LED
Gap no more
than 10mm
Magnet
Sensor
ale
Y
1 2 3
6
54
789
0
Panic button A
Panic button B
Disarm
Home Arm
LED
Learn button=
Press 8 and 9 together
/
Pull out the plastic battery saver tab at the back of
the Key Pad. This will activate the batteries.
(Button not in
use)
Tamper Switch Learn Button
Power Switch
Programming
Dip Switch
Indoor Siren (EF-KIT4 ONLY)
Siren Setup
1. Remove the cover by unscrewing
the single screw located on the lid.
2. Ensure the dip switches position
are as shown in the diagram. If the
switches are in the wrong position, please change
accordingly.
DO NOT SWITCH THE POWER SWITCH TO ON
POSITION AT THIS STAGE.
NORMAL
Dip Switches
DSW 1: Siren Reset
DSW 2: Jamming detection
DSW 3: Not in use (Supervision)
DSW 4: Siren as Master/Slave (On position only)
i
External Siren (EF-KIT1 ONLY) Door/Window Contacts
PIR Motion Detectors
Key Pad
Especificaciones del producto
| Marca: | Yale |
| Categoría: | Sistema de alarma |
| Modelo: | Easy Fit Kit 4 |
¿Necesitas ayuda?
Si necesitas ayuda con Yale Easy Fit Kit 4 haz una pregunta a continuación y otros usuarios te responderán
Sistema de alarma Yale Manuales
22 Agosto 2024
31 Julio 2024
Sistema de alarma Manuales
- Sistema de alarma IKEA
- Sistema de alarma Honeywell
- Sistema de alarma Abus
- Sistema de alarma Hikvision
- Sistema de alarma Nedis
- Sistema de alarma Pyle
- Sistema de alarma Eminent
- Sistema de alarma Vivanco
- Sistema de alarma Blaupunkt
- Sistema de alarma Ezviz
- Sistema de alarma Elro
- Sistema de alarma Dometic
- Sistema de alarma Velleman
- Sistema de alarma Smartwares
- Sistema de alarma Burg-Wachter
- Sistema de alarma Somfy
- Sistema de alarma Olympia
- Sistema de alarma Dahua Technology
- Sistema de alarma Chacon
- Sistema de alarma Konig
- Sistema de alarma Swann
- Sistema de alarma DESQ
- Sistema de alarma M-e
- Sistema de alarma FBT
- Sistema de alarma Chuango
- Sistema de alarma ORNO
- Sistema de alarma ETiger
- Sistema de alarma Redmond
- Sistema de alarma Vimar
- Sistema de alarma Schwaiger
- Sistema de alarma Woonveilig
- Sistema de alarma EVOLVEO
- Sistema de alarma Olymp
- Sistema de alarma Schabus
- Sistema de alarma Protector
- Sistema de alarma Qolsys
- Sistema de alarma Bearware
Últimos Sistema de alarma Manuales
3 Octubre 2024
2 Octubre 2024
30 Septiembre 2024
30 Septiembre 2024
30 Septiembre 2024
30 Septiembre 2024
30 Septiembre 2024
30 Septiembre 2024
30 Septiembre 2024
30 Septiembre 2024