Ubiquiti Networks PBE-5AC-620 Manual de Usario

Lee a continuación 📖 el manual en español para Ubiquiti Networks PBE-5AC-620 (28 páginas) en la categoría repetidor wifi. Esta guía fue útil para 9 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/28
High-Performance
Integrated InnerFeed
airMAX® ac Bridge
Model: PBE-5AC-620
Introduction
Thank you for purchasing the Ubiquiti Networks® PowerBeam
™ ac.
This Quick Start Guide is designed to guide you through the
installation, and show you how to access the airOS® Configuration
Interface. This Quick Start Guide also includes the warranty terms
and is for use with the
PowerBeam ac, modelPBE-5AC-620.
Package Contents
Dish Reflector with
Mounting Bracket
Antenna
Feed
Rear
Housing
Support
Arm
Upper Pole
Bracket Assembly
Lower Pole
Bracket
Brace Screws
(M6, Qty. 4)
Hex Head Bolts
(M8, Qty. 5)
Lock Washers
(M8, Qty. 5)
Flat Washers
(M8, Qty. 5)
Stabilizer Brackets
(Qty. 2)
M10x100 Bolts
(Qty. 2)
M8x150 Carriage Bolts
(Qty. 4)
High-Performance
Integrated InnerFeed
airMAX
®
ac Bridge
Model: PBE-5AC-620
Pole Clamps
(Qty. 2)
Gigabit PoE Adapter with
Wall-Mount Bracket
Power
Cord
Quick Start
Guide
TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet
cable and earth grounding must be used as conditions of product warranty. TOUGHCable
is designed for outdoor installations. It is the customer’s responsibility to follow local country
regulations, including operation within legal frequency channels, output power, and Dynamic
Frequency Selection (DFS) requirements.
Hardware Overview
Bottom View
Cable Door
Rear Housing
Technology
Ethernet Port
Release
Button Slot
Release Button
Dish
Reflector
Alignment Pins
Reset Button
Antenna Feed
Mounting Bracket
Reset Button To reset to factory defaults, press and hold the
Reset button for more than 10 seconds while the PowerBeam
is already poweredon. Alternatively, the PowerBeam may be
reset remotely via a Reset button located on the bottom of the
Gigabit PoE Adapter.
Release Button After you assemble the PowerBeam, check
the button; it should be fully engaged in the Release Release
Button Slot Rear Housing Antenna of the . This ensures that the
Feed is locked into place. If you need to remove the Antenna
Feed, you must depress the button first.Release

Especificaciones del producto

Marca: Ubiquiti Networks
Categoría: repetidor wifi
Modelo: PBE-5AC-620

¿Necesitas ayuda?

Si necesitas ayuda con Ubiquiti Networks PBE-5AC-620 haz una pregunta a continuación y otros usuarios te responderán




repetidor wifi Ubiquiti Networks Manuales

repetidor wifi Manuales

Últimos repetidor wifi Manuales