Satel AOCD-250 Manual de Usario

Lee a continuación 📖 el manual en español para Satel AOCD-250 (7 páginas) en la categoría detector de movimiento. Esta guía fue útil para 3 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/7
aocd-250_en 04/18
WIRELESS OUTDOOR
DUAL TECHNOLOGY CURTAIN DETECTOR
AOCD-250
Firmware version 1.00
SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gdańsk • POLAND
tel. +48 58 320 94 00
www.satel.eu
WARNING
The device should be installed by qualified personnel.
Read carefully this manual before proceeding to installation.
Changes, modifications or repairs not authorized by the manufacturer shall void your rights
under the warranty.
SATEL's goal is to continually upgrade the quality of its products, which may result in some
changes of their technical specifications and firmware. The current information on
the introduced modifications is available on our website.
Please visit us:
http://www.satel.eu
Hereby, SATEL sp. z o.o., declares that this detector is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU. The
declaration of conformity may be consulted at www.satel.eu/ce
The following symbols may be used in this manual:
- note;
- caution.
The AOCD-250 detector makes it possible to detect motion at the moment of crossing the
perimeter of protected area. It is designed for perimeter protection. The detector is designed
for use as part of the ABAX two-way wireless system. This manual applies to the detector
with firmware version 1.00, which is supported by:
ACU-120 / ACU-270 controller with firmware version 5.02 2016-04-01 (or newer),
ARU-100 repeater with firmware version 2.02 2015-06-01 (or newer),
INTEGRA 128-WRL control panel with firmware version 1.15 2016-03-09 (or newer) and
firmware version of processor used to operate ABAX system 3.05 (or newer).
1. Features
Passive infrared (PIR) sensor and microwave sensor.
Adjustable detection sensitivity of both sensors.
Remote configuration.
Digital motion detection algorithm.
Digital temperature compensation.
Tricolor LED indicator.
Supervision of detector signal path.
Battery status control.
Tamper protection against cover removal and tearing enclosure from the wall.
Weatherproof enclosure featuring a very high mechanical strength.
Angle-type mounting bracket included.
2. Description
Alarms
The detector reports alarm in the following cases:
both sensors have detected motion within a time interval of less than 5 seconds. This
alarm can only be reported in the active mode (see: „Operating modes”).
tamper switch has been opened (tamper alarm).
Operating modes
Switching between the operating modes is done remotely.
Active mode motion detection alarm or tamper alarm can be triggered. The microwave
sensor activates after motion is detected by the infrared sensor.
Passive mode tamper alarm only can be triggered. The microwave sensor is inactive.
During polling, the detector indicates whether motion has been detected by the infrared
sensor. The passive mode prolongs the battery life.
The alarm information is sent instantly.
Test mode
If you want to test the detector, you can remotely enter the test mode. When in the test mode,
the detector LED is working.

Especificaciones del producto

Marca: Satel
Categoría: detector de movimiento
Modelo: AOCD-250

¿Necesitas ayuda?

Si necesitas ayuda con Satel AOCD-250 haz una pregunta a continuación y otros usuarios te responderán




detector de movimiento Satel Manuales

detector de movimiento Manuales

Últimos detector de movimiento Manuales