Bellari VP549 Manual de Usario

Bellari No categorizado VP549

Lee a continuación 📖 el manual en español para Bellari VP549 (3 páginas) en la categoría No categorizado. Esta guía fue útil para 4 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF
Página 1/3
VP549 Phono Preamp
SPECIFICATIONS
I/ O Connectors: RCA, 1/8" TRS Stereo
Gain: 41.51 dB gain @ 1kHz at the "0" setting
31.64 dB of gain at the "-10" setting
45.66 dB of gain at the "+4" setting
Input Impedance: 47k ohms
Output Impedance: 32 ohms Headphone, 470 ohms RCA
Frequency Response: 3Hz to 36kHz
Equalization: RIAA +/- 1 dB, 14Hz to 23kHz
Rumble Filter: 20Hz
THD: .005% @ 1KHz
S/N Ratio: >94 dB unweighted
PWR: 15 VDC
Size: 5.5"w x 3.5"d x 1.25"h
Weight: .8 lbs
Indicator: 1 Power LED
Bellari is a division of Rolls Corporation
Salt Lake City, UT
4/18
The RIAA equalization curve was intended to operate as the
global industry standard for records since 1954. However, it
is almost impossible to say when the change actually took
place.
RIAA equalization is a form of pre-emphasis on recording
and de-emphasis on playback. A recording is made with the
low frequencies reduced and the high frequencies boosted,
and on playback the opposite occurs. The net result is a at
frequency response, but with attenuation of high frequency
noise such as hiss and clicks that arise from the recording
medium. Reducing the low frequencies also limits the ex-
cursions the cutter needs to make when cutting a groove.
Groove width is thus reduced, allowing more grooves to t
into a given surface area, permitting longer recording times.
This also reduces physical stresses on the stylus which
might otherwise cause distortion or groove damage during
playback.
A potential drawback of the system is that rumble from the
playback turntable's drive mechanism is amplied by the
low frequency boost that occurs on playback. Players must
therefore be designed to limit rumble, more so than if RIAA
equalization did not occur. Using a rumble lter to lter out
the subsonic frequencies many help mitigate the noise from
the turntable.
INPUT
OUTPUT
15 VDC
HEADPHONE/
LINE OUTPUT
+
-
VP549
MADE IN USA
www.rolls.com
Rumble
0
The Bellari VP549 is a phonograph preamplier with RIAA EQ.
- RIAA equalization is a specication for the recording and playback of
phonograph records, established by the Recording Industry Association
of America (RIAA).
Connecting the VP549: You have an input for the VP549 that connects
to your phonograph, and the output of the VP549 plugs into your pre-
amp or amplier. The ground post is where things can get complicated.
Ground hums have always plagued the turntable. We recommend using
the ground post to connect to your turntable's ground connection. In our
experience we have never seen a situation where not using the ground
would sound better than using it.
Ground loops are a very common occurrence with audio. The more
equipment you use, the higher likelihood you will have a ground loop.
The term "loop" refers to your ground generating unwanted noise from
traveling back and forth in a loop. The turntable is usually the most likely
component to have a ground issue. Another thing you can try if you
have a ground loop is connecting the turntable ground to the RCA jack's
ground if the ground post is not remedying the issue. One thing to keep
in mind is that ground loops can be anywhere in a system so try and
isolate the components that are the issue before you spend a lot of time
looking at just one component.
Cartridge load capacitance: The VP549 has three settings: 120 pF,
220 pF and 330 pF. Set the switch in the position you feel sounds best to
you. The di󰀨erence might be very slight, but it is there. Most cartridges
come with a capacitance load recommendation in the spec sheet for the
cartridge. For example the Ortofon 2M series asks for a loading of 150pF
to 300pF. Most Audio Technica cartridges state 100pF to 200pF for load-
ing. The VP549 has been tested with multiple turntables and multiple
cartridges. We have found it best to use your ears to set the loading.
You can set the loading switch to any setting 120, 220 or 330 with any
MM cartridge and no damage will be done to the VP549 or your car-
tridge. If you can not hear a di󰀨erence we would suggest that you do as
the cartridge manufacturer suggests, and set the loading switch to their
recommendation for the cartridge you are using.
Rumble lter: AKA "subsonic lter" cuts very low frequencies (below 20
Hz). The purpose of a lter like this is to get rid of annoying frequencies
that disrupt the turntable's sound quality. A good rumble/subsonic lter
should be inaudible, meaning you can not hear when it is on or o󰀨 in the
program material you are listening to. What it will do is help with exces-
sive very low frequency interruptions from the turntable to the preamp.
Trim - Gain: Control to attenuate the signal level up or down. It is not a
volume control, meaning that signal will still be present even when the
level is turned to the lowest point (in this case -10dB as labeled). If at
half way up you are at 0 dB output level then all the way up you will have
+4dB more gain, and all the way down you will be at -10dB down from
a reference of the middle 0 dB. Most users will be best served to set
the control at the middle or 0 setting to get the best outcome. This is not
always the case. In some situations you might need more gain, like when
using a quiet record or a very low level cartridge. In the opposite situa-
tion you might need less gain from a hot or loud record, or if you have a
high output cartridge. The newer cartridges made tend to have a higher
output level than in the past. For instance, the popular Ortofon 2M series
of carts have a 6mV output. This is much hotter than carts of old, as they
were around 4mV to 5mV. When using a 6mV cart you might need to
turn the trim gain control to just below the half or 0 setting. Many factors
go into setting the proper level, but we recommend start at the middle, 0
setting.
Rumble
0
INPUT
OUTPUT
15 VDC
HEADPHONE/
LINE OUTPUT
+
-
VP549
MADE IN USA
www.rolls.com
Thank you for purchasing the VP549. We spent a considerable amount
of time designing and developing the VP549. Hundreds of hours listening
and improving the design. We hope you enjoy using the VP549, and that
it makes listening to your vinyl collection rewarding. We sincerely ap-
preciate the opportunity to build a product for you and participate in your
love of quality music and sound. We love what we do and we’re happy to
help. All Bellari products are hand built in Salt Lake City, Utah by people
who care about high quality music. No surface mount parts are ever used
at Bellari.
The Bellari VP549 has excellent true sound resolution, no frequencies
are omitted. It's tone center is right in the middle of the music. It performs
very well on the extremes and never looses its solid performance when
things get loud. It never gives you the impression that it has articially
u󰀨ed up the bass or over emphasized the treble. It is well balanced and
bold, yet has a very surprising attack that will take your rig to the next
level.

