Yamaha NS-2HX Manual de Usario

Yamaha Sistema de altavoces NS-2HX

Lee a continuación 📖 el manual en español para Yamaha NS-2HX (4 páginas) en la categoría Sistema de altavoces. Esta guía fue útil para 14 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/4

English

E-1

Read this before using the speakers.

●

To assure the finest performance, please read this manual

carefully. Keep it in a safe place for future reference.

●

Install the speakers in a cool, dry, clean place – away from

windows, heat sources, sources of excessive vibration,

dust, moisture and cold. Avoid sources of humming

(transformers, motors). To prevent fire or electrical shock,

do not expose the speakers to rain or water.

●To prevent the enclosure from warping or discoloring, do

not place the speakers where they will be exposed to

direct sunlight or excessive humidity.

●Do not place the following objects on the speakers:

Glass, china, etc.

If glass etc. falls by vibrations and breaks, it may cause

personal injury.

A burning candle etc.

If the candle falls by vibrations, it may cause fire and

personal injury.

A vessel with water in it

If the vessel falls by vibrations and water spills, it may

cause damage to the speakers, and/or you may get an

electric shock.

●Do not place the speakers where foreign objects such as

water drips might fall. It might cause a fire, damage to

the speakers, and/or personal injury.

●Do not place the speakers where they are liable to be

knocked over or struck by falling objects. Stable

placement will also ensure better sound performance.

●Placing the speakers on the same shelf or rack as the

turntable can result in feedback.

●Never put a hand or a foreign object into the port located

on the front of the speaker as this might cause personal

injury and/or damage to the speaker.

●When moving the speaker, do not hold the port as it

might cause personal injury and/or damage to the

speaker.

●Any time you note distortion, reduce the volume control

on your amplifier to a lower setting. Never allow your

amplifier to be driven into “clipping”. Otherwise the

speakers may be damaged.

●

When using an amplifier with a rated output power higher

than the nominal input power of the speakers, care should

be taken never to exceed the speakers’ maximum input.

●

Do not attempt to clean the speakers with chemical solvents

as this might damage the finish. Use a clean, dry cloth.

●Do not attempt to modify or fix the speakers. Contact

qualified YAMAHA service personnel when any service

is needed. The cabinet should never be opened for any

reasons.

●Secure placement or installation is the owner’s

responsibility.

YAMAHA shall not be liable for any accident caused

by improper placement or installation of speakers.

PRECAUTIONS

Place the speakers on a sturdy, vibration-free surface, on a

well-built stand.

■ Using as 2ch stereo speakers

Better stereo images will be obtained when the speakers

are slightly angled in towards the listeners.

■ Using as main speakers in a multi channel

system

Position the speakers on both sides of the TV. The

positioning of speakers is important, because it controls the

whole sound quality of a multi channel system. Set up the

speakers on the basis of your listening position by following

the owner’s manual supplied with your amplifier.

■ Using as front effect or effect speakers

Mount the speakers on a wall or place the speakers on a

shelf. Determine the best position by following the owner’s

manual supplied with your amplifier.

The screw holes on the rear of the speakers can be used

when mounting the speakers using a commercially available

speaker bracket.

Note

These speakers feature a magnetically shielded design,

but there is still a chance that placing them too close to

a TV set might impair picture color. Should this happen,

move the speakers away from the TV set.

PLACING THE SPEAKERS

NS-2HX Speaker System

OWNER’S MANUAL

G R

Thank you for selecting this YAMAHA NS-2HX speaker system.

Subwoofer

CenterNS-2HX

(Main L)

NS-2HX

(Main R)

NS-2HX

(Front

effect R)

NS-2HX

(Front

effect L)

NS-2HX

(Effect R)

NS-2HX

(Effect L)

Screw holes

(diameter: 6 mm)

60 mm

E-2

SPEAKERS

+– –

–

CONNECTIONS TO YOUR AMPLIFIER

Amplifier or

Receiver

Tighten

NS-2HX (L)

This speaker system is capable of standard connections and bi-wired connections. Before making

connections, make sure that the amplifier is switched off.

