IHome ICVBT1 Manual de Usario

IHome Vocero ICVBT1

Lee a continuación 📖 el manual en español para IHome ICVBT1 (1 páginas) en la categoría Vocero. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/1
6
2
5
4
3
1
iHome Beauty
PORTABLE
Quick Start Guide
iCVBT1
Charging the Mirror
Lift the door on the back of the unit. Connect included
USB charging cable to the USB port, and the other end to
a powered USB port.
RESET
USB AC
adaptor
(not included)
USB charging
cable
(included)
• The LED will flash red while charging, and will shut o
automatically when the internal battery is fully charged.
Battery
Status/Pairing
LED
Light Function
• Tap the center button to turn the mirror light ON or OFF.
(The light will activate if the speaker is ON or OFF.)
You look
Amazing!
• Hold the center button to adjust the brightness level.
Note: The mirror light runs on a timer that will automatically
power o after 15 minutes.
Audio Function
power icon to turn speakerPress and hold
ON or OFF
• When mirror is ON, fortouch/hold icon
pairing mode, indicated by the blinking
BLUE LED
• Select “iHome iCVBT1” on your device’s
Bluetooth menu to connect
• Tap to play / pause Bluetooth audio
• Tap to answer & end Bluetooth calls
• Touch/hold for 2 seconds to decline
Bluetooth calls
• Tap to l er or raise volumeow
Adjusting the Mirror
The door on the back of the unit also works as a
kickstand for the mirror. Adjust the door to the desired
angle as needed.
Reset
In the event of interrupted operation, use the extended
wire of a paper clip or other thin tool to push in the Reset
Button on the back of the unit.
IMPORTANT SAFETY INSTRUCTIONS
When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety.
However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating
instructions carefully before installation and use, and keep these instructions handy for future reference. Take
special note of all warnings listed in these instructions and on the unit.
GENERAL
• Please exercise caution when in use as the mirror is made of glass.
1. Water and Moisture The unit should not be used near water. For example: near a bathtub, washbowl, kitchen
sink, laundry tub, swimming pool or in a wet basement.
2. Ventilation The unit should be situated so that its location or position does not interfere with its proper
ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block ventilation
openings. Also, it should not be placed in a built-in installation, such as a bookcase or cabinet, which may
impede the flow of air through the ventilation openings.
3. – The unit should be situated away from heat sources such as radiators, heat registers, stoves or other Heat
appliances (including amplifiers) that produce heat. Do not use around aerosol products or in the presence of
oxygen being administered.
4. Sunlight Never place the mirror in or expose the mirror to direct sunlight. The sun’s rays can reflect to
become focused and cause excessive heat and/or fire. Do not use mirror in direct sunlight as reflected sunlight
could injure eyes.
5. Power Sources – The unit should be connected to a power supply only of the type described in the operating
instructions or as marked on the appliance.
6. Power-Cable Protection – Power supply cables should be routed so that they are not likely to be walked on
or pinched by items placed upon or against them. It is always best to have a clear area from where the cable
exits the unit to where it is plugged into an AC socket.
7. – The unit should be cleaned only as recommended. See the Maintenance section of this manual Cleaning
for cleaning instructions.
8. Objects and Liquid Entry Care should be taken so that objects do not fall and liquids are not spilled into
any openings or vents located on the product.
9. – Do not use attachments not recommended by the product manufacturer.Attachments
10. Lightning and Power Surge ProtectionUnplug the unit from the wall socket and disconnect the antenna
or cable system during a lightning storm or when it is left unattended and unused for long periods of time. This
will prevent damage to the product due to lightning and power-line surges.
11. Overloading Do not overload extension cords, as this wall sockets, or integral receptacles convenience
can result in a risk of fire or electric shock.
12. Damage Requiring Service – The unit should be serviced by qualified service personnel when:
A. the power supply cable or plug has been damaged.
B. objects have fallen into or liquid has been spilled into the enclosure.
C. the unit has been exposed to rain.
D. the unit has been dropped or the enclosure damaged.
E. the unit exhibits a marked change in performance or does not operate normally.
