Stinger TXFBB12 Manual de Usario

Lee a continuación 📖 el manual en español para Stinger TXFBB12 (11 páginas) en la categoría Altavoz de subgraves. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/11
12 SWING GATE MOUNTED
SUBWOOFER ENCLOSURE
FOR FORD BRONCO
INSTALLATION GUIDE
NOTE! Read this installation guide thoroughly before disassembling or modifying
the vehicle. Installation of this product requires technical skill, experience and
specialized tools. If in doubt, it’s recommended to have it professionally installed
by an authorized or Dealer.Stinger Phoenix Gold
TXFBB12
A video installation guide is available at:
https://stingerelectronics.com/products/txfbb12
®
2
Limited Warranty
Stinger warrants this product to be free of defects in materials and workmanship for a period of one (1) years from the original date of
purchase. This warranty is not transferable and applies only to the original purchaser from an authorized Stinger dealer in the United
States of America only. Should service be necessary under this warranty for any reason due to manufacturing defect or malfunction,
Stinger will (at its discretion), repair or replace the defective product with new or remanufactured product at no charge. Damage caused
by the following is not covered under warranty: accident, misuse, abuse, product modication or neglect, failure to follow
installation instructions, unauthorized repair attempts, misrepresentations by the seller. This warranty does not cover incidental or
consequential damages and does not cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to accident or normal
wear and tear is not covered under warranty.
INTERNATIONAL WARRANTIES:
Products purchased outside the United States of America are covered only by that country’s Authorized Stinger reseller and not by
Stinger. Consumers needing service or warranty information for these products must contact that country’s reseller for information.
3
INSTALLATION NOTES
For models equipped with a factory subwoofer, unplugging the factory subwoofer is recommended.
Some installation steps are more easily completed with a second person.
Speaker wire is required before the enclosure is mounted.
Recommended amplier rating: 400-800 watts @ 2ohms.
Do not power up until inside contents are removed.
GETTING STARTED
Remove the four Philips screws from the speaker and remove the speaker.
Set speaker and screws in a safe place.
Remove contents from inside the enclosure.
Open the hardware pack and conrm hardware quantities and tools required using the guide on the
following pages.
RECOMMENDED TOOLS
#2 Philips Screwdriver
5mm Allen Wrench
14mm Wrench
10mm Socket
Ratchet
Socket Extension
9mm Drill Bit (Included)
Drill
Center Punch
Hammer
Tape
Wire Strippers
Scissors
Rivet Nut Setter (Optional)

Especificaciones del producto

Marca: Stinger
Categoría: Altavoz de subgraves
Modelo: TXFBB12

¿Necesitas ayuda?

Si necesitas ayuda con Stinger TXFBB12 haz una pregunta a continuación y otros usuarios te responderán




Altavoz de subgraves Stinger Manuales

Altavoz de subgraves Manuales

Últimos Altavoz de subgraves Manuales