Especificaciones del producto

Marca: Bellari
Categoría: No categorizado
Modelo: VP549

¿Necesitas ayuda?

Si necesitas ayuda con Bellari VP549 haz una pregunta a continuación y otros usuarios te responderán


No categorizado Bellari Manuales

Bellari

Bellari BT587 Manual de Usario

19 Septiembre 2024
Bellari

Bellari MT502 Manual de Usario

19 Septiembre 2024
Bellari

Bellari VP130 MK2 Manual de Usario

19 Septiembre 2024
Bellari

Bellari RP563 Manual de Usario

18 Septiembre 2024
Bellari

Bellari VP549 Manual de Usario

18 Septiembre 2024
Bellari

Bellari HA543 Manual de Usario

16 Septiembre 2024
Bellari

Bellari SE560 Manual de Usario

16 Septiembre 2024

No categorizado Manuales

Últimos No categorizado Manuales

POLARIS

POLARIS RZR S 1000 EPS (2018) Manual de Usario

27 Octubre 2024
Workzone

Workzone 20V Li-Ion Reciprocating Saw PT160501 Manual de Usario

27 Octubre 2024
Philips

Philips 43PUL7672 Manual de Usario

27 Octubre 2024
Manhattan

Manhattan 461504 Manual de Usario

27 Octubre 2024
Sungrow

Sungrow SG125HV Manual de Usario

27 Octubre 2024
Schneider

Schneider CCT724319 Manual de Usario

27 Octubre 2024
Technoline

Technoline WS 250 Manual de Usario

27 Octubre 2024
Livarno

Livarno IAN 354423 Manual de Usario

27 Octubre 2024
Kupper

Kupper 12152 Manual de Usario

27 Octubre 2024
JennAir

JennAir CARBON24L Manual de Usario

27 Octubre 2024