Elite ProAV Evanesce Tab-Tension Manual de Usario
Elite ProAV
pantalla de proyección
Evanesce Tab-Tension
Lee a continuación 📖 el manual en español para Elite ProAV Evanesce Tab-Tension (9 páginas) en la categoría pantalla de proyección. Esta guía fue útil para 4 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/9
Rev. 072019JA 1 03 www.eliteproav.com
Evanesce Tab-Tension CineGrey 5D®
Recessed -ceiling Ambient Light Rejecting Projector ScreenIn
Installation Guide
The screen material included is our CineGrey 5D® which is a front projection material, award winning
precisely formulated for environments with minimal control over room lighting. It was designed to enhance
picture brightness oer accurate color delity improve contrast levels, , and . The is best for CineGrey 5D™
family rooms, educational facilities, conference rooms, house of worship or any applications in which incident
light is a factor.
In order for the CineGrey 5D® to maintain its projection qualities and optimum performance please refer to
the list below for proper maintenance and cleaning.
• Use a dry microfiber cloth to remove dust from the screen’s surface.
• When cleaning, use a damp microber cloth with warm water to remove any marks.
• Never rub or apply pressure when cleaning the surface.
• Never attempt to use any solutions, chemicals or abrasive cleaners on the screen surface.
• In order to avoid damaging the screen, avoid touching it directly with your ngers, pens/pencils or
any other sharp or abrasive objects.
Important Safety & Warning Precautions
Make sure to read this user’s guide and follow the procedures below.
Caution: The screen’s Black Top Drop is already set to its maximum drop distance. There is NO extra Black
Top Drop in the roller Unapproved changes or modications (except for cutting the power cord for hardwire .
installations) to this unit are prohibited and will void your warranty. For more information, please contact our
Technical Support Department at (877) 511-1211 Ext. 604.
• Please retain this user’s guide for future reference.
• To avoid damaging the unit, do not use with any unauthorized accessories not recommended by the
manufacturer.
• Handle the unit carefully during transportation to avoid any damages.
• To ensure safe and reliable operation, direct connection to a properly grounded power source is
advised.
• The power outlet supplying power to the unit should be close to the unit and easily accessible.
• Do not install the unit on uneven, inclined surfaces;
• Do not install in damp places to avoid an electric shock or short circuit.
• Do not place any heavy objects over the power cord.
• Position the power cord properly to avoid creating a trip obstacle.
• The internal & external parts of this unit are not end user serviceable. Do not attempt to disassemble
this unit by yourself. No one except authorized technicians can open and make repairs to this unit.
• Make sure the power source that this unit is connected to has a continuous power ow.
Rev. 072019JA 2 03 www.eliteproav.com
• If there is need to use an extension cord, make sure the cord has an equal rating as the appliance to
avoid over heat.
• Do not handle the power plug when your hands are wet or your feet are in contact with water.
• Properly dispose of this equipment according to the environmental regulations in your area when
product is no longer of service.
Do not use this unit under the following circumstances.
• Disconnect the power cord under the conditions of heavy rain, wind thunder or lightning.
• Avoid direct sun light, rain shower and moisture.
• Keep away from re sources and high temperature to prevent this device from overheating.
• Cut o the power supply rst before transportation or maintenance.
• To avoid possible injury and/or an electric shock, do not attempt to use this screen if there is obvious
damage or if there are any evident broken parts.
Installation Warning
The instructions provided in this user’s guide are for reference only. Please consult a professional
installation company for further installation and safety advice. The installer must insure that proper
mounting hardware is used to provide adequate strength suitable for the installation. Elite Screens is
not liable for any faulty installations. For limit adjustment instructions, please contact our Technical
Support Department at (877) 511-1211 Ext. 604
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that the interference will not occur on a particular installation. If this equipment
causes harmful interference to radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more of the following measures.
✓ Reorient or relocate the receiving antenna of the device which may be casing the interference.
✓ Increase the separation between the screen and the device’s receiver.