■CONNECTIONS

• Connect the screw-type input terminals at the rear of the

speakers to the speaker output terminals of the amplifier

(or receiver) with the speaker cable.

• Connect the (+) terminals on the amplifier (or receiver)

and the speakers using one side of the cable. Connect

the (–) terminals on both components using the other

side of the cable.

• Connect one speaker to the left (marked L) terminals of

your amplifier, and another speaker to the right (marked

R) terminals, making sure not to reverse the polarity

(+, –). If one speaker is connected with reversed polarity,

the sound will be unnatural and lack bass.

How to connect:

1Loosen the knob.

2Insert the bare wire. [Remove the insulation coating at

the extremity of each speaker cable by twisting the

coating off.]

3Tighten the knob and secure the cable.

Test the firmness of the connection by pulling lightly on

the cable at the terminal.

Note

Do not let the bare speaker wires touch each other as

this could damage the speaker or the amplifier, or both

of them.

Loosen

< >Standard connections

Short bar

Leave the short

bars in place

when

connecting.

NS-2HX (R)

Speakers output

terminals of the

amplifier (or

receiver)

English

E-3

+– –

SPEAKERS

++ – –

–

When using a banana plug

< >General model only

1Remove the cover by pulling it toward you.

2Tighten the terminal knob.

3Simply insert the banana plug into the terminal.

Bi-Wired Connections

This speaker system is capable of bi-wired connections. To

connect the speaker to the output terminals of the amplifier

(or receiver), two pairs of cables for each of woofer and

tweeter are used instead of standard connections. This type

of connection decreases the modulation distortion caused

by electric resistance of the cables and driving current of

the speakers. Consequently, purer sound quality can be

expected.

To utilize bi-wired connections, remove the short bars from

the terminals first, and then connect the woofer and tweeter

to the amplifier separately using two pairs of cables.

< >Bi-wired connections

Remove the short

bars before

connecting.

Amplifier or

Receiver

Woofer

terminals

Tweeter

terminals

Banana plug

Amplifier or

Receiver

NS-2HX (L)NS-2HX (R) NS-2HX (L)NS-2HX (R)

Both SPEAKERS A and B

should be selected.

Especificaciones del producto

Marca:	Yamaha
Categoría:	Sistema de altavoces
Modelo:	NS-2HX
Tipo de operación:	Draaiknop
Color del producto:	Zwart
Peso.:	1400 g
Tipo de enchufe:	Type F (CEE 7/4)
Longitud del cable:	0.8 m
Peso del embalaje:	1700 g
Ancho del embalaje:	360 mm
Empaquetadura en profundidad:	105 mm
Altura del embalaje:	330 mm
Material de la carcasa:	Kunststof
Fácil de limpiar:	Ja
Activos:	1200 W
Almacenamiento de cable:	Ja
País de origen:	China
Luz indicadora:	Ja
Termostato ajustable:	Ja
Pies antideslizantes:	Ja
Cantidad por paquete:	1 stuk(s)
Recubrimiento antiadherente:	Ja
Indicador de temperatura lista:	Ja
Altura del paquete principal (exterior):	380 mm
Ancho del embalaje principal (exterior):	345 mm
Peso bruto del embalaje principal (exterior):	11500 g
Longitud del paquete principal (exterior):	645 mm
Cantidad por caja principal (exterior):	6 stuk(s)
voltaje-de-entrada-de-CA:	220 - 240 V
Frecuencia-de-entrada-de-CA:	50 / 60 Hz
Número GTIN (EAN/UPC) (exterior) embalaje principal:	8712836963238
Productos por contenedor intermodal (40 pies - High Cube):	4158 stuk(s)
Productos por contenedor intermodal (20 pies):	1656 stuk(s)
Productos por contenedor intermodal (40 pies):	3498 stuk(s)
Número de crepes:	1 crêpe(s)
Crepediametro:	30 cm
Número de espátulas incluidas:	1
Incluye espátula:	Ja
Material de la espátula:	Hout
T-stock:	Ja
Material de la varilla en T:	Hout