Axton ATB20A Manual de Usario

Axton Altavoz de subgraves ATB20A

Lee a continuación 📖 el manual en español para Axton ATB20A (12 páginas) en la categoría Altavoz de subgraves. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF
Página 1/12
INSTALLATION & OPERATION MANUAL
EINBAU & BEDIENUNGSANLEITUNG
8"/ 20 CM ACTIVE SUBWOOFER
ATB20A
– 2 –
Dear Customer
Thank you and congratulations on your purchase of the AXTON ATB20A. This active
subwoofer system exclusively uses very high quality parts and components. As with all
high-quality car audio components, professional installation is highly recommended.
If you plan on installing this active subwoofer by yourself, please read the following
installation guide carefully, before you attempt the installation. You should retain this manual,
the packaging and the purchasing receipt for future reference. For any further additional
information about mounting, connecting or adjusting this subwoofer system, please contact
your AXTON dealer.
UNPACKING THE SYSTEM
Carefully remove all parts from the giftbox and check whether they are in good undamaged
condition, and match with the set contents listed below:
ATB20A active subwoofer
Connector
Owner‘s manual
Please contact your authorized AXTON dealer, if the content of this set is incomplete,
or parts of it show signs of transport damage.
SPECIFICATIONS
8" / 20 cm active subwoofer
8" passive membrane for deep bass
Frequency response: 45 – 150 Hz
100 W rms x 1 @ 4 ohms (< 1.0 % THD / 14.4V)
9DULDEOH ¿OWHU ±  ORZSDVV  +]  G%RFW
Bass-Boost: 0 dB - 12 dB
RCA, adjustable input sensitivity: 150 mV – 5 V
High-Level, adjustable input sensitivity: 1.0 V – 16 V
Signal to noise ratio: > 90 dB
Dimensions W x H x D: 315 x 275 x 330 mm
Net Weight: 7.9 kg
– 4 –
SAFETY INSTRUCTIONS
1. This unit is designed to be used in a vehicle with a 12V battery and negative ground.
2. Before any wiring, always remove the negative terminal of the battery to prevent short-
circuiting. This is also the last lead to be (re-)connected.
3. Do not disassemble or alter the unit in any way, because that will void your warranty. Do
not attempt to repair or to service the unit yourself, but contact an authorized AXTON
dealer instead.
4. Use only original accessories which are designed and manufactured for the unit,
otherwise you will risk damage. Install the unit according to the mounting manual and
use only the supplied mounting accessories. The forces of acceleration for accidents are
sometimes huge. Heavy objects may pose a risk for the driver and the passengers of the
car, during an accident.
5. Protect the unit from water and other liquids, which can enter the casing. A short circuit
or even fire could be the result.
6. Before you replace a defective fuse, try to find the cause for the short circuit. Please
pay attention to the cables of the power supply! If the short circuit doesn‘t result from a
failure of the power supply or wiring, you can replace the defective fuse with a new one
of identical value. If the short-circuit still exists, please contact an authorized AXTON
dealer.
7. Be careful not to drain the car battery while using the unit when the car engine is turned
off. Because the unit uses a considerable amount of energy and the battery will be
charged only while the engine is running, it might happen that the battery will discharge
to a point where it‘s not longer possible to start the engine.
8. If your car is parked in direct sunlight and there is a considerable rise in temperature
inside the car, allow the unit to cool off before operation.
9. The amplifier module employs a protection circuit to protect the transistors and the
woofer if the amplifier malfunctions. The amplifier’s protection circuitry will shut-off the
amplifier in case of short-circuit, overload or DC offset at the speaker outputs or in case
of overheat. In case the cause for protection shut-off has been eliminated, the amplifier
will operate normally again (green LED ON/ Red LED OFF). Otherwise the amplifier will
continue to remain in protection mode.
10. Do not use the unit with a weak or old battery as its optimum performance depends on
a normal battery supply voltage.
11. Please pay attention to the music playback volume inside your vehicle, because you are
obliged to notice exterior sounds like a police siren or you might face penalties in case
of an accident or even loose your insurance cover.
12. Do not operate the unit in no other way than described in this manual. Failure to follow
the instructions within this manual will void your warranty.

Especificaciones del producto

Marca: Axton
Categoría: Altavoz de subgraves
Modelo: ATB20A

¿Necesitas ayuda?

Si necesitas ayuda con Axton ATB20A haz una pregunta a continuación y otros usuarios te responderán


Altavoz de subgraves Axton Manuales

Axton

Axton ATB220 Manual de Usario

19 Septiembre 2024
Axton

Axton ATB20A Manual de Usario

9 Septiembre 2024
Axton

Axton ATB216 Manual de Usario

31 Agosto 2024
Axton

Axton ATW20 Manual de Usario

29 Agosto 2024

Altavoz de subgraves Manuales

Últimos Altavoz de subgraves Manuales

Canton

Canton SUB 8.2 Manual de Usario

27 Octubre 2024
Deaf Bonce

Deaf Bonce Machete MFX30D2 Manual de Usario

26 Octubre 2024
Phoenix Gold

Phoenix Gold ZP12D4 Manual de Usario

21 Octubre 2024
Phoenix Gold

Phoenix Gold ZP12D2 Manual de Usario

21 Octubre 2024
Phoenix Gold

Phoenix Gold Z12AB Manual de Usario

21 Octubre 2024
Phoenix Gold

Phoenix Gold Z10AB Manual de Usario

21 Octubre 2024
Phoenix Gold

Phoenix Gold ZB8P Manual de Usario

21 Octubre 2024
Bowers And Wilkins

Bowers And Wilkins CT 8SW Manual de Usario

20 Octubre 2024
Pioneer

Pioneer TS-W257D2 Manual de Usario

17 Octubre 2024
Vonyx

Vonyx SWP15 Manual de Usario

17 Octubre 2024