13. Periods of NonuseIf the unit is to be left unused for an extended period of time, such as a month or longer,
the power cable should be unplugged from the unit to prevent damage or corrosion.
14. Servicing The user should not attempt to service the unit beyond those methods described in the user’s
operating instructions. Service in instructions methods not covered the operating should be referred to
qualified service personnel
15. Attention should be drawn to the environmental aspects of battery disposal
16. Do not dispose of batteries in the household trash or fire”
17. No naked flame sources, such as lighted candles, should be placed on this product”
18. This product is suitable for use in tropical and/or moderate climates.”
FCC Information
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-3 (B)/NMB-3(B)
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two
conditions:
(1) This device may not cause interference and (2) This device must accept any interference received, including
interference that may cause undesired operation
FCC ID: EMOICVBT1
IC: 986B-ICVBT1
Limited One Year Warranty
iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI), warrants this
product to be free from defects in workmanship and materials, under normal use and conditions,
for a period of one (1) year from the date of original purchase.
Should this product fail to function in a satisfactory manner, it is best to first return it to the store
where it was originally purchased. Should this fail to resolve the matter and service still be
required by reason of any defect or malfunction during the warranty period, SDI will repair or, at
its discretion, replace this product without charge. This decision is subject to verification of the
defect or malfunction upon delivery of this product to the Factory Service Center authorized by
Customer Service.
If service is required, please call Customer Service at 1-800-288-2792 to obtain a Return
Authorization Number and shipping instructions. A copy of the sales receipt is required to validate
in-warranty coverage.
Disclaimer of Warranty
NOTE: This warranty is valid only if the product is used for the purpose for which it was designed.
It does not cover (i) products which have been damaged by negligence or willful actions, misuse
or accident, or which have been modified or repaired by unauthorized persons; (ii) cracked or
broken cabinets, or units damaged by excessive heat; (iii) damage to digital media players, CD’s
or tape cassettes (if applicable); (iv) the cost of shipping this product to the Factory Service
Center and its return to the owner.
This warranty is valid only in the United States of America and does not extend to owners of the
product other than to the original purchaser. In no event will SDI or any of its affiliates,
contractors, resellers, their officers, directors, shareholders, members or agents be liable to you
or any third party for any consequential or incidental damages, any lost profits, actual, exemplary
or punitive damages. (Some states do not allow limitations on implied warranties or exclusion of
consequential damages, so these restrictions may not apply to you.) This warranty gives you
specific legal rights, and you may also have other rights which vary from state to state.
Your acknowledgment and agreement to fully and completely abide by the above mentioned
disclaimer of warranty is contractually binding to you upon your transfer of currency (money
order, cashier's check, or credit card) for purchase of your SDI product.
© 2019 SDI Technologies, Inc. All rights reserved.
Questions? Visit www.ihome.com
or call 1-800-288-2792 Toll Free
Printed in China
Note: If no audio is playing for 15 minutes, the unit will
automatically power o to conserve the battery.
If the LED flashes red when the unit is charging, thisnot
indicates that the battery is weak and should be charged.
IC Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of
the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
le dispositif a été évalué à satisfaire l'exigence générale de l'exposition aux rf.
l'appareil peut être utilisé dans des conditions d'exposition portatif sans restriction.
Maintenance
This unit comes with a cleaning cloth to keep the mirror
smudge free. If more cleaning is needed, try washing with
mild soap and water.

Especificaciones del producto

Marca: IHome
Categoría: Vocero
Modelo: ICVBT1

¿Necesitas ayuda?

Si necesitas ayuda con IHome ICVBT1 haz una pregunta a continuación y otros usuarios te responderán




Vocero IHome Manuales

Vocero Manuales

Últimos Vocero Manuales