Electro-Voice ND44 Manual de Usario

Electro-Voice micrófono ND44

Lee a continuación 📖 el manual en español para Electro-Voice ND44 (4 páginas) en la categoría micrófono. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF
Página 1/4
Electro-Voice | ND44
ND44
▪Excellent acoustic control with aggressive and
punctuated sound
▪Large diaphragm dynamic capsule creates a rich and
detailed frequency response
▪Easy mic placement with low-profile pivoting head
▪Humbucking coil guards against line hum
▪Memraflex grille resists denting
The Electro-Voice ND44 is a robust, high-performance
dynamic instrument microphone with a tight cardioid
polar pattern.
Designed for excellent performance on drums and
other rhythm section instruments, the ND44 capsule is
precisely tuned to deliver the aggressive and
punctuated sound these instruments produce, as well
as excellent isolation from the sound of other nearby
instruments.
The ND44 dynamic capsule contains a large Mylar
diaphragm which delivers a rich and detailed
frequency response by combining its large surface
area for tonal balance with its low-mass high-velocity
material for exceptionally fast transient response.
The ND44 low profile pivoting head makes mic
placement around a drum set easy. The included
DRC-2 drum rim clamp is simple to use and eliminates
the need for an additional mic stand.
The ND44 capsule uses a humbucking coil that
attenuates AC hum and electromagnetic interference.
ND dynamic mics can be used with confidence near
speaker cabinets and EMF generating equipment
racks.
The ND44 Memraflex grille is made of a durable tight-
mesh grille wire that withstands extraordinarily-rough
treatment. Your microphone remains protected and
looking good gig-after-gig, year-after-year.
For additional protection, the ND44 capsule contains a
hydrophobic cloth membrane which prevents moisture
and debris from reaching the diaphragm.
ND44 is also designed to function very well as a guitar
cabinet mic. It can be stand-mounted using the
optional SAND-1 stand adapter on a mic stand, or
merely hung over the speaker cabinet with the grille
facing the speaker cone using its mic cable to suspend
it.
Technical specifications
Element Type: Dynamic neodymium magnet structure
Frequency Response, Free
Field:
80Hz to 16.5kHz
Polar Pattern: Tight Cardioid
Sensitivity, Open Circuit
Voltage @ 1 kHz::
2.4 mV/Pascal
Maximum SPL: > 140 dB SPL
Polarity: Pin 2 positive, reference to pin 3 with
positive pressure on diaphragm
Impedance: 350 ohms balanced (low-z)
Microphone Connector: 3-pin, XLR-type
Finish: Black polyurethane paint
Material: Zinc die cast handle, ABS-
Polycarbonate Head, Memraflex grille
screen
Dimensions, Head:
Length:
Shank:
1.91 in (48.5 mm) Dia. X 1.94 in
(49.22 mm) Long
5.47 in (139 mm)
0.83 in (21 mm)
Net Weight: 6.85 oz (194 g)
Shipping Weight: 17.2 oz (488 g)
Accessories Included: (1) DRC-2 Drum Rim Clamp, (1) Gig
bag
Frequency Response:
-10
20 50
0 dB
+10
500
FREQUENCY IN HERTZ
100 1K 5K 10K 20K
1 m
2.5 cm
5 cm
Polar Response:
Dimensions:
System overview
Mounting the DRC-2 drum rim clamp to a drum rim:
This method can be used with or without the ND
Series microphone mounted in the clip (1).
To , do
mount the DRC-2 drum rim clamp to a drum rim
mount the DRC-2 drum rim clamp to a drum rim
mount the DRC-2 drum rim clamp to a drum rim
mount the DRC-2 drum rim clamp to a drum rimmount the DRC-2 drum rim clamp to a drum rim
the following:
1. Grip the DRC-2 firmly by placing your index finger in
the finger loop (2).
2. Choose a notch (3) at the top of the DRC-2 jaw and
place it to the drum rim so the top edge of the rim
fits inside the desired notch.
3. Using the finger you placed through the finger loop
(2), pull downwards and allow the edge of the
bottom DRC-2 jaw (4) to latch to the bottom edge of
the drum rim.
4. Using the thumbscrew (5), tension can be adjusted
on the pivoting joint as desired.
Microphone Use and Placement:
Please note that micing techniques are a matter of
personal preference. These are merely guidelines to
assist in the placement of the microphone to gain
optimal performance.
Usage
Usage
Usage
UsageUsage Optimal Placement
Optimal Placement
Optimal Placement
Optimal PlacementOptimal Placement
Tom-Toms On double headed Toms, place mic over the top of
drum 1-3" and at a 45° angle to the drumhead surface
and 1-2" in from the drum edge. On single headed
Toms, use above method or place mic inside Tom from
underneath at a 90° angle from the center of head,
3-5" away.
Snare Drum Place mic 1-3" above the heads, 1-2" in from the rim.
Aim each mic at the top heads angled down about 45°.
If the drum rings, tape deadening material to the head
or use damping rings. For more “snare” sound place a
2nd mic underneath aimed up at the bottom of head.
Electric
Guitar and
Bass Guitar
Amplifier
Place microphone approximately 1-2" from and at a
90°degree angle to the speaker cone. To reduce
boominess, move the microphone off axis to the cone
from 90° to 45°, or move mic from center of cone to
either edge.
Cymbals Place microphone one to two feet above the cymbals.
High-Hat Place 4-5” above outside edge at a 45° down angle.
2 | ND44
Brass 6-24" away, and on axis with the bell of the
instrument.
Acoustic
Guitar
Place mic 6-12" from where neck joins the body.
Standard Placement and Use Guidelines:
1. Always point the microphone at the desired source of
sound and away from any unwanted sources.
2. The microphone should be located close to the sound
source to minimize interference from other potential
sound sources.
3. Use the 3-to-1 rule when using multiple microphones.
Place each microphone three times farther from other
microphones as from the desired source.
4. Minimize over-handling of the microphone to reduce
unwanted mechanical noise.
5. Working close to the microphone will increase the
bass tone and also provide increased gain-before-
feedback.
Parts included
Qty. Item
1 Microphone
1 Gig bag
1 DRC-2 drum rim clamp
1 Engineering data sheet
1 Warranty and Product Documentation Information card
Ordering information
ND44
Dynamic tight cardioid instrument microphone, black
Order number ND44
DRC-2
Drum rim clamp, black
Order number DRC-2
ND44GRILLE
Replacement end grille, black
Order number ND44GRILLE
Accessories
SAND-1
Stand adapter, black
Order number SAND-1
3 | ND44

