K&K Sound Golden Bullet URB Manual de Usario

K&K Sound No categorizado Golden Bullet URB

Lee a continuación 📖 el manual en español para K&K Sound Golden Bullet URB (2 páginas) en la categoría No categorizado. Esta guía fue útil para 6 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/2
92798 Cape Arago Hwy, Coos Bay, OR 97420 | 541-888-3517 | Toll Free 1-800-867-6863 | www.kksound.com
P R O D U C T M A N U A L
G O L D E N B U L L E T U R B M I C R OPH O N E
The Golden Bullet URB Microphone is a condensor microphone chosen specifically for its performance with the
double bass. We picked this mic in cooperation with one of the most renowned double bass specialists, Bob
Gollihur, because it combines great sound with excellent feedback resistance. It is unidirectional to help avoid
rumble and undesirable bleed from other instruments. Amazingly light and small, it is mounted on the bridge
using a special Velcro self-adhesive fastener and positioned using its six-inch gooseneck.
ATTACHING THE MICROPHONE
The mic is supplied with a piece of dual-lock (similar to Velcro) for mounting on your bridge. Cut a piece from
the supplied dual-lock (the same length as the folded piece attached to the mic gooseneck) and, leaving the
adhesive backing piece in place, attach it to one side of the dual-lock on the mic.
Since each bridge is different, the best placement requires some
experimenting. You may wish to place the adhesive piece on the inside or
on the bottom of the leg of the bridge. Before you remove the protective
strip, use both hands to temporarily hold it in place and adjust the mic
gooseneck.
Once you have found the best location, remove the protective strip and
press the adhesive against the bridge. The bridge surface should be clean
and clear of any rosin for the best results. Our testing has shown that a good
location for the mic is on the G-string side of the bass, with the mic at an
angle towards the F-hole, as shown in the photograph. Directly aiming at the
sound hole is not recommended. Of course, the gooseneck allows you to try
a wide range of positions.
Note: Tight bass cases may catch on or move the mic. If necessary, you may wish to place another piece of
dual-lock elsewhere on your bridge to temporarily relocate the mic when you pack the bass.
2
92798 Cape Arago Hwy, Coos Bay, OR 97420 | 541-888-3517 | Toll Free 1-800-867-6863 | www.kksound.com
JACK INSTALLATION
Put the mounting plate between any two pairs of strings as shown in the illustration. Make sure all cables are
placed so they do not vibrate against the bass or each other.
USING THE PREAMP
Remove the screw and remove the lid to install a 9-volt battery. The microphone must be used with the
companion preamplifier to work. The preamp supplies the necessary power to the microphone. To prolong
battery life, remove the output cable when not in use.
TECHNICAL DATA
Preamp: 3"x3.5"x1.25"
Pickup channel input impedance: 1 MegOhm
Output impedance: 10K ohms
Input: Stereo 1/4"
Outputs: 1/4"
Power: 9-volt battery
Supplied with stereo connecting cable
Frequency Diagram

Especificaciones del producto

Marca: K&K Sound
Categoría: No categorizado
Modelo: Golden Bullet URB

¿Necesitas ayuda?

Si necesitas ayuda con K&K Sound Golden Bullet URB haz una pregunta a continuación y otros usuarios te responderán




No categorizado K&K Sound Manuales

No categorizado Manuales

Últimos No categorizado Manuales