Generac G0063341 Manual de Usario
Generac
cámara réflex
G0063341
Lee a continuación 📖 el manual en español para Generac G0063341 (36 páginas) en la categoría cámara réflex. Esta guía fue útil para 8 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/36
Installation Guidelines
For
SE-Rated Single Load Manual
Transfer Switches 6333 / 6334
This manual should remain with the unit.
This manual must be used in conjunction
with the appropriate owner’s manual.
*NOT INTENDED FOR USE IN CRITICAL
LIFE SUPPORT APPLICATIONS.
*ONLY QUALIFIED ELECTRICIANS OR
CONTRACTORS SHOULD ATTEMPT
INSTALLATION!
ii Transfer Switch Installation Guidelines
Forward
Thank you for purchasing a Generac Single Load Manual Transfer Switch to safely connect a portable generator to your
home or business (single phase only), recommended to be used as the disconnect panel for a single 120/240VAC load or to
feed a subpanel for multiple loads, see Installation Diagrams for typical installations. Use where the main electrical panel is
located indoors. This product is suitable for service entrance equipment.
READ THIS MANUAL THOROUGHLY. This manual has been prepared to familiarize personnel involved with the
installation of transfer switches with the manufacturer’s installation requirements. Information and instructions con-
tained herein are not intended to replace or supersede, local, state, or national safety, electrical, and building codes
pertaining to such installations. Applicable laws, codes, and standards must always take precedence over the recom-
mendations contained herein. Always check with the local Authority Having Jurisdiction (AHJ) for the codes or stan-
dards that apply.
Only authorized dealers or qualified, competent installation contractors or electricians thoroughly familiar with applica-
ble codes, standards, and regulations should install this standby electric power system. The installation must be in strict
compliance with all codes, standards, and regulations.
It is not intended that this manual be a transfer switch. used by any unqualified person for the purpose of installing
Installation, inspection, and testing of the system must be attempted only by competent, qualified electricians or instal-
lation contractors who are familiar with the equipment and with all installation codes and requirements.
It would be impossible to provide details for every installation configuration. For this reason, much of the information in
this manual is general in nature. Illustrations of typical installations are not intended to serve as specific installation
plans, but may be used in the planning and design process when considering the selection and purchase of a genera-
tor set for standby power applications. Always have the unit specific drawings and manuals on hand before beginning
any installation.
If a portable generator is used to power electrical load circuits normally powered by a utility
power source, it is required by code to install a transfer switch. The transfer switch must
effectively isolate the electrical system from the utility distribution system when the generator
is operating. Failure to isolate an electrical system by such means may result in damage to the
generator and may also result in injury or even death to utility power workers due to backfeed
of electrical energy.
After the transfer switch has been installed, do nothing that might render the installation in non-
compliance with such codes, standards, and regulations. Every effort was made to ensure that
the information in this manual was both accurate and complete at the time it was released.
However, the manufacturer reserves the right to change, alter, or otherwise improve this product
at any time without notice.
WARNING!
California Proposition 65
Engine exhaust and some of its constituents are known to the state of California to cause cancer,
birth defects, and other reproductive harm.
WARNING!
California Proposition 65
This product contains or emits chemicals known to the state of California to cause cancer,
birth defects, and other reproductive harm.
Transfer Switch Installation Guidelines iii
Section 1 Safety
1.1 Introduction .......................................................................................................................... 1
1.2 Safety Rules .......................................................................................................................... 1
1.3 General Hazards ................................................................................................................... 2
1.4 Electrical Hazards ......................................................................................... ........ 2...............
1.5 Fire Hazards .......................................................................................................................... 3
1.6 Explosion Hazards ............................................................................................................... 3
1.7 Standards Index ................................................................................................................... 3
Section 2 Installation
2.1 Contents................................................................................................................................. 5
2.2 Required Tools ...................................................................................................................... 5
2.2.1 Tools and Items Needed for Installation......................................................................5
2.2.2 Optional Items for Installation
2.3 Specifications ........................................................................................................................ 5
2.4 Transfer Switch Installation ................................................................................................6
2.5 Wiring Diagram ..................................................................................................................... 6
Section 3 Operation
3.1 Transferring from Utility Power to Generator Power ........................................................7
3.2 Transferring from Generator Power to Utility Power .........................................................7
Table of Contents
Forward ....................................................................................................................ii
Especificaciones del producto
| Marca: | Generac |
| Categoría: | cámara réflex |
| Modelo: | G0063341 |
¿Necesitas ayuda?
Si necesitas ayuda con Generac G0063341 haz una pregunta a continuación y otros usuarios te responderán
cámara réflex Generac Manuales
18 Septiembre 2024
18 Septiembre 2024
18 Septiembre 2024
18 Septiembre 2024
18 Septiembre 2024
cámara réflex Manuales
- cámara réflex Samsung
- cámara réflex Gram
- cámara réflex Sym
- cámara réflex Chauvet
- cámara réflex Interstuhl
- cámara réflex Roccat
- cámara réflex AdHoc
- cámara réflex Toro
- cámara réflex Buzz Rack
- cámara réflex Kern
- cámara réflex Tamron
- cámara réflex Uni-T
- cámara réflex Chauvin Arnoux
- cámara réflex Gossen Metrawatt
- cámara réflex Rigol
- cámara réflex Wiha
- cámara réflex BOB Gear
- cámara réflex Esab
- cámara réflex Arthur Berndt
- cámara réflex Sky Rider
Últimos cámara réflex Manuales
25 Octubre 2024
1 Octubre 2024
1 Octubre 2024
Tamron SP AF70-200mm F/2.8 Di LD [IF] MACRO Manual de Usario
1 Octubre 2024
1 Octubre 2024
1 Octubre 2024
1 Octubre 2024
1 Octubre 2024