Electronics International CA-1 Manual de Usario

Electronics International Equipo de medición CA-1

Lee a continuación 📖 el manual en español para Electronics International CA-1 (22 páginas) en la categoría Equipo de medición. Esta guía fue útil para 4 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/22

0906941

Single and Multi-Channel

EGT, CHT, Carb Temp and OAT Instruments

Operating and Installation Instructions

OII 0906941 9/6/94

Electronics International Inc. ®

63296 Powell Butte Hwy  Bend, OR 97701  (541) 318-6060  Buy-EI.com

(This manual covers 25 instruments and remote switches)

(Supersedes OI 070781, II 070781, OI 040831 and II 070781-1)

(FAA Approved)

S/N:_____________________

You must read this manual before installing or operating the instrument. This

manual contains warranty and other information that may affect your decision

to install this product and/or the safety of your aircraft.

Important Installation Information

0720921

1. Leave slack in the cable to allow

for engine movement and vibration.

All steps must be read before installing a probe.

2. Do Not Overtighten.

Over time, tight wire

wraps will cause the wire

to break.

Hose Clamp.

4. The tab inside the male connector must be centered (not

bent up or down) to mate properly. Check each connector

before installation. Two drops of oil on the connector will

protect it from corrosion for many years.

5. If you remove a connector, double over the wire

before installing it into a new connector. Each connec-

tor must be double crimped very tightly.

Male Conn.

6. If connectors have been disconnected several times the female connector may become

loose. If this happens use a pair of needle nose pliers to retighten the female recep-

tacle then mate the connectors.

S.S. Washer.

3. Both clip rings must be on

the inside of the hose clamp.

The rubber band is used to hold

the washer on during shipping.

Important Notice

***** MUST READ *****

If you think it is not important to read this manual, you're wrong! This manual

contains important installation information that may affect the safety of your air-

craft, delay your installation or affect the operation of your instrument. You Must

read this manual prior to installing your instrument. Any deviation from these

installation instructions is the sole responsibility of the installer/pilot and may

render the STC invalid.

Read the Warranty / Agreement. There is information in the Warranty / Agreement that may alter

your decision to install this product. If you do not accept the terms of the Warranty / Agreement, do not

install this product. This product may be returned for a refund. Contact Electronics International inc. for

details.

Check that the instrument make and model marked on the side of the instrument and on the invoice are

correct before starting the installation.

It is possible for any instrument to fail thereby displaying inaccurate high, low or jumpy readings.

Therefore, you must be able to recognize an instrument failure and you must be proficient in operating your

aircraft safely in spite of an instrument failure. If you do not have this knowledge, contact the FAA or a

local flight instructor for training.

The pilot must understand the operation of this product before flying the aircraft. Do not allow anyone

to operate the aircraft that does not know the operation of this product. Keep the Operating Manual in the

aircraft at all times.

Especificaciones del producto

Marca:	Electronics International
Categoría:	Equipo de medición
Modelo:	CA-1
Color del producto:	Grijs
Peso.:	790 g
Ancho:	171.5 mm
Profundidad:	241 mm
Altura:	44.5 mm
Indicadores LED:	Ja
Actual:	0.325 A
Tecnología de conectividad:	Bedraad
Número de puertos Ethernet LAN (RJ-45):	1
Certificación:	FCC
Interfaz:	Ethernet
Estándar de red:	IEEE 802.3af
Tipo de comida:	24 VDC
Interno:	Nee
Protocolos de red compatibles:	DHCP, IGMP v3, UDP, TCP, HTTP, Telnet, FTP
Fuente de alimentación a través de USB:	Nee
Interfaz de host:	RJ-45
Velocidad máxima de transferencia de datos:	100 Mbit/s
Conexión(es):	8 x RJ-11
Listo para la red:	Ja
LED de enlace/actuación:	Ja
Temperatura de funcionamiento (TT):	0 - 40 °C
Humedad relativa de funcionamiento (VV):	0 - 85 procent
Número de puertos:	4