Pyle PLRDN43 Manual de Usario

Pyle Altavoz de subgraves PLRDN43

Lee a continuación 📖 el manual en español para Pyle PLRDN43 (18 páginas) en la categoría Altavoz de subgraves. Esta guía fue útil para 9 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/18

AM/FM/MP3/USB/AUX Stereo Receiver, Single DIN,

30 Preset Memory Stations, LCD Display

with Remote Control (Black)

PLCD54MP

MP3 DSP Stereo Receiver Power Amplifier

www.PyleUSA.com

INSTALLATION

Preparation

The preparation kit is necessary to mount the radio on the dashboard, this kit is

available at electronics stores and car audio specialists, check the installation

kit before using it to make sure it is the right one for your vehicle.

INSTALL THE DEVICE

1. Lift the left or right top corner of the plastic outer trim ring then pull it out to

remove it.

2. Insert the two bracket keys into the left and right side of the chassis to

separate the chassis from the housing.

3. Install the mounting knob on the board. Check the opening size of the sliding

panel to be mounted. If the measurement is not large enough, carefully cut it

until it slips easily on the opening. Do not force the handle in the opening so

as not to bend it. Locate the series of dubbing tabs above, below and all sides

to be mounted. Completely insert it to the opening of the board, bend the

tabs as necessary towards outside to ensure it ts the board.

4. Slide the stereo into the opening in the dash, ensuring that the wires behind

are tucked and not pinched.

5. Follow the wiring diagram carefully. Verify you've connected them correctly.

Connect the unit to a 12 Volt power source with adequate ground.CAUTION!

6. Now that your wires are all completed, attach the front panel and turn theON

unit (the vehicle must be switched on). If the unit does not work, check the

calibration again until the problem is solved. With the new car stereo secured

into the bracket, all you need to do is plug the wiring harness back into the

stereo and put the assembly back into place.

7. Slide the stereo into the opening in the dash, ensuring that the wires behind

are tucked and not pinched. Sometimes this may take a few times when the

vehicle has a tight dash opening. Tuck the wires back into an opening behind

the unit.

8. Install the plastic outer trim ring

9. Snap all the pieces of trim back into place over the stereo. Double check that

all screws and trim pieces are securely in place.Try out the new stereo.

Turn the car power on again and play around with the stereo and its settings

to be sure everything is in working order.

www.PyleUSA.com 3

WIRING CONNECTIONS

HARDS FREE PUSH-TO-TALK

PUSH-TO-TALK

• Allows you to access SIRI GOOGLE voice or via Wireless BT.

• Your phone must support SIRI or GOOGLE voice. Once connected to BT, your

phone will ask for access to your contact list.

• Now you are ready to use PUSH-TO-TALK. Press the PUSH-TO-TALK icon.

You are ready to talk. Call "(CONTACT NAME)"The system will call without

having to use your phone.

CONTROL PANEL BUTTONS

15A

Front C utput(Left)R A O Front C utput( ight)R A O R

R A Oear RC utput(Left)

R A O Rear RC utput( ight)

SU WOOFERB

EX nal MICter

SWC

Antenna Jack

Power/speaker Connector

FUSE 15A

AN RADIO ANTENNA JACKT:

F-L: R A OFront C utput(Left)

F-R: R A O RFront C utput( ight)

R-L:R R A Oear C utput(Lef t )

R-R:R R A O Rear C utput( ight)

PRECAUTION

+12V DC

NEGATIVE

EARTH

13 1719 2 312

15 8 9

6 7

Especificaciones del producto

Marca:	Pyle
Categoría:	Altavoz de subgraves
Modelo:	PLRDN43
Color del producto:	Zilver
Pantalla incorporada:	Ja
Peso.:	880 g
Ancho:	200 mm
Profundidad:	118 mm
Altura:	110 mm
Reloj integrado:	Ja
Fuente-de-alimentación:	AC
Resolución:	320 x 240 Pixels
Estándares wifi:	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Formato de audio soportado:	MP3, WAV, WMA
Tipo de enchufe de conexión:	3,5 mm
Cables suministrados:	Audio (3,5 mm)
Incluye adaptador de CA:	Ja
Función de reloj mundial:	Ja
Altavoces incorporados:	Ja
Energía promedio:	3 W
Control del volumen:	Draaiknop
Salidas de auriculares:	1
Conexión para adaptador de red:	Ja
Visualización en pantalla (OSD) -talen:	CZE, DAN, DUT, ENG, ESP, FRE, ITA, NOR, POL, POR, RUS, SLV, SWE, TUR
tipo de sintonizador:	Digitaal
Certificación de Digital Living Network Alliance (DLNA):	Ja
Voltaje de entrada:	230 V
Visualización en pantalla (OSD):	Ja
Algoritmos de seguridad compatibles:	WEP, WPA, WPA2-PSK, WPS
Despertador:	Ja
Baterías:	Ja
Plug and Play universal (UPnP):	Ja
Reproducir MP3:	Ja
Entrada auxiliar:	Ja
Bandas de frecuencia soportadas:	FM, UKW
Número de canales preestablecidos:	25000
Radio:	Internet
Proyección:	Nee
Compatibilidad con acoplamiento de Apple:	Niet ondersteund
Regulador de intensidad:	Ja
banda FM:	87.5 - 108 MHz
Mando a distancia incluido:	Ja
Wifi.:	Ja
Temperatura de funcionamiento (TT):	0 - 35 °C
Tiempo-de-dormir:	Ja
Tipo-de-visualización:	TFT
Temperatura exterior:	Ja