Chief CMS024 Manual de Usario
Chief
Accesorio para proyector
CMS024
Lee a continuación 📖 el manual en español para Chief CMS024 (4 páginas) en la categoría Accesorio para proyector. Esta guía fue útil para 3 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/4
1
CMS SERIES COLUMNS
Fixed and Adjustable Length Columns
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
DEFINITIONS
MOUNTING SYSTEM: A MOUNTING SYSTEM is the
primary Chief product to which an accessory and/or component
is attached.
ACCESSORY: AN ACCESSORY is the secondary Chief
product which is attached to a primary Chief product, and may
have a component attached or setting on it.
COMPONENT: A COMPONENT is an audiovisual item
designed to be attached or resting on an accessory or mounting
system such as a video camera, CPU, screen, display,
projector, etc.
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all accessories are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this accessory can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this accessory is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
accessory.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the CMS Series Extension
Column does not exceed 500 lbs (226 kg).
• The weight capacity of the CMS Series Extension
Columns may be LIMITED to the lowest weight
capacity of any other component, accessory or
mounting system used with this accessory.
WARNING: Do not use this product outdoors.
WARNING: Use this accessory only for its intended use as
described in these instructions. Do not use attachments not
recommended by the manufacturer.
WARNING: Never operate this accessory if it is damaged.
Return the accessory to a service center for examination and
repair.
NOTE: Chief CMS Series extension columns are Listed for use
with all Listed Chief ceiling plates and mounts specified
for use with 1-1/2" NPT following ANSI/ASME B1.20.1
(Schedule 40, 0.154" minimum thickness, steel or
aluminum - ASTM B221) extension columns and the
UL listed truss ceiling adapter accessory CMS380.
CMS Series extension columns are suitable for a
maximum 500 lbs (226 kg).
--SAVE THESE INSTRUCTIONS--
TOOLS REQUIRED
5/32" - security 3/16"
(included with
adjustable columns)
(included with
adjustable columns)
PARTS
[CMS adjustable length]
A (1)
[CMS fixed length]
OR
B (1)
C (1)
5/16" x 5/8"
D (1)
5/16" E (1)
5/16"
F (2)
5/16" x 1/4" H (2)
5/16" x 1/4"
(security)
G (1)
5/32"
A (1)
(security)
J (1)
3/16"
NOTE: Parts B-J are only included with adjustable length
columns.
Installation Instructions
2
FIXED LENGTH EXTENSION COLUMN
IMPORTANT ! : The following procedure assumes that
the ceiling plate/adapter (not included) has been properly
installed following instructions provided with ceiling plate/
adapter.
NOTE: Intended for use with Chief accessories and mounts.
1. Install 1-1/2" NPT threaded column (A) into plate/adapter
(See Figure 1). Securely tighten column.
• Ensure column (A) engages four full threads into
plate/adapter.
• Ensure cable access opening is rotated to desired
position (optional installation).
NOTE: Cable access opening provided on columns 9" or
longer (229mm) in length. Optional installation used
when cables must exit below plate/adapter.
Figure 1
2. Secure column (A) by tightening set screw in plate/adapter
(See Figure 1).
NOTE: Hex key and set screw provided with plate/adapter.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the CMS Series Extension
Column does not exceed 500 lbs (226 kg).
• The weight capacity of the CMS Series Extension
Columns may be LIMITED to the lowest weight
capacity of any other component or accessory used
within the mounting system.
3. Install and secure projector/display mount (not included) to
lower end of column (A) following instructions included with
mount.
ADJUSTABLE LENGTH EXTENSION
COLUMN
IMPORTANT ! : The following procedure assumes that
the ceiling plate/adapter (not included) has been properly
installed following instructions provided with ceiling plate/
adapter.
NOTE: Intended for use with Chief accessories and mounts.
1. Install 1-1/2" NPT threaded column (A or B, as applicable)
into plate/adapter (See Figure 2). Securely tighten column.
