Shadow SH-SB1 Manual de Usario

Shadow No categorizado SH-SB1

Lee a continuación 📖 el manual en español para Shadow SH-SB1 (1 páginas) en la categoría No categorizado. Esta guía fue útil para 7 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/1

Sensor

Copper foil

Fax: (561) 743 0460

eMail: jjmelch@shadow-pickups.com

Shadow Elektroakustik

Peter-Haendel Straße 2

91334 Hemhofen · Germany

Shadow Electronics of America Inc.

17791 Alexander Run

Jupiter, FL 33478 U.S.A.

Fax: +49 - 91 95 - 92 99 30

eMail: info@shadow-electronics.com

Installation Instruction for Shadow SH SB1

Slice Transducer for Upright Bass

Content:Content:

Note:

Piezo pickups and transducers have a very high output impedence. In order to get the optimum sound output we

recommend an amplier with low impedence.

Note:

Piezo pickups and transducers have a very high output impedence. In order to get the optimum sound output we

recommend an amplier with low impedence.

Fig. 1Fig. 1

Fig. 2Fig. 2

1 slice transducer (20 mm diameter) with 6,3mm

output socket and mounting adhesive

Copper foil tape

Cable holder

1 slice transducer (20 mm diameter) with 6,3mm

output socket and mounting adhesive

Copper foil tape

Cable holder

If pickup is too loose, shim with included shim material (see Fig. 2). if pickup is too high, file the bridge slot slightly.If pickup is too loose, shim with included shim material (see Fig. 2). if pickup is too high, file the bridge slot slightly.

1. Test fit sensors into the slot between the wing and foot. Pickup should fit tightly for best output (see Fig. 1).1. Test fit sensors into the slot between the wing and foot. Pickup should fit tightly for best output (see Fig. 1).

2. Install the sensors into the bridge slots.

3. Locate the output socket in a convenient location on the intrument and attach with applied double sided adhesive.

4. Connect to appropriate amplier with instrument cable.

2. Install the sensors into the bridge slots.

3. Locate the output socket in a convenient location on the intrument and attach with applied double sided adhesive.

4. Connect to appropriate amplier with instrument cable.