Chief HB026S Manual de Usario

Lee a continuación 📖 el manual en español para Chief HB026S (1 páginas) en la categoría Accesorio para proyector. Esta guía fue útil para 10 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/1
HB-026S
V P C M IDEO ROJECTOR EILING OUNT
FOR SIM 2 HT-500 LINK
The Chief HB-026S video projector ceiling mount is designed to provide fast, simple and secure installation of the
SIM 2 HT-500 LINK, Special roll, pitch, yaw and horizontal adjustments simplify projection positioning for image
alignment. The HB-026S mount also has positive registration lock so that the projector may be removed without
losing projector mount registration.
WARNING: IMPROPER INSTALLATION MAY RESULT IN SERIOUS PERSONAL
INJURY! All components must be securely fastened to each other and to the ceiling, AND
the ceiling MUST be capable of supporting 5 times the total weight of the installation. If it
cannot, the ceiling MUST be reinforced.
Unpack and check contents:
(1) Deluxe ceiling mount housing assembly. (6) M6 Washers, flat
(1) SIM 2 mounting bracket (6) M6 x 10mm Screws, PH, Phillips
(4) 5/16” Flange Nuts
INSTALLATION INSTRUCTIONS
1. Turn your projector upside down.
2. Place the SIM 2 mounting bracket on the bottom of the projector so the hooks are facing the back and the six
holes in the bracket line up with the six threaded inserts in the bottom of the projector.
3. Slide the (6) M6 washers on the (6) M6 x 10mm Screws and install them into the six threaded inserts in the
projector. Securely tighten all six mounting screws at this time.
4. Be sure that the method of support you are using for the VCM ceiling mount is securely installed to the
ceiling. If not, the ceiling must be reinforced. Improper installation may result in serious personal injury.
5. Attach the VCM housing to your method of support and tighten firmly so the VCM housing is square to the
screen.
PRECAUTION: Installing a ceiling mount requires the presence of two persons familiar with
mechanical installations. A third assistant is recommended for hanging the projector if it weighs over 75
Lbs.
6. With the help of your assistants, lift the projector and install it to the four studs extending from the mounting
plate. Be sure the SIM 2 mounting plate is seated in slots. Tighten securely using the (4) 5/16” flange nuts.
For projector alignment see attached sheet.Error! No index entries found.
8803-000043 05/05/04
CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: 1-877-894-6918, Email: chief@chiefmfg.com

Especificaciones del producto

Marca: Chief
Categoría: Accesorio para proyector
Modelo: HB026S

¿Necesitas ayuda?

Si necesitas ayuda con Chief HB026S haz una pregunta a continuación y otros usuarios te responderán




Accesorio para proyector Chief Manuales

Accesorio para proyector Manuales

Últimos Accesorio para proyector Manuales