• Ensure column (A or B, as applicable) engages four full
threads into plate/adapter.
• Ensure cable access opening is rotated to desired
position (optional installation, column (A)).
NOTE: Cable access opening provided on columns 9" or
longer (229mm) in length. Optional installation used
when cables must exit below plate/adapter.
Figure 2
2. Secure column (A or B, as applicable) by tightening set
screw in plate/adapter (See Figure 2).
NOTE: Hex key and set screw provided with plate/adapter.
3. Install mating column (A or B, as applicable) (See Figure 2).
1
4 x
2
A
1
4 x
2
1
4 x
B
BA
A
33
1
4 x
Installation Instructions
3
4. Using key (J), loosely install screw (C) through lock washer
(D), flat washer (E), and outer column (B) into adjustment
hole in inner column (A) (See Figure 3).
NOTE: Two adjustment holes provided in columns 6" or longer
(152mm) in length. Either adjustment hole can be used
to provide 1" (25mm) adjustment increments.
NOTE: Optional installation similar; not shown.
Figure 3
5. Adjust column (A or B, as applicable) to desired length, then
rotate and lock into position (See Figure 3).
NOTE: Any locking slot can be used to provide 2" (51mm)
adjustment increments.
6. Tighten screw (C) using key (J) (See Figure 3).
7. Install and tighten set screws (standard (F) or security (H),
as desired) using key (G) (See Figure 4).
NOTE: Optional installation similar; not shown.
Figure 4
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the CMS Series Extension
Column does not exceed 500 lbs (226 kg).
• The weight capacity of the CMS Series Extension
Columns may be LIMITED to the lowest weight
capacity of any other component, accessory or
mounting system used with this accessory.
8. Install and secure projector/display mount (not included) to
lower end of column (A or B, as applicable) following
instructions included with mount.
46
5
CDE
B
A
7
F x 2
H x 2
Especificaciones del producto
| Marca: | Chief |
| Categoría: | Accesorio para proyector |
| Modelo: | CMS024 |
¿Necesitas ayuda?
Si necesitas ayuda con Chief CMS024 haz una pregunta a continuación y otros usuarios te responderán
Accesorio para proyector Chief Manuales
12 Septiembre 2024
2 Septiembre 2024
2 Septiembre 2024
2 Septiembre 2024
2 Septiembre 2024
2 Septiembre 2024
2 Septiembre 2024
2 Septiembre 2024
2 Septiembre 2024
2 Septiembre 2024
Accesorio para proyector Manuales
- Accesorio para proyector Sony
- Accesorio para proyector Casio
- Accesorio para proyector Panasonic
- Accesorio para proyector BenQ
- Accesorio para proyector Optoma
- Accesorio para proyector Vision
- Accesorio para proyector Sanyo
- Accesorio para proyector Nec
- Accesorio para proyector Da-Lite
- Accesorio para proyector AV:link
- Accesorio para proyector Barco
- Accesorio para proyector Vogels
- Accesorio para proyector InFocus
- Accesorio para proyector Auna
- Accesorio para proyector Viewsonic
- Accesorio para proyector Newstar
- Accesorio para proyector Projecta
- Accesorio para proyector Peerless
- Accesorio para proyector Chipolino
- Accesorio para proyector Gabor
- Accesorio para proyector Konig & Meyer
- Accesorio para proyector Speaka
- Accesorio para proyector Tempest
- Accesorio para proyector Gravity
- Accesorio para proyector Kanto
- Accesorio para proyector V7
- Accesorio para proyector Unicol
- Accesorio para proyector Roadinger
- Accesorio para proyector My Wall
- Accesorio para proyector Smart Media
Últimos Accesorio para proyector Manuales
18 Octubre 2024
27 Septiembre 2024
22 Septiembre 2024
17 Septiembre 2024
17 Septiembre 2024
17 Septiembre 2024
17 Septiembre 2024
17 Septiembre 2024
17 Septiembre 2024
17 Septiembre 2024