✓ Connect the equipment into a dierent power outlet other than the device.
Pre-Installation
1. Carefully unpack the screen.
2. Always handle the screen in a leveled position on a clean surface.
3. In order to protect the screen from exposure to stains, keep the screen out of contact with foreign
particles such as dust, sawdust, and/or liquids.
ATTENTION: Regardless of the mounting method, the screen should be securely supported so that the
vibration or pulling on the viewing surface will not cause the casing to become loose or fall. The installer must
insure the fasteners that are used are of adequate strength and suitable for the installation location.
Rev. 072019JA 3 03 www.eliteproav.com
Evanesce Tab-Tension Series | Controls and Accessories
A. IR
Remote
B. RF
Remote
C. Wall
switch
control box
D. 5-12 volt
trigger
cable
E. IR
extended
“eye” receiver
F. Wireless 5-
12v (3.5 mm)
mono trigger
cable
G. AAA
batteries
H. Bubble leveler
Screen operation
Electric Current: The screen operates on AC110V at 60Hz/ 1.18A
1.After ensuring the power outlet & screen are compatible (voltage), plug the power cord into the power outlet.
2. Once the screen has power, you’ll be able to control it using any of the 6 methods described below.
6 ways to control the Evanesce Tab-Tension
1. IR remote control ( ): The Infrared functions by direct line of sight Item A, Fig 1
contact with a beam range of 30 feet. Aim the IR remote at the “eye” receiver once it
has been connected to the control box’s RJ45 port.
2. IR “Eye” Receiver (Item E, Fig 2): The IR “Eye” Receiver plugs directly into the
control box’s RJ45 port to present a low prole line-of-sight control option for your
IR remote control even in a recessed ceiling installation.
3. RF Remote Control ( ): The radio waves eliminate the need for a direct line Item B
of sight with a range of 100 feet.
4. 3-Way Wall Switch (Item C, Fig 3): The 3-way wall switch is a wall mount switch
with an up/stop/down button and plugs directly into the control box’s RJ45 port.
5. 5-12 volt trigger (Item D, Fig 4): The built-in 5-12V trigger
input allows your screen to synchronize its drop & rise with the
projector’s power cycle. The screen deploys when the projector
powers up and will retract when the projector powers down. The
5-12 volt RJ45 cable connects to your projector’s trigger output
via a separate cable that may or may not be provided by the
manufacturer of the projector. The trigger feature will not work
without an output cable from the projector, but it can be tested
by connecting the Red (+) and Green (-) cable to a 9-volt battery.
UP
STOP
DOWN
Fig.1
IR/RF remote
Especificaciones del producto
| Marca: | Elite ProAV |
| Categoría: | pantalla de proyección |
| Modelo: | Evanesce Tab-Tension |
¿Necesitas ayuda?
Si necesitas ayuda con Elite ProAV Evanesce Tab-Tension haz una pregunta a continuación y otros usuarios te responderán
pantalla de proyección Elite ProAV Manuales
15 Septiembre 2024
15 Septiembre 2024
15 Septiembre 2024
15 Septiembre 2024
pantalla de proyección Manuales
- pantalla de proyección Draper
- pantalla de proyección Pyle
- pantalla de proyección Kodak
- pantalla de proyección Optoma
- pantalla de proyección Nec
- pantalla de proyección Da-Lite
- pantalla de proyección Luxburg
- pantalla de proyección Duronic
- pantalla de proyección EluneVision
- pantalla de proyección Celexon
- pantalla de proyección Stewart
- pantalla de proyección Avers
- pantalla de proyección Instaal
- pantalla de proyección KHOMO GEAR
- pantalla de proyección EPV
Últimos pantalla de proyección Manuales
11 Octubre 2024
6 Octubre 2024
2 Octubre 2024
29 Septiembre 2024
29 Septiembre 2024
27 Septiembre 2024
26 Septiembre 2024
22 Septiembre 2024
20 Septiembre 2024
18 Septiembre 2024