DESQ 2008 Manual de Usario
Lee a continuación 📖 el manual en español para DESQ 2008 (8 páginas) en la categoría detector de movimiento. Esta guía fue útil para 11 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/8
OPERATING INSTRUCTIONS
MOTION ALARM
MODEL 2008
®
ENG
NL
FR
DU
ESP
Type Motion alarm
Alarm Built – in 110 db alarm or pleasant announcement chime
Battery 1 x 9 Volt battery (alkaline battery recommended)
CAUTION: This alarm is extremely loud. For your safety, never
place the unit close to your ears. To test the alarm, direct the unit
away from you at arms length and activate.
9 Meter
9 Meter
Figure 2 Figure 3 Figure 4 Figure 5
DESQ International:
Gildeweg 18 - 3771 NB – Barneveld
The Netherlands
Phone +31 (0)342-425350 - Fax +31 (0)342-425351
E-mail all@desq.nl - Internet www.desq.eu
Service Department:
NL: Phone +31 (0)342-425352.
SPAIN: Ofiactiva S.L. - Phone +34 935441884
ENG
INTRODUCTION
The DESQ motion alarm 2008 provides detection of unwanted intruders in your (home) office. The latest infrared tech-
nology is used to detect any movement within the protected area. It can provide valuable protection if used properly.
However, this unit cannot guarantee complete protection against burglary or robbery. Therefore, DESQ Interna-
tional will not be held responsible for any loss or damage which could occur. In order to use this product correctly,
read these instructions carefully. Please keep instructions for future reference.
IMPORTANT SAFETY TIPS
1) Read all installation and operating instructions
2) Avoid dropping or rough handling
3) Be careful not to damage the plastic lens
4) Do not install alarm where it will be exposed to direct sunlight or rain
5) The alarm siren is very loud, never put the unit close to your ear. To test the alarm, direct the unit away from
you at arms length and activate.
6) This unit should be directed away from heat sources, such as radiators, heating ducts and stoves
7) Be aware, pets can trigger the motion alarm, as well as movement detected through a window
8) If the unit goes off at random, it is possible the unit is located too close to a heat source. Changing the location
or direction of the unit can remedy this
9) People and/or automobiles may be detected if they are close to a window and within range of the unit.
SELECTING THE MOUNTING LOCATION
Important: before mounting and testing this unit, be sure to read the “important safety tips” section at the
beginning of this manual. For best coverage, the unit should be placed in a corner located between 1 & 2
meters above the floor. The area of coverage by the unit is 20 degrees vertically (see figure 4) and 110 degrees
horizontally (see figure 5) with a range of approximately 9 meters from the unit. Before installing the mounting
screws, you may want to test the location you have selected.
TESTING
After selecting a location for installation of the unit, the DESQ 2008 motion alarm will allow you to perform a
“walk test” to determine the area which is being protected by the unit.
1) Test the area of detection (figure 4 and 5). Slide the function switch to the alarm position. The unit is now in
the “walk test” mode.
2) Begin walking in front of the unit, the LED indicator will now blink on and off as you walk within the detection
area. If you walk beyond the detection range, the LED will go out and remain off. If you walk back into the
detection area the LED indicator will illuminate.
3) After testing the detection area, leave the room. Wait for at least 2 minutes and go back into the room. If the
LED indicator does not go on, you have been detected as an intruder. The alarm siren will sound approximately
60 seconds. If the LED indicator goes on again, you have not waited long enough and the unit is still in the “walk
test” mode.
4) Slide the switch to OFF position, the unit is now disarmed and testing is completed.
5) Using the template provided (figure 6), mark location of holes and install anchors and screws (do not screw
all the way in). Place the unit over the screws and slide the unit down to secure in place.
OPERATION
The DESQ 2008 motion alarm provides 2 different modes of operation: alarm (110 db) and chime. A slide switch
is located on the side of the unit to select which mode is active.
ALARM MODE
1) To arm the unit, slide the switch to the “alarm” position. The unit will automatically arm itself after no motion
has been detected for approximately 2 minutes.
2) To disarm the unit, slide the switch to OFF position, you have approximately 5-10 seconds to slide the switch
to OFF position before the alarm sounds once you have entered the detection area.
CHIME MODE
1) To change the unit to the chime mode, simply slide the switch to “chime” position.
2) The chime mode sounds a pleasant “ding-dong” sound when any motion is detected within the detected zone.
The chime will sound for 3 times, then shut-off and automatically resets itself.
LOW BATTERY INDICATOR
The LED indicator light located on the front of the unit will light up when the battery becomes low. It will stay on
until the battery is replaced (9 Volt).
2008
Especificaciones del producto
Marca: | DESQ |
Categoría: | detector de movimiento |
Modelo: | 2008 |
¿Necesitas ayuda?
Si necesitas ayuda con DESQ 2008 haz una pregunta a continuación y otros usuarios te responderán
detector de movimiento DESQ Manuales
6 Septiembre 2024
detector de movimiento Manuales
- detector de movimiento Gigaset
- detector de movimiento Nedis
- detector de movimiento Yale
- detector de movimiento Renkforce
- detector de movimiento Optex
- detector de movimiento Schneider
- detector de movimiento Axis
- detector de movimiento Theben
- detector de movimiento Chamberlain
- detector de movimiento Velleman
- detector de movimiento Smartwares
- detector de movimiento Perel
- detector de movimiento Steinel
- detector de movimiento ESYLUX
- detector de movimiento Dahua Technology
- detector de movimiento Arlo
- detector de movimiento Grothe
- detector de movimiento Hager
- detector de movimiento Busch-Jaeger
- detector de movimiento Xavax
- detector de movimiento Marmitek
- detector de movimiento Niko
- detector de movimiento Jung
- detector de movimiento DSC
- detector de movimiento HQ
- detector de movimiento Fibaro
- detector de movimiento Satel
- detector de movimiento Wentronic
- detector de movimiento EQ3
- detector de movimiento Homematic IP
- detector de movimiento Vernier
- detector de movimiento Chuango
- detector de movimiento ORNO
- detector de movimiento Berker
- detector de movimiento Extron
- detector de movimiento Maxsa
- detector de movimiento Kopp
- detector de movimiento Vimar
- detector de movimiento Kogan
- detector de movimiento XQ-Lite
- detector de movimiento Legrand
- detector de movimiento Elgato
- detector de movimiento Intertechno
- detector de movimiento Schwaiger
- detector de movimiento Inovonics
- detector de movimiento V-Tac
- detector de movimiento Suevia
- detector de movimiento Pentatech
- detector de movimiento Joy-it
- detector de movimiento Megatron
- detector de movimiento Ledvance
- detector de movimiento Gewiss
- detector de movimiento ALC
- detector de movimiento Avigilon
- detector de movimiento GEV
- detector de movimiento Pepperl+Fuchs
Últimos detector de movimiento Manuales
19 Septiembre 2024
19 Septiembre 2024
19 Septiembre 2024
19 Septiembre 2024
19 Septiembre 2024
19 Septiembre 2024
18 Septiembre 2024
18 Septiembre 2024
18 Septiembre 2024
18 Septiembre 2024