HeatStar HSSVFBF30NGBT Manual de Usario

HeatStar Calentador HSSVFBF30NGBT

Lee a continuación 📖 el manual en español para HeatStar HSSVFBF30NGBT (4 páginas) en la categoría Calentador. Esta guía fue útil para 4 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/4

Enerco Technical Products, INC., 4560 W. 160TH ST., CLEVELAND, OHIO 44135 · 866-447-2194

INSTALLER: Leave this manual with the appliance.

CONSUMER: Retain this manual for future reference.

UNVENTED NATURAL GAS FIRED ROOM HEATER

WARNING: If the information in this manual is not followed exactly, a fire or explosion may

result causing property damage, personal injury, or loss of life.

-Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any

other appliance.

-WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone in your building.

• Immediatelycallyourgassupplierfromaneighbor’sphone.Followthegassupplier’sinstructions.

• If you cannot reach your gas supplier, call the fire department.

-Installation and service must be performed by a qualified installer, service agency or the gas supplier.

This is an unvented gas-fired heater. It uses air (oxygen) from the room in which it is installed.

Provisions for adequate combustion and ventilation air must be provided. Refer to Fresh Air for

Combustion and Ventilation section on page 4 of this manual.

This appliance may be installed in an aftermarket permanently manufactured (mobile) home,

where not prohibited by local codes.

This appliance is only for use with the type of gas indicated on the rating plate. This appliance is

not convertible for use with any other gas.

Blue Flame Heaters

HSSVFBF30NGBT

HSSVFBF20NGBT

Plaque Heaters

HSSVFRD20NGBT

HSSVFRD30NGBT

OPERATING INSTRUCTIONS

ANDOWNER’SMANUAL

Model #

HSSVFRD20NGBT

HSSVFRD30NGBT

HSSVFBF20NGBT

HSSVFBF30NGBT

READ INSTRUCTIONS CAREFULLY: YOUR SAFETY IS IMPORTANT TO YOU AND TO OTHERS Read and

follow all instructions. Place instructions in a safe place for future reference. Do not allow anyone who has

not read these instructions to assemble, light, adjust or operate the heater.

13 Installation Instructions and Owner’s ManualUnvented Natural Gas Vent Free Room Heaters

PAGE LEFT INTENTIONALLY BLANK

15 Installation Instructions and Owner’s ManualUnvented Natural Gas Vent Free Room Heaters

OBSERVED SYMPTOM POSSIBLE CAUSE REMEDY

Burner does not light after

ODS/pilot is lit

Burner orifice is clogged Clean burner orifice (see Cleaning and Maintenance on page

11), or replace burner orifice

Burner orifice diameter to small Replace burner orifice

Inlet gas pressure is too low Contact local gas company

Delayed ignition of burner

Manifold pressure is too low Contact local gas company

Burner orifice is clogged Clean burner orifice (see Cleaning and Maintenance on page

11), or replace burner orifice

Burner backfiring during

operation

Burner orifice is clogged or damaged Clean burner orifice (see Cleaning and Maintenance on page

11), or replace burner orifice

Burner damaged Replace burner

Gas regulator defective Replace gas regulator

Burner plaque(s) does not

glow [Infrared Only]

Plaque damaged Replace burner

Control knob set between locked

positions

Turn control knob until it locks at desired setting.

Inlet gas pressure is too low Replace gas regulator

Slight smoke or odor

during initial operation

Residues from manufacturing process Problem will stop after a few hours of operation

Heater produces a

whistling noise when

burner is lit

Turning control knob to HI position when

burner is cold

Turn control knob to LO position and let warm up for a minute

Air in gas line Operate burner until air is removed from line have gas line

checked by local gas company

Air passageways on heater blocked Observe minimum installation clearances (see Figure 4 page 6)

Dirty or partially clogged burner orifice. Clean burner orifice (see Cleaning and Maintenance on page

11), or replace burner orifice

White powder residue

forming within burner box

or on adjacent walls or

furniture

When heated, vapors from furniture

polish, wax, carpet cleaners, etc., turn

into white powder residue

Turn heater off when using furniture polish, wax, carpet cleaner

or similar products

Heater produces unwanted

odors.

Heater burning vapors from paint,

hair spray, glues, etc. See IMPORTANT

statement on page 14

Ventilate room. Stop using odor-causing products while heater

is running.

Gas leak. See WARNING statement at top

of page 14

Locate and correct all leaks (see Checking Gas Connections,

page 9)

Heater shuts off in use

(ODS operates)

Not enough fresh air is available Open window and/or door for ventilation

Low line pressure Contact local gas company

ODS/pilot is partially clogged Clean ODS/pilot (see Cleaning and Maintenance, page 11)

Gas odor even when

control knob is in OFF

position

Gas leak. See WARNING statement at top

of page 14

Locate and correct all leaks (see Checking Gas Connections,

page 9)

Control valve is defective Replace control valve

Gas odor during

combustion

Foreign matter between control valve

and burner

Take apart gas tubing and remove foreign matter

Gas leak. See WARNING statement at top

of page 14

Locate and correct all leaks (see Checking Gas Connections,

page 9)

Heater produces a clicking/

ticking noise just after

burner is lit or shut off

Metal expanding while heating or

contracting while cooling

This is common with most heaters. If noise is excessive, contact

qualified service person

Moisture/condensation

noticed on windows

Not enough combustion/ventilation air Refer to Fresh Air for Combustion and Ventilation page 3

through 5.

Especificaciones del producto

Marca:	HeatStar
Categoría:	Calentador
Modelo:	HSSVFBF30NGBT
Peso.:	33500 g
Ancho:	560 mm
Profundidad:	2230 mm
Altura:	530 mm
Material:	Aluminium
Ruedas:	Ja
Sistema de defensa:	Water
Monitor de rendimiento:	Ja
Placas de pie ajustables:	Ja
Número de cajas de embalaje:	2
Correas para los pies:	Ja