Frigidaire MWTK27FGUF Manual de Usario

Frigidaire Magnetron MWTK27FGUF

Lee a continuación 📖 el manual en español para Frigidaire MWTK27FGUF (16 páginas) en la categoría Magnetron. Esta guía fue útil para 6 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF
Página 1/16
Installation Instructions
Installation
Instructions
Built-in Trim Kit
Model #
BEFORE YOU BEGIN
• IMPORTANT – Save these instructions
for local inspector's use.
• IMPORTANT – Observe all governing
codes and ordinaces.
• Note to Installer – Be sure to leave
these instructions with the Consumer.
• Note to Consumer – Keep these
instructions for future reference.
• Skill level - Installation of this appliance
requires basic mechanical and electrical
skills.
Read these instructions completely and carefully.
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is
not covered under the Warranty.
• Unplug the microwave oven before
attempting installation of this kit.
• Because the kit includes metal parts, caution
should be used in handling and installation to
avoid the possibility of injury.
• Do not remove permanently affixed labels,
warnings, or plates from the product. This
may void the warranty.
FOR YOUR SAFETY:
WARNING – Before beginning the installation,
switch power off at service panel and lock out
When the service
cannot be locked, securely fasten
a prominent warning device, such as a tag, to
the service panel.
IMPORTANT - PLEASE READ
AND FOLLOW
THIS BUILT-IN KIT IS DESIGNED FOR USE
ONLY WITH ELECTROLUX MICROWAVE
OVENS SPECIFYING BUILT-IN KIT
QUESTIONS?
For customers in the United States call:1-800-944-9044
For customers in Canada call: 1-800-265-8352 (English)
1-800-668-4606 ext.8199 (French)
Visit our Website at: www.frigidaire.com
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
PN:
EN-1
MWTK27FGUF
MWTK30FGUF
MWTK30FGUD
MWTK27FGUD
MWTK30FPUF
A06823511
June 2018
to prevent being switched on accidentally.
PARTS INCLUDED IN THE KIT
1. Front Frame Assembly- QTY 1
2. Exhaust Duct - QTY 1
Mounting
Rail – QTY 2
3. Screw A - QTY 11+
4. Screw B - QTY 4
CHOOSING A LOCATION FOR
YOUR MICROWAVE OVEN IF
BUILT-IN
Built-In Trim Kit allows for the installation of microwaves
listed below to be built into a cabinet or wall by itself or
over an electric wall oven*.
Microwave Models:
See Illustration 1 for proper location and when building
in above a wall oven. Carefully follow both the wall oven
installation instructions and Electrolux’s Built-in Kit
instructions. If building over a wall oven, be sure the
clearance between the wall oven and the microwave
oven is a minimum of 3 inches.See illustration 2.
*NOTE: Trim Kit and microwave can only be built-in
over an electric self-clean or non self-clean
single cavity wall oven.
CABINET OR WALL CUTOUT
Cutout Dimensions( See illustration 3)
Height (A)
Minimum
Maximum
16 (42.5 cm)
17 (43.2 cm)
Width (B)
Minimum
Maximum
24 (62.9 cm)
Depth (C)
Minimum
EN-2
Bottom
3 extra
+ 2 extra
FGMO226NUF FGMO226NUD FPMO227NUF
CGMO226NUF CPMO227NUF
(50.8 cm)
2
Illustration 1
Bottom Mounting
Rail
Exhaust Duct
Front Frame Assembly
Trim Kit Overall Dimensions
Height 18" （458mm）
Width （686mm）（762mm）
Depth
MWTK27 MWTK30
27"
18" （458mm）
30"
Installation Instructions
" (63.5 cm)
25
Screw A
Screw B
Illustration 2
1 1/2" (38.9cm) 1 1/2" (38.9cm)
3"Min
3/4
0"
3/4 "
"
"
EN-3
Installation Instructions
Illustration
ELECTRICAL OUTLET LOCATION
Outlet should NOT be in the shaded area as indicated
on Illustration 3
NOTE 1:
The floor of the opening should be constructed of
plywood strong enough to support the weight of the
oven and floor load (approximately 100 pounds). The
floor should be level for proper operation of the oven. Be
sure to check the local building code as it may require
that the opening be enclosed with side, ceiling and rear
partition. The proper functioning of the oven does not
require the enclosure.
Illustration
EXHAUST DUCT ASSEMBLY
1. Draw a Central Line on floor. Place the Exhaust
Duct in the opening，When the Exhaust Duct
Assembly is in the opening correctly, the Center
Line is in the middle of the Exhaust Duct
Assembly. See Illustration .
2. Secure the Exhaust Duct Assembly with the
three screws A.
IMPORTANT: Secure screws in outer hole.
3 are needed for exhaust duct assembly
Screw A
Center Line
pcs
3 4
4

Especificaciones del producto

Marca: Frigidaire
Categoría: Magnetron
Modelo: MWTK27FGUF

¿Necesitas ayuda?

Si necesitas ayuda con Frigidaire MWTK27FGUF haz una pregunta a continuación y otros usuarios te responderán


Magnetron Frigidaire Manuales

Frigidaire

Frigidaire FMOS1846BW Manual de Usario

3 Octubre 2024
Frigidaire

Frigidaire MWTK27FGUF Manual de Usario

24 Septiembre 2024
Frigidaire

Frigidaire FFCM1155US Manual de Usario

22 Septiembre 2024
Frigidaire

Frigidaire FGMV173KQ Manual de Usario

20 Septiembre 2024
Frigidaire

Frigidaire FMOS1746BS Manual de Usario

19 Septiembre 2024
Frigidaire

Frigidaire FMV156DS Manual de Usario

17 Septiembre 2024
Frigidaire

Frigidaire FMOS1745BS Manual de Usario

13 Septiembre 2024
Frigidaire

Frigidaire FFCT1278LS Manual de Usario

28 Agosto 2024
Frigidaire

Frigidaire FGMV185KF Manual de Usario

26 Agosto 2024
Frigidaire

Frigidaire FFCM1134LW Manual de Usario

21 Agosto 2024

Magnetron Manuales

Últimos Magnetron Manuales

GE

GE Adora DVM7195DKWW Manual de Usario

27 Octubre 2024
Klarstein

Klarstein Julieta Manual de Usario

27 Octubre 2024
Severin

Severin MW 9628 Manual de Usario

27 Octubre 2024
Philco

Philco PMG1620S Manual de Usario

27 Octubre 2024
Thermador

Thermador PODMW301 Manual de Usario

27 Octubre 2024
GE

GE Profile PWB7030SVSS Manual de Usario

27 Octubre 2024
BEKO

BEKO MOC20100W1 Manual de Usario

25 Octubre 2024
Panasonic

Panasonic NN-SU656W Manual de Usario

24 Octubre 2024
Panasonic

Panasonic NN-CT552W Manual de Usario

24 Octubre 2024
Candy

Candy CMXW 30DS-UK Manual de Usario

24 Octubre 2024