Extron WPC 210 A MK Manual de Usario

Extron Toma de corriente WPC 210 A MK

Lee a continuación 📖 el manual en español para Extron WPC 210 A MK (2 páginas) en la categoría Toma de corriente. Esta guía fue útil para 10 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/2
WPC 210 A EU and MK • Installation Guide
NOTE: Refer to www.extron.com for the product specications.
The Extron® WPC 210 A EU and MK are wall mounted plates that accept HDMI video and
audio signals through one HDMI pigtail connector, and one 3.5 mm to captive screw connector.
The audio signal passes through the unit without modification and is output from the back via
captive screw connectors. The captive screw connectors accept 18 AWG (1.02mm) to 26AWG
(0.404 mm) wires.
• The WPC 210 A EU mounts onto one-gang European junction boxes.
• The WPC 210 A MK mounts onto MK electric type one-gang UK junction boxes.
SIDEWPC 210 A EU (FRONT) WPC 210 A MK (FRONT)
WPC 210 A MK
HDMI
AUDIO
WPC 210 A EU
HDMI
AUDIO
Preparing the Mounting Surface
Before starting the installation, do the following:
CAUTION: Risk of personal injury. Failure to check the items listed below may result
in personal injury.
ATTENTION: Potential Damage to Property. Failure to check the items listed below
may result in property damage.
Clear the intended location of any damaged cables or pipes that might cause injury when
you are installing the device.
Check that the installation meets the local and state regulatory
requirements, including building, electrical, and safety codes,
and UL and ADA accessibility requirements.
During installation, ensure that there is sufficient space behind the
device for the bend radius of the pigtail. The recommended
minimum bend radius is 0.80 inches (see image at right).
WPC 210 A EU
HDMI
AUDIO
0.80"
(20.3 mm)
68-2233-01
Rev. A
08 12
Installation
1. Using a junction box (not included) as a guide, mark and cut out the appropriate material
within the marked area.
2. Insert the junction box and secure it with nails or screws.
3. Run the HDMI and audio cables from the output or input device locations (as applicable)
behind the wall, and to the junction box location, then run the cables through the junction
box.
4. Video — Insert the HDMI connector from the wall into the pigtail connector of the plate.
5. Audio — Strip away 3 inches of the outer jacket from the end of the cable, strip 3/16 inches
(5 mm) of the inner jacket from the end of each wire, and secure the
wires to the 3-pole captive screw connector (see image at right).
Wire as described below.
• For balanced mono audio:
tip (T) = +, ring (R) = –, sleeve (S) = ground
• For unbalanced stereo audio:
tip (T) = left channel, ring (R) = right channel, sleeve (S) = ground
6. Secure the WPC 210 model to the junction box using the screws provided (see images
below).
WPC 210 A EU
HDMI
AUDIO
EU Junction Box
Extron
WPC 210 A EU
UK Junction Box
Extron
WPC 210 A MK
WPC 210 A MK
HDMI
AUDIO
7. Connect the appropriate input or output devices to the front panel connectors (see image
below).
WPC 210 A EU
HDMI
AUDIO
Projector
Laptop
Extron
WP EUC 210 A
TS
R
Extron USA Headquarters Extron USA - West SA - East Extron U
+800.633.9876 (Inside USA/Canada Only) +1.714.491.1500 +1.919.850.1000
+1.714.491.1517 FAX +1.919.850.1001 FAX
© 2012 Extron Electronics All rights reserved. www.extron.com

Especificaciones del producto

Marca: Extron
Categoría: Toma de corriente
Modelo: WPC 210 A MK

¿Necesitas ayuda?

Si necesitas ayuda con Extron WPC 210 A MK haz una pregunta a continuación y otros usuarios te responderán




Toma de corriente Extron Manuales

Toma de corriente Manuales

Últimos Toma de corriente Manuales