Projecta BLT200 Manual de Usario

Projecta cargador de bateria BLT200

Lee a continuación 📖 el manual en español para Projecta BLT200 (4 páginas) en la categoría cargador de bateria. Esta guía fue útil para 8 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF
Página 1/4
CAUTION- BATTERIES PRODUCE EXPLOSIVE GASES,
TO REDUCE THE RISK OF EXPLOSION OR INJURY
ALWAYS ENSURE:
• No sparks or ames are present
• Eye protection is worn
• All vehicle or battery manufacturer’s instructions are followed
• The load is ‘OFF’ before connection or disconnection
• Correct Polarity, do not reverse connect
• Beware of moving engine parts
NOTE
Carbon pile load testers produce a great amount of heat while the load is ‘ON’,
do not apply the load for more than 20 seconds at a time and allow time to cool
between tests.
When operating the unit for the rst time it is normal for a small amount
of smoke to develop as the lubricants used in the manufacturing process burn off.
SPECIFICATIONS
Tests: Volts (0-16VDC)
12V Lead Acid Batteries
12V Charging systems
(Alternators & Regulators)
Battery Range: Up to 1000CCA (160Ah)
Test Load: Adjustable Carbon Pile
0 - 500 AMPS
Maximum Load ‘ON’ Time: 20 Seconds
Recommended Cool
Down Time: 2 Minutes
Test time alert: Buzzer sounds after 15 seconds
Cable length: 1000mm
Size: 267mm x 230mm x 92mm
Weight: 3.5kg
Operating Instructions
Battery Load Test
1. Connect the RED clamp to the Positive (+) battery terminal or post.
2. Connect the BLACK clamp to the Negative (-) battery terminal or post.
Note: If testing a battery in the vehicle, ensure the engine and all loads are ’OFF’.
3. Check the battery’s open circuit voltage (OCV) on the DC Volt meter.
- If the needle is in the green section of the ‘State of Charge’ scale (above 12.5V)
the battery has sufcient charge to test.
- If the needle is in the red section (below 12.5V) the battery needs to be fully
charged before testing.
4. Determine the battery’s rated capacity in Cold Cranking Amps (CCA) or
Amp Hours (Ah) and calculate the correct load current:
Cranking Batteries: Load current = 1/2 the CCA rating
Deep Cycle Batteries: Load current = 3 x Ah rating
5. Turn the ‘Load Control Knob’ clockwise until the correct load current is reached
on the DC Amps meter.
6. After 15 seconds the buzzer will sound to indicate the correct test time,
immediately read the DC Volt meter.
- If the needle is in the Green area of the ‘Battery Test’ scale the battery has
passed the test.
- If the needle is in the red area the battery has failed the test, quickly reduce
the load current until the needle moves back into the green area, and then read
the approximate battery capacity in Ah or CCA from the DC Amps meter.
ONCE THE METER HAS BEEN READ THE LOAD MUST BE TURNED OFF
IMMEDIATELY TO PREVENT OVERHEATING - TURN THE LOAD CONTROL
KNOB FULLY ANTI-CLOCKWISE.
Note: Battery output varies due to temperature change, the ‘Battery Test’ scale has
4 temperature calibrations (21º, 10º, -1º & -18º Celcius) Use the closest scale to the
approximate ambient temperature.

Especificaciones del producto

Marca: Projecta
Categoría: cargador de bateria
Modelo: BLT200

¿Necesitas ayuda?

Si necesitas ayuda con Projecta BLT200 haz una pregunta a continuación y otros usuarios te responderán


cargador de bateria Projecta Manuales

Projecta

Projecta IC2500W Manual de Usario

16 Septiembre 2024
Projecta

Projecta BLT700 Manual de Usario

13 Septiembre 2024
Projecta

Projecta IDC45 Manual de Usario

7 Agosto 2024
Projecta

Projecta BLT200 Manual de Usario

7 Agosto 2024
Projecta

Projecta IC1000 Manual de Usario

30 Julio 2024
Projecta

Projecta PC800 Manual de Usario

27 Julio 2024

cargador de bateria Manuales

Últimos cargador de bateria Manuales

Nitecore

Nitecore UHX1 PRO Manual de Usario

27 Octubre 2024
Nitecore

Nitecore EMR05 TAC Manual de Usario

26 Octubre 2024
Bosch

Bosch GAA12V-21N Manual de Usario

24 Octubre 2024
Panasonic

Panasonic CF-VCB331 Manual de Usario

24 Octubre 2024
Ryobi

Ryobi One+ RC18627 Manual de Usario

21 Octubre 2024
Alecto

Alecto BL-179 Manual de Usario

19 Octubre 2024
Graupner

Graupner Ultramat 12 Manual de Usario

16 Octubre 2024
Graupner

Graupner ULTRA DUO PLUS 30 Manual de Usario

16 Octubre 2024
MSW

MSW S-CHARGER-20A.2 Manual de Usario

15 Octubre 2024
MSW

MSW S-CHARGER-10A.2 Manual de Usario

15 Octubre 2024