Honeywell EnergySmart Low Profile HZ-817 Manual de Usario

Honeywell cocina EnergySmart Low Profile HZ-817

Lee a continuación 📖 el manual en español para Honeywell EnergySmart Low Profile HZ-817 (15 páginas) en la categoría cocina. Esta guía fue útil para 16 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/15
The Honeywell trademark is used by Kaz, Inc. under license from Honeywell International Inc.
IMPORTANT SAFETY
INSTRUCTIONS
IF YOU DO NOT UNDERSTAND THESE
INSTRUCTIONS OR PRODUCT LABELS
DO NOT USE THIS PRODUCT AND
CALL US AT (800) 477-0457 FOR AN
EXPLANATION.
Warning - Failure to follow any of these safety
instructions could result in fire, injury or death.
YOUR RESPONSIBILITIES
These instructions are intended to provide you
with the information you need to use the product
and to avoid such hazards. When using electrical
appliances, basic precautions should always be
followed to reduce the risk of fire, electric shock,
and injury to persons, including the following:
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns,
do not let bare skin touch hot surfaces. If,
provided, use handle when moving this heater.
Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes, and curtains
at least 3 feet (0.9 m) from the front of the
heater and keep them away from the sides and
rear.
3. Extreme caution is necessary when any heater
is used by or near children or invalids, and
whenever the heater is left operating and
unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged
cord or plug or after the heater malfunctions,
has been dropped or damaged in any manner.
Return heater to authorized service facility
for examination, electrical or mechanical
adjustment, or repair.
6. Do not use outdoors.
7. This heater is not intended for use in
bathrooms, laundry areas and similar indoor
locations. Never locate heater where it may fall
into a bathtub or other water container.
8. Do not run cord under carpeting. Do not cover
cord with throw rugs, runners, or similar
coverings. Arrange cord away from traffic area
where it will not be tripped over.
9. To disconnect the heater, first turn off the
product, then grip the plug and pull it from the
wall outlet. Never pull by the cord.
10. Warning - Connect to properly grounded
outlets only. This heater is for use on 120 volts.
This appliance has a grounded plug as shown
in Fig. 1. An adapter is available at retail (not
included) for connecting three-blade grounding-
type plugs to two-slot receptacles. The green
grounding lug extending from the adapter must
be connected to a permanent ground such as
a properly grounded outlet box. The adapter
should not be used if a three-slot grounded
receptacle is available.
11. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening as this may
cause an electric shock or fire, or damage the
heater.
12. To prevent a possible fire, do not block air
intakes or exhaust in any manner. Do not use
on soft surfaces, like a bed, or where openings
may become blocked.
13. A heater has hot and arcing or sparking parts
inside Do not use it in the areas where gasoline,
paint or flammable liquids are
used or stored.
Q Huick eat® Heaters
MODEL HZ-614 SERIES AND HZ-614C SERIES
MODEL HZ-615 SERIES
MODEL HZ-617 SERIES AND HZ-617C SERIES
MODEL HZ-817 SERIES
HZ-614, HZ-615, & HZ-617 SERIES OPERATION
14. Use this heater only as described in this
manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or
injury to persons.
15. Avoid the use of an extension cord because the
extension cord may overheat and cause a risk
of fire. However, if you have to use an extension
cord, the cord shall be No. 14 AWG minimum
size and rated not less than 1875 watts. The
extension cord shall be a three wire cord with a
grounding-type cord and plug connector.
16. This heater draws 12.5 amps during operation.
To prevent overloading a circuit, do not plug
the heater into a circuit that already has other
appliances working.
17. It is normal for the plug to feel warm to the
touch; however, a loose fit between the
AC outlet (receptacle) and plug may cause
overheating and distortion of the plug. Contact
a qualified electrician to replace loose or worn
outlets.
18. Never tamper with this product or attempt to fix
it. Any tampering with, or modification of this
product can result in serious injury, death, fire
or risk of electric shock. Do not open, no user
serviceable parts inside.
19. Do not remove product labels that contain
warnings or safety instruction.
20. The output of this heater may vary and its
temperature may become intense enough
to burn exposed skin. Use of this heater is
not recommended for persons with reduced
