Kent Somerset MKII Manual de Usario

Kent Calentador Somerset MKII

Lee a continuación 📖 el manual en español para Kent Somerset MKII (12 páginas) en la categoría Calentador. Esta guía fue útil para 5 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/12

OWNERS MANUAL

Tested and approved to Australian Standards AS/NZS 2918:2018

and AS/NZS 4013/4012:2014.

Prior to installation check with your state and local authorities

regarding any specific regulations that may apply.

Please keep these instructions for future reference.

Burn hardwood only.

Pricotech proudly supports the

activities of Landcare Australia

through its membership of the

AHHA.

WOOD HEATERS

for

Kent Somerset MkII

and

Kent Country Classic MkII

FIRST THINGS FIRST...

Congratulations on your purchase of a quality wood heater. This product is designed according to strict

environmental, quality and safety standards and should give you years of trouble free home heating.

Read these instructions carefully to get the most out of your heater and to ensure safe and satisfactory heater

performance. In particular, we would like to draw your attention to these warnings.

ExclusionofLiability

Whilst every care has been taken in formulating these instructions, no responsibility whatsoever will attach to

and/or claim lie against, the manufacturer and/or the distributor of the heater as a result of any failure to follow

the whole or any part of the instructions and/or as a result of incorrect information herein and/or any omission

here from.

Becarefulofwhatyouburn:

*Use only dry, well seasoned hardwood.

*Do not use coal or briquettes.

*WARNING: DO NOT USE FLAMMABLE

LIQUIDS OR AEROSOLS TO START OR

REKINDLE THE FIRE.

*Do not burn garbage in the firebox as garbage

can cause a dangerous soot build up and

increase the amount of smoke your heater

produces.

*Do not burn chemically treated timber as the

poisonous gases given off could damage your

stove.

*CAUTION: THE USE OF SOME TYPES OF

PRESERVATIVE-TREATED WOOD AS FUEL

CAN BE HAZARDOUS.

*Do not place any types of builders board eg

fibro, cement sheeting (or any other materials

not specified and tested by the manufacturer)

inside the firebox.

Protect yourself and your family from

burns:

*WARNING: OPEN AIR CONTROL

BEFORE OPENING FIRING DOOR.

*The exterior surfaces of the heater will become

hot during operation. For protection of

children, the elderly or infirm, provide a

firescreen to prevent contact with the

appliance in operation.

*To protect against injury from burns, use

caution when operating the appliance. In

particular, when loading the firebox, provide

adequate protection for your hands.

Use your heater according to these

instructions:

*CAUTION: THIS APPLIANCE SHOULD BE

MAINTAINED AND OPERATED AT ALL TIMES

I N A C C O R D A N C E W I T H T H E S E

INSTRUCTIONS.

*DO NOT BURN WITH DOOR OPEN.

*CAUTION: THIS APPLIANCE SHOULD NOT

BE OPERATED WITH A CRACKED GLASS.

*Do not throw logs into the firebox. Always

place logs carefully.

*Do not overfire (allow firebox to glow red) as

this could damage your firebox.

*WARNING: ANY MODIFICATION OF

THE APPLIANCE THAT HAS NOT BEEN

APPROVED IN WRITING BY THE

TESTING AUTHORITY IS CONSIDERED

AS BREACHING AS/NZS 4013.

*The appliance or flue system should not be

modified in any way without the written

approval of the manufacturer.

The heater can get very hot, so watch

obviousfirehazards:

*Do not place clothing or other combustible

materials on top of the heater.

*WARNING: DO NOT USE FLAMMABLE

LIQUIDS OR AEROSOLS OR PLACE

THESE IN THE VICINITY OF THIS

APPLIANCE WHEN IT IS OPERATING.

*WARNING: DO NOT STORE FUEL

WI TH IN HE ATE R INS TA LL ATI ON

CLEARANCES.

*Do not store flammable liquids near the

heater.

ASSEMBLING YOUR NEW HEATER

Your heater comes almost completely assembled. There is only a simple matter of placing the bricks and brick

retainer, positioning the baffle plate and the heater is ready to be installed. The firebricks and baffle plate

MUST be installed prior to operating the appliance.

BRICK RETAINER

To hold the firebricks in place, you should now

position the brick retainer bracket over the

firebricks as shown below.

Somerset MkII

Country Classic MkII

BAFFLE PLATE

Both models have baffles with an angled lip.

Ensure the baffle is placed into the firebox with the

angled lip facing up, as shown in the diagrams

below.

When placing the baffle plate in the heater, you

may need to angle the baffle plate up on one side

to get it through the door.

You should then lift the baffle over one bracket,

push it up to the top of the firebox, and then lift it

over the other bracket.

Push the baffle plate all the way to the back of the

heater to ensure it is in the correct position.

Somerset MkII

Country Classic MkII

FIREBRICK PLACEMENT

There are two firebox sizes in the Kent range and

each has its own arrangement of firebricks. Refer

to the diagrams below for your heater. The bricks

are placed with their longest edge upright.

There will be gaps in between the firebricks. Allow

the ash to settle in between - there is no need to

remove the bricks when cleaning the firebox.

Brick Sizes

A - 200 x 119 B - 200 x 173 C - 215 x119

D - 173 x 74 E - 119 x 74

Especificaciones del producto

Marca:	Kent
Categoría:	Calentador
Modelo:	Somerset MKII
Color del producto:	Zwart
Peso.:	120 g
Ancho:	66 mm
Profundidad:	170 mm
Altura:	85 mm
Amable:	Draagbare streepjescodelezer
Código de seguridad internacional (IP):	IP40
Indicadores LED:	Ja
Tecnología de conectividad:	Bedraad
Señal de advertencia:	Ja
Consumo de energía (en espera):	0.45 W
Certificación:	CE, FCC, BSMI
Voltaje de entrada:	4 - 5.5 V
Temperatura de almacenamiento:	-40 - 60 °C
Longitud de onda:	617 nm
El consumo de energía:	400 mA
Códigos de barras compatibles (1D):	Code 39, U.P.C.
Interfaces estándar:	USB, RS-232
tipo de escáner:	1D/2D
Consumo de energía (típico):	2 W
Temperatura de funcionamiento (TT):	0 - 40 °C
Humedad relativa de funcionamiento (VV):	5 - 95 procent
Rincón de lectura de propuestas:	-70 - 70 °
Admite códigos de barras 2D (matriciales y apilados):	Data Matrix, PDF417, QR Code
Rincón de lectura inclinable:	-60 - 60 °
Tolerancia de movimiento (cm/s):	10