Especificaciones del producto

Marca: Electro-Voice
Categoría: micrófono
Modelo: ND44

¿Necesitas ayuda?

Si necesitas ayuda con Electro-Voice ND44 haz una pregunta a continuación y otros usuarios te responderán


micrófono Electro-Voice Manuales

Electro-Voice

Electro-Voice PL80c Manual de Usario

18 Septiembre 2024
Electro-Voice

Electro-Voice ND44 Manual de Usario

12 Septiembre 2024
Electro-Voice

Electro-Voice ND76S Manual de Usario

13 Agosto 2024
Electro-Voice

Electro-Voice ND96 Manual de Usario

13 Agosto 2024
Electro-Voice

Electro-Voice RE97LTX Manual de Usario

11 Agosto 2024
Electro-Voice

Electro-Voice PL80a Manual de Usario

6 Agosto 2024
Electro-Voice

Electro-Voice RE27N/D Manual de Usario

27 Julio 2024
Electro-Voice

Electro-Voice RE20 Manual de Usario

26 Julio 2024
Electro-Voice

Electro-Voice RE320 Manual de Usario

23 Julio 2024

micrófono Manuales

Últimos micrófono Manuales

Shure

Shure SBC210LM Manual de Usario

25 Octubre 2024
Akg

Akg GN50 M Manual de Usario

25 Octubre 2024
Countryman

Countryman B6 Manual de Usario

19 Octubre 2024
Pyle

Pyle PMKSHUSB04 Manual de Usario

19 Octubre 2024
Trust

Trust 21670 Manual de Usario

18 Octubre 2024
Neumann

Neumann U 87 Ai Manual de Usario

18 Octubre 2024
BOYA

BOYA BY-PM700 Manual de Usario

18 Octubre 2024
Audio-Technica

Audio-Technica BP892xCW Manual de Usario

17 Octubre 2024
Audio-Technica

Audio-Technica BP4073 Manual de Usario

15 Octubre 2024
Power Dynamics

Power Dynamics PD524 Manual de Usario

15 Octubre 2024