Extron WPB 109 Manual de Usario
Extron
Toma de corriente
WPB 109
Lee a continuación 📖 el manual en español para Extron WPB 109 (2 páginas) en la categoría Toma de corriente. Esta guía fue útil para 6 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/2
IMPORTANT:
Go to www.extron.com for the
complete user guide, installation
instructions, and specifications.
WPB 109 Wallplate • Installation Guide
The Extron WPB 109 wallplate is a single gang
pass-through wallplate with audio, VGA, and HDMI
connectors and 10-inch pigtails. It can be installed in
the supplied single gang mud ring or a junction box.
Install the wallplate directly into the wall using the
supplied mud ring or a UL-approved 1-gang junction
box (not supplied). Follow the steps in the “Installation”
section.
Planning - Check the Proposed Installation Location
Before starting the installation t is important that you do the following i :
WARNING: Failure to check these items may result in property damage, personal injury,
or both.
c Ensure there are no utility cables or pipes at the intended location that might be damaged
or cause injury when you are installing the device.
c Check that the installation meets the local and state regulatory requirements, including
building, electrical, and safety codes, and UL and ADA accessibility requirements.
During installation ensure the space behind the device is sufficient for the bend radius of the
pigtail. The recommended minimum bend radius is 2.4 inches.
WPB 109
HDMI
COMPUT ER
AUDIO
Front Side
Extron
WPB 109
Wall Mounting
Bracket
Locking Arms
WPB 109
HDMI
COMPUTER
AUDIO
Installation
1. Using the supplied mud ring or a junction box (not included) as a guide, mark and cut out
the appropriate material within the marked area.
2. Either:
zInsert the mud ring into the opening, rotate the
locking arms, and secure it with the supplied screws
(as shown at right), or
zInsert the junction box and secure it with nails or
screws.
3. Run the cables (video, audio, and HDMI) from the output
or input device locations (as applicable), behind the wall,
and to the WPB location, then thread the cables through
the mud ring or junction box.
4. Video — Insert the HDMI and VGA cable connector into
the appropriate connector on the pigtail.
NOTE: If using a DVI display with the WPB 109, connect a HDMIM-DVIDF adapter (part
number 26-617-01) and a separate audio cable.
5. Audio — Secure the output audio cable into the 3-pole captive screw connector. Wire as
described in “Cable Preparation for Audio Connections” on page 2.
NOTE: This may be easier to do before attaching the device to the mud ring.
6. Mount the cabled device into either the mud ring or the junction box.
CONTINUED ON SIDE 2
1
WPB 109 Wallplate • Installation Guide (Continued)
Extron Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
Extron Asia
+65.6383.4400
Extron China
+86.21.3760.1568)
Extron Korea
+82.2.3444.1571
Extron Europe
+31.33.453.4040
Extron Japan
+81.3.3511.7655
Extron Middle East
+971.4.299.1800
Extron India
+91.80.3055.3777
© 2013 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners. www.extron.com
68-1162-50
Rev. A 01 13
Tip
Sleeve(s)
Ring
Ring
Tip
Tip
Sleeve
Sleeve
Tip
Unbalanced Input
TRS Connector
RCA Connector
Left
Right
Left
Right
Balanced Input or Output
Balanced Mono Audio
Unbalanced Stereo Audio
Balanced Audio
Wiring
Unbalanced Audio
Wiring
Source
Reference
Tip
Sleeve
Ring
Tip
Sleeve
Direct Insertion
Captive Screw
Unbalanced Output
Left
Tip
Sleeve(s)
NO Ground Here
NO Ground Here
Tip Right
CAUTION
For unbalanced audio, connect the
sleeve(s) to the ground contact.
DO NOT connect the sleeve(s) to the
negative (-) contacts.
Tip
Sleeve
NO Ground Here
Ring (R)
Ring
Tip (T)
Tip
Tip
Tip
Sleeve (S)
Ring (R) = Right Channel
Tip (T) = Left Channel
Sleeve (S)
(input or output)
(input or output)
Sleeve
Sleeve
Sleeve (S)
Ring (R)
Tip (T)
3.5 mm Audio Jack
TRS
Heat
Shrink 1/8"
(3 mm)
7/8"
(22 mm)
3/16" (5 mm) Max.
Cable Preparation For Audio Connections
The length of the exposed wires in the stripping process is critical.
The ideal length is . 3/16" (5 mm)
• If the stripped section of wire is longer than , the exposed 3/16"
wires may touch, causing a short circuit between them.
• If the stripped section of wire is shorter than , the wires can 3/16"
be easily pulled out even if tightly fastened by the captive screws.
Do not tin the wires!
Tinned wire does not hold its shape and can become
loose over time.
NOTE: Audio ground pins may be labeled as
or . The wiring and function are the same,
whichever way your product is labeled.
7. Connect the appropriate input or output devices to the front panel connectors.
8. Test the system and resolve any cabling or signal issues.
2
Especificaciones del producto
| Marca: | Extron |
| Categoría: | Toma de corriente |
| Modelo: | WPB 109 |
¿Necesitas ayuda?
Si necesitas ayuda con Extron WPB 109 haz una pregunta a continuación y otros usuarios te responderán
Toma de corriente Extron Manuales
26 Septiembre 2024
26 Septiembre 2024
18 Septiembre 2024
18 Septiembre 2024
18 Septiembre 2024
18 Septiembre 2024
18 Septiembre 2024
Toma de corriente Manuales
- Toma de corriente IKEA
- Toma de corriente Philips
- Toma de corriente Apc
- Toma de corriente Brennenstuhl
- Toma de corriente Asus
- Toma de corriente Manhattan
- Toma de corriente EMOS
- Toma de corriente Hazet
- Toma de corriente Hama
- Toma de corriente Gigabyte
- Toma de corriente Bose
- Toma de corriente Digitus
- Toma de corriente Kathrein
- Toma de corriente AS - Schwabe
- Toma de corriente Hager
- Toma de corriente Gamma
- Toma de corriente Reer
- Toma de corriente Busch-Jaeger
- Toma de corriente Jung
- Toma de corriente CyberPower
- Toma de corriente Showtec
- Toma de corriente Peerless
- Toma de corriente ECS
- Toma de corriente Homematic IP
- Toma de corriente Lanberg
- Toma de corriente Crestron
- Toma de corriente ORNO
- Toma de corriente Berker
- Toma de corriente PCE
- Toma de corriente Logilink
- Toma de corriente Ebode
- Toma de corriente InterBar
- Toma de corriente Kopp
- Toma de corriente Vimar
- Toma de corriente Kogan
- Toma de corriente Lenoxx
- Toma de corriente Legrand
- Toma de corriente Panduit
- Toma de corriente Savio
- Toma de corriente Schwaiger
- Toma de corriente V-Tac
- Toma de corriente Kramer
- Toma de corriente InLine
- Toma de corriente Phoenix Contact
- Toma de corriente Bachmann
- Toma de corriente Metz Connect
- Toma de corriente Leviton
- Toma de corriente Neutrik
- Toma de corriente Omnilux
- Toma de corriente Heitronic
- Toma de corriente Hoopzi
- Toma de corriente Adam Hall
- Toma de corriente Biostar
- Toma de corriente 360 Electrical
- Toma de corriente PS Audio
- Toma de corriente Bearware
- Toma de corriente PureLink
Últimos Toma de corriente Manuales
25 Octubre 2024
15 Octubre 2024
15 Octubre 2024
15 Octubre 2024
15 Octubre 2024
15 Octubre 2024
15 Octubre 2024
6 Octubre 2024
1 Octubre 2024
1 Octubre 2024