Gossen Metrawatt METRAHIT CAL Manual de Usario

Lee a continuación 📖 el manual en español para Gossen Metrawatt METRAHIT CAL (36 páginas) en la categoría Equipo de medición. Esta guía fue útil para 4 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/36
METRAHITCAL
Calibrator 3-349-442-03
13/1.19
Operating Instructions
2 GMC-I Messtechnik GmbH
Operating Overview – Connections, Keys, Rotary Switch, Symbols
1 Display (LCD) (see page 3 for significance of symbols
2HOLD / CONT Pause/resume ramp/interval
Increase parameter values
Mode menu:
Selection of individual menu entries against direction of flow
3
ON / OFF | LIGHT
, key for switching device and display illumination on and off
4 OUT | ENTER
OUT: Switch calibrator output on and off
Mode menu: Acknowledge entry (ENTER)
5 Move cursor to the right
SELECT RANGE operating mode: ramp function selection
6Rotary switch for calibration functions and complete shutdown
7 DAkkS calibration mark
8 Connector jacks for calibrator output
9HOLD / CONT Pause/resume ramp/interval
Reduce parameter values
Mode menu:
Selection of individual menu entries in direction of flow
10 MEAS/CAL | SETUP
Key for switching back and forth between calibration and menu function
11 ZERO/SEL | ESC
Mode menu: Exit current menu level and
return to a higher level,
exit parameters configuration
without saving data.
Pause ramp/interval.
12 Move cursor to the left,
SELECT RANGE operating mode: interval function selection
13 Power pack connector jack (accessory: NA X-TRA)
14 Infrared interface (accessory interface adapter:
USB X-TRA)
1
3
4
14
5
6
12
10
2
12
9
13
7
Not a measurement input!
Do not apply interference voltage,
except with current sink.
!
8
GMC-I Messtechnik GmbH 3
Symbols used in the Digital Display 1 Battery level indicator
2 NUM: Numeric entry of the output signal
3 INT: Interval sequence active
4 RAMP: Ramp function active
5 SINK: Current sink is active
6 SOURCE: Current source is active
7 ON: The calibrator output is active
8 IR: Infrared interface display
9 Auxiliary display with decimal point and polarity display
10 Main display with decimal point and polarity display
11 Calibration unit of measure
12 : Simulator in continuous mode operation
13 Ni/Pt1000: Selected temperature sensor
14 Auxiliary display with decimal point and polarity display
1 2 8
9
10
12
12
14
654 7
15
3
Battery full
Battery OK
Battery weak
Battery (almost) dead, U < 1.8 V
Data transmission to / from calibrator is active
IR interface in standby mode
(ready to receive starting commands)
Battery Level Indicator
Interface Indicator (with selector switch setting OFF)

Especificaciones del producto

Marca: Gossen Metrawatt
Categoría: Equipo de medición
Modelo: METRAHIT CAL

¿Necesitas ayuda?

Si necesitas ayuda con Gossen Metrawatt METRAHIT CAL haz una pregunta a continuación y otros usuarios te responderán




Equipo de medición Gossen Metrawatt Manuales

Equipo de medición Manuales

Últimos Equipo de medición Manuales