sensitivity to heat or an inability to react to avoid
burns.
21. Caution - Before cleaning, or storage, or when
not in use, turn the fan to the off position and
unplug the heater from the electrical outlet and
allow it to cool.
22. Caution - place the heater on a firm, level open
surface free from obstructions and at least
3 feet (0.9m) away from any combustaible
materials. DO NOT use on an unstable surface
such as bedding or deep carpeting. Be sure
the heater is not in a position where it may
be tripped over by small children or pets. The
heater’s rubber feet will hold it firmly in position.
23. Caution - if your home has aluminum wiring
have a licensed electrician check your
receptacle’s connections. When using any 1500
watt heater, aluminum wire connections can
cause a safety issue.
24.
SAVE THESE INSTRUCTIONS
Place the heater on a firm, level surface away from any
combustible material.
With Power Knob in the OFF position, plug the heater into a
grounded outlet.
Turn the Thermostat Knob fully clockwise to the high setting.
To turn the heater on, turn the Power Knob clockwise to the ON
position. (Fig. 2).
If you want to use the Quick Heat® feature, turn the Power Knob to
the Quick Heat® Setting.
When the room reaches a comfortable temperature, slowly turn the thermostat control counter-
clockwise until the heater goes off. This is the point at which the thermostat setting equals the
room temperature. If left at this setting, the thermostat will automatically turn the heater on and off to
maintain the selected temperature.
Fig. 2
IMPORTANT SAFETY INSTRUCTIONS REGARDING THE PLUG ON YOUR PRODUCT
Fig. 1
Quick Heat® will propel a steady blast of warm air out of your baseboard. This can help heat your room
more quickly. You will hear a fan operating in this mode. You can also turn the Quick Heat® setting off
and the heater will operate silently.
QUICK HEAT® FEATURE
This heater is equipped with several devices and features for added
protection.
• A high temperature safety control prevents overheating
(Hi Limit).
• A back-up thermal circuit breaker that will permanently shut down
the heater should it operate at higher than normal temperatures
(HZ-614, HZ-615, HZ-617 and HZ-817 only).
• A SafeGuard Alert Heat Indicator Badge that indicates the grille is
hot and should not be touched - turns from black to red (HZ-614C,
HZ-617, HZ-617C and HZ-817 only).
• Tip-over switch feature - The HZ-817 SERIES ONLY is equipped
with a tip-over switch that disables the heater if it is tipped over.
To restore power to the heater, stand the heater up properly and
press the power button.
• A three-prong grounded plug.
• This heater was created using a high quality safety plastic.
SAFETY FEATURES
Place the heater on a firm, level, open surface free from
obstructions and at least 3 feet (0.9 m) away from any
combustible materials.
Never leave an operating unit unattended.
Plug the heater into an electrical wall outlet.
Touch the Power Button to turn the heater on.
The power indicator light will illuminate. (Fig. 3)
To save up to 35% in energy bills, turn the Energy Smart
knob to your desired temperature. There are four distinct
settings of 65°F/18°C, 70°F/ 21°C, 75°F/23°C, and
80°F/26°C. The Energy Smartheater will automatically
select the appropriate power level to best accommodate
your desired temperature. As the air temperature in
the room approaches the set temp, the heater will
automatically lower the power consumption and provide
consistent warmth without wasting energy.
The illuminated LED lights will indicate what the current room temperature is.
The LOW setting ( ) is designed to operate only if the temperature is below 55°F (12°C). If the room
temperature is above 55°F (12°C), the heater will remain OFF until the temperature drops below this
level. If you want the heater to operate when the room is above 55°F (12°C), then move the Thermostat
to a higher setting.
To override the Energy Smart™ feature and produce maximum heat, turn the knob fully clockwise to
HIGH ( ). This will produce 1500W of heat at all times.
HZ-817 SERIES OPERATION
Fig. 3
Power
Button
Quick
Heat
Power Indicator Light
Control
Knob
Fig. 4 Heat Indicator
Badge
Do not touch the grille until the
unit has been turned off and
the SafeGuard
Alert Badge has
turned back to black.

Especificaciones del producto

Marca: Honeywell
Categoría: cocina
Modelo: EnergySmart Low Profile HZ-817

¿Necesitas ayuda?

Si necesitas ayuda con Honeywell EnergySmart Low Profile HZ-817 haz una pregunta a continuación y otros usuarios te responderán




cocina Honeywell Manuales

cocina Manuales

Últimos cocina Manuales