Mycoolman CTP10 Manual de Usario

Lee a continuación 📖 el manual en español para Mycoolman CTP10 (4 páginas) en la categoría Caja fría. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/4
CTP COOLER·WARMER
Operation Manual
Thermoelectric Cooler/Warmer
Model CTP 10
LEISURE-TEC Australia Pty Ltd
oolman.com.au
DO NOT use if any of the electrical cables
exes and plugs are worn or frayed.
Replace with original manufacturers parts.
ALWAYS check cables for mechanical damage,
cuts in the insulation, heat / moisture damage
before use. If in any doubt REPLACE.
DO NOT handle electricalexes with wet hands.
DO NOT place electrical items in refrigerator.
If your appliance has been owith food
stored, do not consume if in any doubt!
Repairs should only be carried out by a
suitably qualied and authorized person.
Poor repair could be dangerous.
DO NOT store dangerous items in the
appliance, such as spray cans, explosives,
andammable liquids / propellants.
ALWAYS leave room for airow around the
contents stored in the appliance to ensure
optimum performance.
DO NOT operate this appliance in the rain.
DO NOT allow children to play with the
appliance.
Small children must be supervised when
around all electrical appliances.
DO NOT allow children or pets to climb inside
appliance.
ALWAYS disconnect before cleaning.
Food must be stored in suitable and
appropriate containers.
If your appliance is plugged in to a
DC vehicle socket – ensure that you
disconnect from power when you stop.
Don’t come back to aat battery!
DO NOTll appliance with ICE, WATER
or other liquid.
DO NOT attempt to remove frost with scraper
or knife. Serious damage to cooling system
could occur.
Buildup of heat in a vehicle can be extreme,
“shutdownwill occur if cooling is not possible.
Important Safety Warnings page 2
Product Features page 2
Important Product Information page 3
Control Panel & Operation Instructions page 3
Troubleshooting page 3
Cleaning & Maintenance page 4
Product Specications page 4
Warranty Terms & Conditions page 4
Built in cup holders
Super Compact
USB socket
Chills to a maximum of 18 °C below ambient
Warms up to a maximum of 65 °C
Built in storage compartment for power leads
NOTE:
This appliance is not designed for
temperature control of medicine.
When the ’warming’ setting is engaged the
inside surface can become extremely hot.
Caution should be taken when retrieving
contents.
CTP COOLER·WARMER10
Contents
Important Safety Warnings
page 2
Product Features
Temperatures above +32 °C may see a slight
performance drop.
When using the unit ensure the circuit being used
has a fuse or circuit breaker, recommended size
for DC 12 Volt is 10 Amp, DC 24 Volt is 5 Amp.
Make sure the voltage is within the correct
range for socket and cable being used.
Do not place any electrical devices inside
the appliance as they may be damaged.
Your unit requires good ventilation, especially
around the vents of the appliance; allow a
gap of at least 100 mm around all vents.
Do not allow a large amount of frost to
build up on the inside walls as this may
impair cooling.
• Designed for short term warming and
cooling.
Defrost by turning the unit o , allowing
the frost to melt and wipe out the water.
Problem Possible Cause Possible Solution
Cooler
is not
heating
or
cooling
• No voltage available at DC socket
• Poor or dirty connection at DC socket
• Break in connection cable from
DC socket from appliance
• Fuse in DC connection cable has blown
(open circuit)
• Vehicle fuse blown (open circuit)
• Ignition not on
• Appliance is not on
• Check vehicle fuse is not blown (open circuit)
• Visually check the DC socket contact surfaces for
contamination or oxidation
• Visually inspect the DC cable for damage. If damage
is sighted, dispose of cable and purchase a new one.
• There is a fuse located in the tip of the DC plug. Visually check
to see if the fuse has blown. If the fuse has blown, replace.
• Visually inspect your vehicles fuse and replace if blown.
• Check that the ignition is turned on
• Check that the appliance is switched to either the HOT or COLD.
Turning the unit on and o :
Step 1: Plug in the DC power cable (ensure power is on at source).
Step 2: Slide the switch from the OFF middle position to either the
HOT or COLD setting.
Important Product Information
Control Panel & Operation Instructions
Troubleshooting
page 3
NOTE:
The light will illuminate
next to the mode that is
engaged.
A GREEN light will
illuminate next to COLD
to indicate that it is
working and cooling.
A RED light will illuminate
next to HOT to indicate
that it is working and
warming.
CTP COOLER·WARMER10
Power Switch
USB Socket
Indicator Light COLD
Indicator Light HOT DC Input Socket

Especificaciones del producto

Marca: Mycoolman
Categoría: Caja fría
Modelo: CTP10

¿Necesitas ayuda?

Si necesitas ayuda con Mycoolman CTP10 haz una pregunta a continuación y otros usuarios te responderán




Caja fría Mycoolman Manuales

Caja fría Manuales

Últimos Caja fría Manuales